The mixing time prolonged by introducing a draft tube.
增加导流筒可以使液相混合时间延长。
The mixing time was decreased with the increase in gas...
混匀时间随气体流量的增大而减少。
The liquid mixing time is of importance for the agitation process.
液相混合时间是搅拌过程的重要内容。
The factors affecting the mixing time and segregating index were analyzed.
分析了影响混合时间和分隔指数的主要因素；
The relationship between mixing time and buoyant stirring energy density is also obtained.
并得到熔池混匀时间与浮力搅拌功率密度的关系。
If emulsifier is not used in cake production, the mixing time needed is about 20-25 minutes.
制造蛋糕时如未加乳化起泡剂，搅拌时间约需20 ~ 25分钟。
The observed parameters of the experiments are the mixing time and the remove ratio of the inclusion.
实验考察指标为混匀时间和夹杂物的去除率。
The result shows that the effect of top blowing oxygen jet on the mixing time and circulation flow r...
结果表明，顶吹氧射流对钢包混匀时间和循环流量的作用可以忽略。
The observed parameters of the experiments are the mixing time and the angle of gas-liquid phase region.
实验考察指标为混匀时间和气液两相区夹角。
The mixing chute may automatically turn to empty the material and mixing time also receives auto control.
混合槽可自动翻转倒料，混合时间也可自动控制。
In the double logarithm coordinate, the relation between the mixing time and the power consumption is linear.
转速升高，混合时间缩短，混合时间与功率消耗在双对数坐标系下呈线性关系。
Concrete mixing time should be in line with "concrete structural engineering and construction inspection norms".
混凝土搅拌的时间应符合《混凝土结构工程施工及验收规范》的规定。
The results show that bleeding quality and consolidation strength are a function of mixing time and rotational ratio.
结果表明水泥浆液的泛浆性能和结石体强度是搅拌时间和速率的函数。
It has been found, that the mixing time mainly depends upon the mechanic power brought into the bath by the blowing gas.
研究中发现，熔池混合均匀时间主要和随气体输入的机械功率有关。
The yellow index of blends at different mixing time and thermal aging time increased obviously than that of pure polymer.
在不同混炼时间及热老化时间下，共混物的黄度指数相对纯聚合物有明显提高。
The result shows that the effect of top blowing oxygen jet on the mixing time and circulation flow rate can be disregarded.
结果表明，顶吹氧射流对钢包混匀时间和循环流量的作用可以忽略。
This machine has many advantages, such as constant operation, low noise, high loading coefficient and short mixing time etc.
该机还具有运转平稳、噪音低、装载系数高、混合时间短等优点。
Properties and morphology of thermites mixed up by twin-screw and ball milling procedures are investigated with different mixing time.
采用双螺旋和球磨两种混料方式，研究不同混料时间对（铝）热剂性能及颗粒微现形态的影响。
The mixing time predicted by CFD for the single DT-6, CBY impeller and multiple CBY impellers was in good agreement with the experiment.
对于单层桨体系，不论是DT-6桨还是CBY桨，其混合时间的模拟值均与实验结果吻合良好；
It is pointed out that the ratio of macromixing time to total mixing time increases with the increase in power consumption by calculation.
计算表明，宏观混合时间与整个过程的混合时间的比例，随单位体积功耗的增大而增大。
The results showed that the range of the region of phase co-continuity PS/PA6 was 40/60-65/35 at experimental temperature, rotor speed or mixing time;
结果表明在一定螺杆转速、共混温度、共混时间范围内，PS/PA6共混物形成双连续相组分的比例范围为40/60—65/35；
This Mixer has the following distinguishing features. No blind Angle in the cylinders, no accumulation of materials. High speed, and short mixing mixing time.
本机具有筒体无死角，不积料，速度快，混合时间短的特点。
Increase of carrier addition will result in the decreased oxygen transfer efficiency, shortened recycle time, mixing time as well as the decrease of air content.
载体加入量增加，会导致氧传递性能下降，循环时间和混合时间缩短，气含率减小。
It is suitable for slurry concentration of 1-6% in the pulp side of the pool, with small, fast mixing time, stirring effect, and the advantages of easy maintenance.
它适用于浆料浓度在1- 6%的方浆池，具有体积小、混合时间快、搅拌效果好、便于维修等优点。
The experiment shows that fewer melting-back materials, higher temperature and more mixing time will decrease the mixture content, and heighten the intensity as well.
实验证明，含回炉料少、熔炼温度适当增高、加强搅拌，能减少其夹杂物含量，从而提高其强度。
The high viscous non-newtonian fluid can be continuously bleached through static mixer, the mixing time is short, the energy consumption is small and the result is ideal.
利用静态混合器可实现生物多糖与脱色剂的连续处理，混合时间短，能耗低、效果好。
Based on the research of aerated time, pore content, aerated structure, the influence of slurry temperature, mixing time and aluminum powder on paste expansion is analyzed.
通过对发气时间、气泡含量和气孔结构的研究，分析了料浆温度、搅拌时间和铝粉膏对料浆发气膨胀的影响。
The effects of mixing temperature, mixing time, crosslinking agent systems and high temperature repeated mixing on the mechanical properties of SBR/PE/PVC blends were studied.
介绍了开炼法制备SBR/PE/PVC多元共混体的共混温度、共混时间、交联体系及共混体高温返炼对材料力学性能的影响。
A better quenching effect is obtained when the temperature increases; and the quenching result is also influenced by the mixing time of fluorescence quenching agent and the pulp.
结果表明，浆料温度及荧光消除剂与浆料的混合作用时间对荧光消除效果有较大影响。
A better quenching effect is obtained when the temperature increases; and the quenching result is also influenced by the mixing time of fluorescence quenching agent and the pulp.
结果表明，浆料温度及荧光消除剂与浆料的混合作用时间对荧光消除效果有较大影响。
应用推荐