通过交叉调试，完成了该嵌入式控制系统的整个软件和硬件的设计工作。
The design of hardware and software of whole embedded system have been made by cross-debug.
本论文包括硬件设计、驱动程序开发和组成CAN总线控制系统三部分。
The dissertation consists of hardware design, driver development, CAN bus control system composing.
给出了控制系统的硬件构成，软件设计思想和实际应用结果。
The hardware constitution, design thought of software and actual application results are given.
设计出剪板机plc控制系统，包括硬件电路和软件程序。
Designs the plate cutter PLC control system including hardware electric circuit and software procedure.
介绍了一种基于VB6.0的硫化控制系统原理、硬件和软件设计。
This paper presents the principle, hardware and software design of VB6.0-Based autocontrol system.
所设计的点焊智能恒流控制系统由硬件和软件两部分组成。
The constant current of intelligent control system is composed of hardware and software.
介绍了灰色预测控制系统软、硬件的设计；
Then, the design of hardware and software systems of GPC is introduced.
设计了基于ARM的机器人小车控制系统的硬件平台。
The hardware of the self-tracing robot car control system based on ARM was designed.
详细介绍了这个微机控制系统的硬件电路及软件设计。
The article has detailed the hardware and software design of this microcomputer control system.
在硬件电路的基础上，进行了控制系统的软件设计。
Paper designs software of control system basing on the hardware circuit.
给出了控制系统的硬件配置和软件设计方案。
Gives the control system hardware configuration and software design.
本文对该控制系统软硬件设计的主要内容进行了阐述。
This paper presents main part of hardware and software design of the controlling system.
文章介绍了一种城市路灯计算机集散控制系统的软硬件设计。
This paper introduces the design of software and hardware for streetlight computer monitoring system.
结合硬件，完成了控制系统软件设计。
Combine the hardware, has finished the software design of the control system.
本文的重点主要包括稳定平台伺服控制系统的硬件设计和软件设计。
The focus of this dissertation includes the Servo System hardware design and software design.
给出了PLC控制系统的硬件实现及软件设计。
The hardware realization and software design of whole control system are analyzed.
研究设计了控制系统的硬件及软件。
给出了单片机自动控制系统的硬件和软件设计图。
Design drawings for hardware and software of single chip computer automatic control system were given.
论文还详细阐述了家电温度控制系统的软硬件设计方案。
The paper expounds the hardware and software scheme of appliance temperature control system.
以及对该处理过程的控制方法，以及控制系统的硬件构成和程序设计。
Then the control scheme, hardware configuration of the system and the program design is presented.
文章的内容主要包括硬件设计部分和控制系统软件设计两大部分。
The main content of this article contains hardware design and control system design.
文章的内容主要包括硬件设计部分和控制系统软件设计两大部分。
The main content of this article contains hardware design and control system design.
应用推荐