An example of mold base assembly was studied to prove the method.
最后以模架的装配为例说明了实现这种方法的过程。
The mold cavity was obtained by splitting mold base in parting surface.
模具型腔可采用分型面分割模板的方法获取。
In this paper, a method of computer-aided-selection of mold base will be discussed.
本文将探讨通过计算机辅助选择模具模座的方法。
Mold base to be minimum hardness of165 BHN.
模座的最低硬度为165布氏硬度。
Mold base to be minimum hardness of 165 BHN.
模座的最低硬度为165布氏硬度。
Mold base to be minimum hardness of 165 BHN.
模座的最低硬度为165布氏硬度。
应用推荐