The FPGA-based implementation of data input module and data output module of VLBI standard interface is expatiated in this dissertation.
本文主要阐述基于FPGA实现VLBI标准接口数据输入模块和数据输出模块。
FPGA-based implementation of floating-point LMS algorithm is one of the key techniques in the engineering design of adaptive array antennas.
浮点LMS算法的FPGA实现是自适应天线阵工程设计中的关键技术。
This paper analyzes 2 critical problems in FPGA-based implementation of SOM neural network algorithm: parallelizability and finite word-length effect.
分析了SOM神经网络算法在FPGA实现过程中要考虑的2个主要问题：并行性和有限字长效应。
Therefore, this paper presents an FPGA-based implementation scheme of CAN bus controller, gives the structure diagram, and detailedly describes the internal modules.
因此本文提出一种基于FPGA的CAN总线控制器的实现方案，给出其结构框图，并对内部各模块进行较为详细的介绍。
A design scheme of high - performance data acquisition based on USB and FPGA and its hardware and software implementation are introduced.
提出了一种基于usb和FPGA的高性能数据采集设计方案并详细介绍了其软硬件实现方法。
An implementation scheme of IJF coding based on FPGA is proposed, which has the features of highly integration, flexible configuration, stable performance.
提出一种基于FPGA的IJF数字基带编码实现方案，具有高度集成、占用资源少、配置灵活、性能稳定的特点。
This paper introduces implementation of transmitting beams that rotates single beams based on FPGA.
文中介绍一种利用FPGA芯片来实现旋转单波束方式的发射波束。
This paper introduces the implementation of VGA controller based on FPGA, which is widely applied in industry.
利用可编程器件FPGA实现VGA彩色显示控制器在工业现场中有很多的应用。
Based on the analysis on algorithm for SSC sequence number identification, an FPGA implementation scheme using fast Hardarm transform are presented.
本文详细分析辅助同步码序号识别算法，在此基础上提出了一种基于快速哈达玛变换的FPGA实现方案。
Researching the implementation of signal detection based on FPGA and acquiring the parameter of IF signal, such as frequency, amplitude and phase.
研究信号检测算法的FPGA 实现，获取信号的频率，幅度，相位等参数。
This paper introduces the design and implementation of ventilator control system based on FPGA including principle and electric circuit.
本文详细介绍了基于FPGA的呼吸机控制系统的设计和实现，包括原理和电路结构图。
A general method of intelligent controller design and closed-loop test based on VHDL and FPGA implementation is proposed.
提出了一种基于VHDL描述、FPGA实现的智能控制器设计和闭环测试的一般性方法。
This paper introduces in detail the design and implementation of ventilator SPONT control chip based on FPGA, including principle and electric circuit.
本文详细介绍了基于F PGA的呼吸机SPONT 模式控制芯片的设计和实现，包括原理和电路结构图。
This paper deals with the design and implementation of Digital Up Conversion and Digital Down Conversion based on the field-programmable gate array (FPGA).
本文主要研究的是基于现场可编程逻辑阵列（FPGA）的数字上下变频技术的设计和实现。
A new hardware implementation of LDPC coding arithmetic in DVB-S2 system based on FPGA is introduced.
提出了一种基于FPGA的DVB -S2系统中ldpc编码算法的硬件实现技术。
For the miniaturization of satellite electronic system, the paper introduces design and implementation of satellite telemetry and telecontrol channel based on FPGA.
为解决卫星电子系统小型化的问题，本研究介绍了一种应用于卫星遥测遥控通道的FPGA设计和实现。
The detecting principle is described in detail. The software flowchart, hardware implementation based on MPU and CPLD/FPGA technology are given.
详细阐述了检测原理，给出了基于MPU与CPLD/FPGA技术的硬件实现和软件工作流程。
This paper is mainly about design and implementation of digital intermediate frequency (IF) transceiver combined with the software defined radios (SDR) technology based on FPGA.
本课题将以FPGA为硬件载体，结合软件无线电技术设计实现数字中频扩频收发系统。
The paper focuses on the design and implementation of FPGA based ASK if transceiver and detailed design and functional verification are described.
文章将重点放在了ASK中频信号发生器和接收机的FPGA设计及实现，给出了详细的设计方案和功能测试结果。
A new implementation of NIDS for fast - speed Ethernet based on the MPM method is proposed finally, and the detection strategies applied FPGA logic and kernel logic are described in detail.
最后，本文给出了一种基于多层模式匹配的高速以太网nids实现方案，并对FPGA硬件逻辑和核心态软件逻辑采用的检测策略进行了详细说明。
The theory and implementation methods of color space conversion based on FPGA are studied, and an improved logic architecture with "time division multiple" is presented.
针对彩色空间变换的FPGA实现方法，在分析原理和一般的实现方法后，给出一种改进的、具有“时分复用”特点的逻辑结构。
The basic principle, design and FPGA implementation of polyphase filtering are discussed, and implementation project of wideband digitized receiver based on polyphase filtering is given.
讨论了多相滤波的基本原理、设计及FPGA实现，给出了多相滤波的中频数字化接收机的实现方案。
The principium, implementation method and simulation results of FPGA -based video format conversion, median filtering and adaptive bidirectional plateau histogram equalization were given.
给出了基于FPGA的视频格式转换、快速中值滤波、自适应平台直方图双向均衡化的原理、实现方法及仿真结果。
This paper discusses the basic principle of channelized receiver with high speed and efficiency based on polyphase filter and the actual implementation scheme of FPGA.
讨论了基于多相滤波器组的高速高效信道化接收机基本原理以及FPGA具体实现方案。
The implementation scheme based on FPGA is proposed, and key techniques such as phase adjusting, elastic store and automatic switch control are introduced.
提出了基于FPGA的无损伤切换的实现方案，并重点介绍了实现中采用的相位调整、弹性存储器和自动切换控制等关键技术。
A new high-speed implementation of SHA which is based on FPGA is proposed, combining two popular hardware optimization techniques, namely "partially unrolling" and "path optimization".
结合“循环打开”和“路径优化”两大硬件优化技术，提出基于FPGA的SHA系列加密算法的高速实现方案。
The implementation based on a FPGA chip has verified the feasibility and the correctness of the interconnection network interface card built on the virtual DDR memory, and verified the memory itself.
基于FPGA的实现验证了虚拟DDR存储器及建立其上的网络适配器的可行性和正确性。
The method was very suitable for hardware implementation based on FPGA (field programmable gate array).
该方法非常适于采用现场可编程门阵列(FPGA)器件的实现。
This paper introduces an integrated design and implementation of the SCS control system based on FPGA.
介绍了基于FPGA的太阳能真空集热管磁控溅射镀膜机控制系统的整体设计和工程实现过程。
This paper introduces a FPGA-based TFT-LCD display controller design and implementation methods.
文章介绍了一种基于FPGA的TFT - LCD显示控制器的设计和实现方法。
应用推荐