最终的进胶位置根据模流分析。
分析表明滑模控制器保证了闭环系统的稳定性。
It is shown that the stability of the closed-loop system is guaranteed by analysis.
分析了冲裁凹模工作部分的结构形式。
The structure and composition of work area of matrix was analyzed.
采用模匹配技术对带通型频率选择表面进行分析，其中单元内的场用有限元法解出。
In this paper, band pass frequency selective surface was analyzed by mode matching technology.
本设计进行了一款开关座的注塑模设计，对零件结构进行了工艺分析。
This paper presents the design of a molding model of switch and its process analysis.
分析了不锈铜器皿拉伸模表面粘附机理。
The adhesive mechanism of a drawing die has been analysised.
本文分析并介绍了制动器底板精整模结构、模具的设计要点和其工作过程。
This paper analyzed and introduced the size die structure, die design points and working process.
最后，本文又对一种低折射率芯光子晶体光纤基模束缚损耗特性进行了分析。
Lastly, the fundamental mode loss of a special kind of depressed-index core PCF is analyzed.
特别分析了本征模式在空气段为截止模的情况。
The evanescant modes in air section are considered especially.
分析了含杂质晶格振动模频率相对于完整晶格振动模频率的变化。
The local mode frequency and the local vibration are also analyzed particularly.
分析了模的动作过程。
分析了模的动作过程。
应用推荐