This paper treats of the fixed end forces of circular curved beam.
本文讨论圆弧曲线杆固端力。
The fixed end moments acting on the member are ignored for the moment.
作用于该杆上的固端力矩暂且都不考虑。
The fixed end moments acting on the member are ignored for the moment .
作用于该杆上的固端力矩暂且都不考虑。
FLOW externally molded onto the body to indicate the fixed end containing a TFE seat.
流向模铸在阀体的外部，表示配置TFE阀座的固定端口。
The boundary value problem usually describes the deformation of elastic beam with both fixed end-points.
该边值问题通常描述了具有固定两端点的弹性梁的形变。
Numcrical calculations show that the impact compression effect of spring is important for dynamic strain of the fixed end.
分析结果表明，考虑弹簧冲击压缩效应与否，对弹簧固定端动态应变历程有很大影响。
At the same time, the reflection characters of strain wave and displacement wave are analyzed at the fixed end, free end and elastic bearing end.
同时，本文分析了位移波和应力波在固定端、自由端和弹性支承端的反射特点。
For the plane stress problem of fixed end orthotropic beams subjected to uniform load, the analytical solutions of stress and displacement were resolved.
针对均布载荷作用下正交各向异性梁在两端固支条件下的平面应力问题，求解了应力和位移的解析解。
With Winkler foundation model, the foundation pressure on Winkler foundation-beam with one fixed end and subject to evenly distributed loading is calculated.
利用文克尔局部弹性地基模型，求解均布荷载作用下一端固定的弹性地基梁的基底压力；
This Paper gives a method of drawing the influence line of fixed end beam and the influence area of fixed edge flat plate which are lying on the elastic foundation bed.
本文提出一种绘制支承于弹簧地基上固端梁影响线及四边固定板影响面的方法。
The stiffness matrix of semi-rigid steel frames and the fixed end moment are deduced, based on the connection element method incorporating the effects of joint flexibility.
采用连接单元法，考虑连接柔性的影响，推导出半刚性框架梁柱的刚度矩阵及半刚性梁的固端弯矩。
The treatment of the fixed end arch bridge, of the continuous arch bridge and of the superstructure on the arch is discussed and practical proposals are made for the solutions.
对固端拱、多孔连续拱和拱上建筑的处理，作了讨论和实用的建议。
Partial Pressure Connection: the varistor of the two fixed end of the bipolar power supply, respectively connected by a sliding side and either a fixed terminal connected to the circuit.
分压接法：将变阻器的两个固定端分别与电源的两极相连，由滑动端和任一固定端连接到电路。
It includes the single site damage detection of continuous beam, simple support beam, fixed end beam, overhanging beam, truss, and the multipoint damage detection of simple support beam.
本文采用了连续梁、简支梁、固端梁、悬臂梁、桁架等的单点损伤识别，简支梁的多点损伤识别。
It includes the single site damage detection of continuous beam, simple support beam, fixed end beam, overhanging beam, truss, and the multipoint damage detection of simple support beam.
本文采用了连续梁、简支梁、固端梁、悬臂梁、桁架等的单点损伤识别，简支梁的多点损伤识别。
应用推荐