The ellipse arc may depress the acceleration of supersonic flow in inlet area, decrease the strength of inlet shock wave.
椭圆形的前缘可减弱超音气流在前缘进口区的加速程度,降低进口弓形波的强度;
Causes of the stray current corrosion in inlet and outlet of the electrolytic bath were analyzed to put forward a solution.
分析了电解槽进出口系统各主要设备杂散电流产生原因,提出了针对性的解决方案。
In this paper, a FVM-TVD method for simulation of one-dimensional unsteady flow in inlet and exhaust manifold of ICE has been constructed.
介绍了进排气系统一维非定常流动的FVM-TVD法(总残差减少的有限体积法)。
The accuracy of the simulation model is verified by inlet duct steady flowing pressure tests on test benches, and then flow field distribution in inlet ducts is analyzed.
在用气道稳流试验台验证了仿真模型的准确性后,分析了进气道内部的流场分布。
The volumetric mass-transfer coefficient in packing increases with gas flow rate and rotating speed raises. Liquid flow rate and concentration of SO2 in inlet gas influences less on it.
转速和气体流量对旋转床填料层内的体积传质系数影响较大,流体流量和气相中二氧化硫浓度影响不大。
The result shows: the dimension disposal of the triangular groove used in inlet and outlet way should be unsymmetrical, and plate noises can be controlled well after using triangular groove.
结果表明:对吸、排油采用的三角槽结构尺寸布置应该是非对称形式的,并且采用了此三角槽结构后,配流噪声可以得到较好的控制。
The measurement of pressure was carried out by using semiconductor silicon piezometer. With the static pressure in inlet of pipeline and theoretic analysis we could get the total pressure of MPT.
压强的测量采用半导体硅压阻式压强传感器,通过测量MPT进气管路的静压,结合理论分析计算得到MPT谐振腔的总压。
Ulteriorly, considering the local head loss in inlet opening and pipes junction plays more important role in the calculative results of water hammer pressure calculation of the short pipeline system.
考虑进口及多管道连接处的局部水头损失对短管道系统水击压强的计算结果影响较大。
Ulteriorly, considering the local head loss in inlet opening and pipes junction plays more important role in the calculative results of water hammer pressure calculation of the short pipeline system.
考虑进口及多管道连接处的局部水头损失对短管道系统水击压强的计算结果影响较大。
应用推荐