So, the research on microwave power amplifier technology is valuable.
因此,对微波功率放大器技术的研究具有重要意义。
A novel thin-film MEMS microwave power sensor is presented.
提出了一种新型的MEMS微波功率传感器。
Rectifying antenna(rectenna) can convert microwave power to DC power.
整流天线能把空间的微波能量转化为直流能量。
The dyeing conditions including microwave power and dyeing time were studied.
对微波染色工艺条件包括微波强度、染色时间进行了研究。
The problem of large zero drift always exists in microwave power meters with thermistor.
热敏电阻式微波功率计,一直存在零点漂移大的问题。
The results show that flow rate, microwave power and reaction temperature are key factors.
实验结果表明,气体流量、微波功率和反应温度对脱硫、脱氮率影响较大。
This paper mostly researches a pulse modulator which can be used in the microwave power module.
主要研究一种可用于微波功率模块的脉冲调制器。
Through repeated improvements, design of microwave power divider meet basic performance requirements.
通过反复改进,设计出的微波功率分配器基本符合性能指标要求。
So it has been paid more and more attention in the research and design of microwave power amplifier .
因而,对微波功率放大器的研究和设计也越来越受关注。
Base emitter metal self aligning, air bridge, and wafer thinning are used to improve microwave power performance.
在晶体管制作过程中采用了发射极-基极金属自对准、空气桥以及减薄等工艺改善其功率特性。
The effect of microwave power, time, moisture content on wheat germ lipase activity and storage capacity was studied.
研究了微波功率、处理时间、小麦胚原料水分对小麦胚的脂肪酶活力及其储藏稳定性的影响。
The temperature of heated tissues and the microwave power are recorded automatically in order to give Clinical references.
受照组织的温升和微波功率均自动记录以作临床数据。
Impedance, power and frequency are the three aspects of the core issues to resolve in the microwave power amplifier design process.
在微波功率放大器设计中所要解决的核心问题主要有以下三个方面:阻抗、功率和频率。
The influences of amount of catalysts, microwave power, microwave irradiation time and the mole ratio of alcohol to acid were studied.
考察了催化剂的用量、微波功率、微波辐射时间、醇酸比对酯产率的影响。
In the research of microwave technology, microwave power is an important parameter which tokens the characteristic of microwave signal.
在微波技术研究中,微波功率是表征微波信号特性的一个重要参数。
With this theory, we studied in detail the effect of an magnetic field and microwave power on the height of the microwave-induced step.
在此基础上,详细研究了外磁场和微波功率对微波感应台阶高度的影响。
The effects of catalyst dosage, microwave irradiation time and microwave power on degradation of reactive yellow wastewater were examined.
实验考察了催化剂用量、微波辐射时间、微波辐射功率对活性嫩黄废水的降解效果。
The relationships between regeneration efficiencies of activated carbon and those factors such as microwave power, microwave irradiation...
通过正交试验,探讨了活性炭再生率与微波功率、微波辐照时间、活性炭的吸附量等因素的关系。
The three-dimensional heat conduction equation for steady state operating conditions of bipolar microwave power transistors has been solved.
本文对双极性微波功率晶体管(以下简称微波功率晶体管)求解了稳态工作条件下的三维热传导方程。
The cavity pull effect, microwave power shift, light shift and temperature coefficient which mostly influence the performance of RAFS are studied.
研究了腔牵引效应、微波功率频移、光频移和缓冲气体温度系数对铷频标输出频率的影响。
The highest DRE of CF4 is up to 99%. The DRE is increased with the increase of microwave power, and is decreased with the increase of gas flow rate.
CF 4气体的最高分解率可达99%以上,分解率随微波功率的提高而增加,随气体流速的增加而减小。
The use of a background plasma in a dielectric Cherenkov maser can effectively increase the efficiency and the microwave power output of the device.
在介质切伦可夫脉塞中加入背景等离子体可有效地提高器件的效率和微波输出功率。
In this paper, design of intermatching network of Si microwave power transister is emphasized. The properties of power, bandwidth and power gain are analyzed.
着重论述了硅微波功率晶体管内匹配网络的设计方法,对内匹配网络的功率均分特性、带宽特性,增益性能做了分析研究。
The copper leaching resistance in the treated wood could be improved as the microwave power and treatment duration increased and also for the samples wrapped.
微波强度、后处理时间的增加和包膜处理是提高铜的抗流失性的有利因素。
In this system, the size of the filter is not limited by the space of installment and it is possible to heat of the filter by using more than one microwave power supply.
多模箱式再生系统中过滤体的尺寸可以不受安装空间的限制,并且可以采用多个微波源馈入功率以提高再生腔中的微波功率密度或改善加热均匀性。
The design of microwave power amplifier needs large-signal s parameters, but under most circumstances, the designer only has small-signal s parameters and the static I-V curve.
微波功率放大器设计需要大信号s参数,但大多数情况下,设计者只有小信号s参数和静态I - V曲线。
A novel structure has been designed and applied in metallization system of microwave power device, in which backflow effect is taken to increase the electromigration resistance.
在回流动力学理论和实验研究的基础上,将回流加固结构应用于实际微波功率器件。
In this paper this phenomenon is analyzed theoretically, and finally the best vacuum degree in correspondence with different microwave power is found out to avoid this phenomenon.
论文对气体击穿现象进行了理论分析,最终确定出与微波输出功率相对应的最佳工作真空度,避免气体击穿现象的发生。
The effects of radiation time, microwave power, volume of solvent for extraction and the volume of solvent for washing cake on extraction yield are discussed in orthogonal experiments.
考察了微波辐射时间、微波功率、溶剂用量、洗涤滤饼的溶剂量对提取率的影响。
The effects of radiation time, microwave power, volume of solvent for extraction and the volume of solvent for washing cake on extraction yield are discussed in orthogonal experiments.
考察了微波辐射时间、微波功率、溶剂用量、洗涤滤饼的溶剂量对提取率的影响。
应用推荐