• The influences of gap length, polar arc and thick of stator yoke on electromagnetic torque are discussed.

    探讨了电机的气隙长度,定子极弧角度、定子轭厚等结构参数对电机转矩特性的影响。

    youdao

  • The rational gap length reduced the volume of adhesive effectively and the highest reduction ratio was 60%.

    合理的间隙长度可以有效地减少胶粘剂的用量,减少率最大可达60%;

    youdao

  • Spark-gap length affects the energy of the spark, and the shape of the insulator affects the temperature of operation.

    火花间隙的长度影响火花的能量,而绝缘体的形状则影响工作温度。

    youdao

  • The analysis of this model shows that if the interelectrode gap length in the CCM elements decreases, the rate of the charge multiplication increases.

    通过对该模型的分析表明:ccm单元内电极间的间隙越小,电荷倍增率越大。

    youdao

  • The design blasting parameters, blasting net, delay time, defending measure selection and gap length determination in complicated environment are discussed.

    探讨在复杂环境条件下爆破参数、爆破网路、延时时间、安全防护措施的选择和爆破切口范围的确定。

    youdao

  • The stress transfer model of the sensor is analyzed and the relationship between the change of Fabry-Perot gap length and hydrogen concentration is constructed.

    分析了其应力的传递过程,建立了法布里-珀罗腔腔长变化与氢浓度关系的数学模型。

    youdao

  • Two kinds of the normal force of the linear servo motor are analyzed by using finite element analysis. The relations between thrust, normal force and air gap length are analyzed.

    采用有限元分析的方法对直线伺服电机的两种法向力进行分析,分析了推力、法向力与气隙长度的关系。

    youdao

  • To keep leakage flux to be constant, the relation is analyzed between the air gap length and the non-magnetic material thickness with the rare earth magnet thickness under the air gap length variety.

    在气隙长度发生变化时,为了保证漏磁大小不变,讨论了气隙与非导磁衬套厚度、磁钢厚度的关系。

    youdao

  • To keep leakage flux to be constant, the relation is analyzed between the air gap length and the non-magnetic material thickness with the rare earth magnet thickness under the air gap length variety.

    在气隙长度发生变化时,为了保证漏磁大小不变,讨论了气隙与非导磁衬套厚度、磁钢厚度的关系。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定