He added, at this speed, they will be generating more heat per cubic centimeter than a nuclear reactor.
他补充，在这种速度下，每立方厘米产生的热将超过核反应堆。
Important requirement of the reactor for Fischer Tropsch process is to remove the heat of the reaction.
反应堆的重要需求费托法是消除反应的热量。
Once the reactor has shut down, there remains "decay heat" from traces of other radioactive isotopes.
一旦反应堆关闭，它仍热存在有来自其他放射性同位素踪迹的衰变热。
Because of this, every nuclear reactor has ways of getting rid of the heat, and blocking those fast-moving radioactive particles.
因为这个，每一个核反应堆都有摆脱热量的方式并且阻塞那些快速移动的核微粒。
So the design differences are really driven by the mechanism of heat removal in the reactor and how that reactor is operated.
所以，设计的不同是由,除去反应堆热量的原理的不同决定的,还有反应堆运作的方式决定的。
Fourth generation reactors have better ways of dealing with "afterheat, " heat created by leftover radioactivity in a reactor, and could circumvent the problem completely.
第四代核反应堆采用更为先进的方法处理“残热”，且能彻底绕开此问题。 残热产生自反应堆中残余的放射能。
The control rods are also used to shut the reactor down from 100% power to about 7% power (residual or decay heat).
它也用来关闭反应器，可以从100%的动力降到7%动力（残留的延迟的热量造成）。
More heat means more steam and less water in the reactor vessel.
在反应炉内，更多的热量将会生成更多的蒸汽，并使水越变越少。
Steam generated by the heat of a cooling down reactor has enough force to run a turbine, which then runs a pump that provides coolant to the core.
由冷却的反应堆产生的蒸汽足够运行一台涡轮机，然后该涡轮机运行一台水泵为反应堆提供冷却剂。
This greatly increased the amount of water available to soak up the heat, and should have made sure that the reactor was fully covered by water and thus not hot enough to damage itself any further.
此举是增加水量来吸收热量，并要确保反应堆完全被水覆盖，这样高温就不会进一步损坏反应堆。
With the primary containment vessel of reactor 1 still too full of steam, the radical decision was made to flood it with sea water to absorb the heat.
由于一号反应堆中最重要的密闭容器中充满了蒸气，因此临时决定用海水对其进行冷却，以便吸掉过多的热量。
But even after shutdown, there is residual heat that needs to be drawn off by cooling water pumped through the reactor core, and that’s where the trouble came.
但是即便终止之后，依旧有余热存在，需要冷却水泵抽水注入反应堆芯将热量散去，这也是问题所在。
Because the reactor had been shut down a long time ago, the decay heat had decreased to a significantly lower level, so the pressure in the plant stabilized, and venting was no longer required.
因为反应器已经关闭了很长时间，残余热量下降到了一个显著的低水平，因此工厂内部的压力已经稳定，不再需要继续排气。
It operates similar to power station reactor, the heat generated by a nuclear reactor is used to raise steam to drive a turbine.
它的原理相当于电站核反应堆，由它所产生的热量将用来产生蒸汽以推动涡轮机。
She says the first improvements that will be made to the existing reactor will be to improve the insulation to help stop heat loss, a simple move that she expects to treble the current efficiency.
她表示，现有反应器第一个需要改进的地方是改善其绝缘性，以便阻止热能流失。她期待这一简单的改进能够使反应器的利用率翻两倍。
Unless you have a mechanism to remove that, the heat can build up and can eventually damage the radioactive fuel or the reactor.
除非你有途径将它移除，否则热量将积累并最终破坏放射性燃料或核反应堆。
The idea behind the reactor was to use the heat generated by fission to heat hydrogen, which would expand, generating the force to push the rocket.
这一试验的原理是运用核裂变产生的热量给氢气加温，导致其膨胀，并产生推动火箭的力量。
What if heat exchangers corrode letting sea water into the reactor?
如果热交换器腐蚀了导致海水进入反应堆怎么办？
A coolant, which may he liquid sodium, water or some other substances can carry away the heat produced in the reactor.
像液体钠、水或其他一些物质这样的冷却剂能吸走反应堆所产生的热。
The system is designed for transferring heat from the reactor core.
要设计成能传输出从反应堆堆芯产生的热量。
The initial phase of reactor cooldown is accomplished by transferring heat from the reactor coolant system to the steam and power conversion system through the steam generator.
停堆初期（第一阶段）的冷却过程：通过蒸汽发生器将反应堆冷却剂系统的能量传输给二次侧的蒸汽。
In the developing the oxidative dehydrogenation of butene process, it is found that the effect of heat feedback through reactor wall is different between laboratory and commercial scale reactors.
在丁烯氧化脱氢反应过程的开发放大中，发现实验室反应器和工业规模反应器通过反应器壁的热反馈存在不同的影响。
'Green' energy is cheap, cheap, cheap to produce. A nuclear reactor can produce hydrogen directly from water using byproduct heat while also generating electricity.
绿色能源生产成本很便宜。核反应堆发电的同时还可以用其副产品直接从水中制氢气。
Based on the meterial and heat balance calculation of single pipe reactor technology, some problems resulting in high ammonia consumption are exposed in the DAP plant.
对单管反应器工艺技术的装置系统进行物料平衡、热量平衡分析，从中发现装置存在的一些工艺问题，导致DAP产品的氨耗偏高。
Although only heat balance of plug flow reactor was discussed in this article, the method could be applied in other types of reactors.
作者论述谨以平推流反应器为代表，但其方法不失通用性，可望在反应器热量衡算中广泛应用。
At the same time , CEFR is the first pool-type LMFBR(Liquid Metal Fast Breeder Reactor)using dacay heat removel system to.
另外，CEFR又是世界上首次在堆内采用非能动手段来排出堆芯余热的池式快堆。
At the same time , CEFR is the first pool-type LMFBR(Liquid Metal Fast Breeder Reactor)using dacay heat removel system to.
另外，CEFR又是世界上首次在堆内采用非能动手段来排出堆芯余热的池式快堆。
应用推荐