In one embodiment, the carrier is made of agarose with improved flow pressure properties.
在一个实施方案中,载体由具有改善的流量-压力性能的琼脂糖制成。
The critical flow pressure is a characteristics parameter which does not change with reservoir pressure.
临界流压是地层的特征参数,不随地层压力发生变化。
Criterion for gas flow pressure loss is presented for rotating liquid film heat and mass transfer device.
提出了旋转液膜气液传热传质设备的气体压力损失的准则关系式。
Two phase flow pressure drop characteristic is an important parameter in the study of two phase flow stability.
两相流压降特性是两相流稳定性研究中的重要特征参数,不同类型的不稳定有不同的压降特性与之对应。
In addition, as flow balancing valve is adjusted by way of flow pressure, the water system will have some resistance.
另外由于流量平衡阀是靠压差方式调整流量的,将对水系统产生一定的阻力。
Several formulations related to the resin velocity, resin filling time and resin flow pressure were proposed accurately.
提出了较准确的树脂流动速度、树脂充模时间和树脂流动压力计算方程。
The change of back-flow pressure, deformed exhaust hole, pre-inflow structure and so on can be adopted to reduce back-flow impact.
根据回流压力的变化规律,采取异型排气口、预进气结构等措施减小回流冲击。
The influence of gas flow pressure produced in gas outburst on air flow stability is studied and related countermeasures are proposed.
分析了瓦斯突出时产生的瓦斯风压对风流稳定性的影响,并提出了有关的防范措施。
Along with the increase of the secondary flow pressure ratio, the shock move toward upstream divergent section and the thrust vector angle gradually increases;
次流压比的增加将导致激波向扩张段上游移动,且喷管矢量角不断增加;
A theoretical calculation and experimental study is conducted of a supersonic steam liquid two phase flow pressure boosting unit, which incorporates a hot water recirculation system.
介绍了具有再循环系统的超音速汽液两相流升压装置,并对该装置的各种性能进行了理论计算及实验研究。
To explore the rules and mechanism of valve movements under the flow pressure in pipes, fluid-structure interaction of valve and fluid in pipes was theoretically analyzed and simulated.
为了探索管道中活门在管道流体压力作用下的运动规律和运动机理,对管道中流体与活门的流固耦合问题进行了理论分析与数值模拟。
Medium is subject to slow flow pressure reduction and then enters the medium flow passage, and can be evenly distributed to various evaporation flow passages among heat transfer plates.
介质经缓流减压之后再进入介质流道,可以均匀的分配到传热板之间的各个蒸发流道。
The selection of pipe wall thickness, the calculation and design key points of the melt flow, melt pipe flow pressure fall and melt flow speed in the design of melt pipes were introduced in detail.
介绍了熔体管道设计中管道壁厚选择、熔体流量、熔体管道流动压力降和熔体流速等计算方法和设计要点。
This paper has analyzed the relationship of flow, pressure pulsation and noise in hydraulic system, and has inquired into generation and propagation of fluid noise in the system.
本文分析了液压系统流量、压力脉动与噪声的关系,对系统的流体噪声产生与传播进行了一些探讨;
If the transport of liquid viscosity and density difference between the larger and water, shall account for the pump parameters: flow, pressure head and shaft power.
若被输送液体的粘度和密度与水相差较大时,应核算泵的特性参数:流量、压头和轴功率。
Through the detection of flow, pressure and level, as well as the rotating speed control unit, the measurement and closed-loop control system is structured.
测控系统通过流量、压力和液位检测单元以及转速控制单元构成闭环控制系统。
High viscosity gear pump does not generate pressure, it is only the output flow. Pressure is low or no pressure, high viscosity gear wheel pump don't inhale the liquid or leakage is serious.
高粘度齿轮泵并不能产生压力,它只是输出流量。压力低或无压力,说明高粘度齿轮泵没有吸入液体或泄漏严重。
The system is able to complete the high-pressure descaling spray flow - pressure, hitting power characteristics of test.
该系统能够完成高压除磷喷嘴的流量-压力、打击力特性测试。
Analyze the relationship between flow, pressure, pressure differential and valve opening of pressure reducing valves.
分析了减压阀的流量、压力、压力差和阀门开度的关系。
Analyze the relationship between flow, pressure, pressure differential and valve opening of pressure reducing valves.
分析了减压阀的流量、压力、压力差和阀门开度的关系。
应用推荐