Excessively high injection speed can cause high surface orientation and increase susceptibility to stress cracking.
过高的注塑速度会引起较高的表面方向性及增加应力破裂的敏感性。
During the process of water injection production, high injection pressure cut in mudstone should be prevented to reduce casing damage.
油田开采过程中，应防止高压注入水进入泥岩，以预防和减少由于泥岩进水发生蠕变导致套管损坏。
The injection units are equipped with hydraulic accumulators to reach the high injection speeds and acceleration rates required for thin-walled parts.
注塑单元配备液压储能器，可实现高速注塑和加速度，适合薄壁产品。
To ensure prolonged stable high production, it is necessary to use a high injection-production ratio so as to ensure that enough water is injected into the main pay…
在注水开发过程中，采用较高的注采比，保证主力油层注够水，选择油井合理流压和生产压差，对实现较长时期的高产稳产是十分重要的。
The larger viscoelasticity of polymer solution, the higher percolation resistance, and the greater of proportion of high injection pressure arising from elastic effect.
聚合物溶液的粘弹性越大，其在地层孔隙中的渗流阻力越大，弹性效应在增高注入压力中所占的份额也越大。
Due to high injection pressure of high concentration polymer solution, reducing injection pressure of high-concentration polymer solution with surfactant has been researched.
针对高浓度聚合物溶液注入压力高的实际情况，开展了表面活性剂降低高浓度聚合物注入压力的研究。
Double tunnel junctions have been used to investigate the properties of superconducting Pb films under quasiparticle injection. At high injection level an inhomogeneous gap state was observed.
用两个重叠的铅隧道结进行实验，当注入电流很大时在铅膜中观察到了非均匀能隙态，铅膜中出现非均匀态的功率阈值比铝膜大得多。
Double tunnel junctions have been used to investigate the properties of superconducting Pb films under quasiparticle injection. At high injection level an inhomogeneous gap state was observed.
用两个重叠的铅隧道结进行实验，当注入电流很大时在铅膜中观察到了非均匀能隙态，铅膜中出现非均匀态的功率阈值比铝膜大得多。
应用推荐