Gas-liquid stirred tank have been widely used in industrial production.
气液搅拌槽在工业生产中应用十分广泛。
So that means that if I looked at the gas-liquid coexistence which is this line right here.
这意味着，如果我们，考虑气液共存曲线，就是右边这条曲线。
One-dimensional homogeneous model based on the gas-liquid two-phase flow theory was established.
基于气液两相流理论，建立了垂直上升管内液氮气液两相流动的一维均相流模型；
And I just looked at this, assuming it obeys Raoult's law What we looked at here was the gas-liquid coexistence.
看这里，假设Raoult定律成立，我们先考虑气液共存曲线。
Application of regular packing and new gas-liquid distributor in the modification of fertilizer plant is reviewed.
论述规整填料和新型气液分布器等塔内件在化肥厂技术改造中的应用。
And we found that the gas-liquid coexistence point, the vapor pressure of the water, was less than if it were pure.
我们发现在汽液共存点，糖水中水的蒸汽压，小于纯水的蒸汽压。
As opposed to gas-liquid systems, there is an interchange of gas between bubble and continuous phase in fluidized beds.
与气-液系统不同的是，在流化床中气泡和连续相之间有气体交换。
A method of using metal probe for measuring the void fraction at any point in gas-liquid two-phase flow on Sieve tray is described.
用金属探针法测量塔板上气液两相流中某些点的含气率。
Unlike in a pure liquid in which the pressure wave velocity is constant, the wave velocity in gas-liquid mixtures varies with pressure.
在混合物中压力波速不象在纯液体中波速那样是恒定的，汽液混合物中的波速随压力变化。
Aiming at the improvement on the structural of the ordinary centrifugal separator, a new centrifugal separator for gas-liquid separation was developed.
针对常规离心式分离器进行结构改进，开发出新型离心式气液分离器。
In comparison with other centrifugal gas-liquid separators, the resistance loss of the axial flow guide vane type gas-liquid cyclone separators was less.
轴流导叶式气液旋流分离器与其他离心式气液分离器比较，其特点是阻力损失小。
Vortex and Pulsed Reaction Equipment (VPRE) was presented. The flow pattern and characteristics for gas-liquid or gas-liquid-solid system in VPRE were analyzed.
设计了一种涡旋脉冲式反应装置，分析了气-液或气-液-固多相体系在涡旋脉冲式反应装置中的流动状态及特点。
A model of mass transfer coefficients in liquid phase near free gas-liquid interface is developed based on the energy spectrum functions of isotropic turbulence.
摘要在单涡模型的基础上，根据各向同性湍流的能谱函数，考虑不同尺度的旋涡对气液传质的影响，建立了气液自由界面传质系数模型。
The liquid in the pipeline under certain conditions and partially vaporizes into gas state, bubble, formation of gas-liquid two-phase flow which is the process of flash.
管道中的液体在一定的条件下，部分液体气化成气体状态，产生气泡，形成气液两相流这就是闪蒸过程。
In the compressor suction mouth increase a gas-liquid separator is the effective way to solve this problem, especially in the inverse heat cycle defrosting the heat pump units.
在压缩机吸气口增加气液分离器是解决这个问题的有效办法，尤其是在采用逆循环热气除霜的热泵机组中。
The model includes reaction rate equations, gas-liquid equilibrium and gas-liquid mass transfer equations, so that the simulation gives close results to the commercial practice.
数学模型中包括了反应动力学方程、气液平衡和气液传质方程，使模拟结果接近于工厂实践。
The influence of temperature, gas-liquid ratio, gas-liquid rate, residual oil saturation and permeability on steam foam sealing ability is studied on the basis of microscopic percolation study.
在蒸汽泡沫微观渗流研究的基础上，研究了温度、气液比、气液速率、残余油饱和度以及渗透率对蒸汽泡沫封堵能力的影响。
Water exists in three states: liquid, gas, and solid.
水以三种状态存在：液体、气体和固体。
We started with gas, no liquid.
我们从气态开始，没有液体。
Matter exists in three states: solid, liquid and gas.
物质以三种形态存在：固态、液态和气态。
Latent heat is absorbed or released whenever matter changes phase, as when matter changes from liquid to gas, for example, or from gas to liquid.
潜热在物质形态变化时被吸收或释放，例如当物质从液体变为气体或从气体变为液体时这一过程就会发生。
And the a gas liquid coexistent line.
这是气体——液体共存曲线。
Because this gas liquid coexistence line, this diagram, and this Clapeyron equation, is all done for a pure substance.
因为这个共存曲线，相图和克拉珀龙方程，都是对纯物质得到的。
Pipeline transportation refers to the transport business of delivering gas, liquid and solid materials through pipeline facilities.
管道运输，是指通过管道设施输送气体、液体、固体物资的运输业务。
There are three states of matter: gas, liquid and solid.
物质有三种状态：气体，液体与固体。
Containers, pipes and tanks which used to fill with flammable gas, liquid without cleaning and measuring, should not be welded and scalpeled.
盛装过可燃、易燃气体、液体的各种容器、管道、罐柜等，未经清洗和测爆，没有安全保障时，不准焊、割。
The volume is fixed by measuring a specific gas (liquid) of controlled temperature and pressure using a sample measurement tube.
通过使用样品测量管测量受控温度和压力的特定气体(液体)来固定体积。
Gas, liquid or electricity supply or production meters, including calibrating meters thereof.
生产或供应气体、液体及电力用的计量仪表，包括它们的校准仪表。
Gas, liquid or electricity supply or production meters, including calibrating meters thereof.
生产或供应气体、液体及电力用的计量仪表，包括它们的校准仪表。
应用推荐