The higher the temperature, the lower the critical fiber volume fraction.
温度越高,临界纤维体积分数越低。
The fiber volume of composite parts made by silicon rubber inflatable bag is high.
利用硅橡胶气囊辅助RTM工艺,可以制作纤维体积含量较高的复合材料构件。
With the increase of the fiber volume contents, the degradation rate of the composites raised.
随着纤维体积含量的增加,复合材料降解速度增大。
One of the aims in the design of 3D fabric parameters is to meet the requirement of fiber volume fraction.
三维机织物设计的一个目标是满足要求的纤维体积含量。
One of the aims in the design of 3D fabric parameters is to meet the requirement of fiber volume fraction (FVF).
通过分析三维正交机织物单元体的结构,可以计算经纱、纬纱和捆绑纱的截面尺寸,建立纤维体积含量与织物参数间的关系。
This process can add mould pressure to the preforms through inflating the bladder. Thus, higher fiber volume fraction can be achieved.
该工艺通过向气囊内充压,对预成型体施加一定的成型压力,从而提高构件纤维体积含量及力学性能。
The experimental results show that the compressive strength of preform increases with the increasing of fiber volume fraction and binder mass fraction.
试验结果表明,氧化铝短纤维预制件的抗压强度随着纤维体积分数的升高而升高,随着黏结剂质量分数的提高而升高。
The experimental results show that the compressive strength and split tensile strength have different increases as the fiber volume fraction increases.
试验结果表明,随着碳纤维质量百分数的增加,水泥砂浆的抗压强度和劈裂抗拉强度都有不同程度的提高。
Under the same deposition condition, the porosity of composites with 40% fiber volume fraction is a little bigger than that with 30% fiber volume fraction.
同样沉积条件下,纤维体积含量40%的复合材料与含量为30%的复合材料相比,气孔率略大。
The natural frequency of the composite T-beams increases and damping properties of the composite T-beams decrease with the increasing of fiber volume fraction.
且其固有频率随纤维体积分数的增大而提高,阻尼性能随纤维体积分数的增大而降低。
The experiment results indicate the deformation properties of composites are affected by fiber volume fraction, fabric structure and parameter, tensile direction etc.
结果表明,复合材料的变形性能与增强纤维的含量,织物的组织结构及参数,拉伸方向等因素有关。
The effect of fiber volume fraction on natural frequency and damping was analyzed. The measured and finite element calculated results of natural frequency were compared.
将实验得到的固有频率结果与有限元得到的固有频率结果作了对比。
The result indicates:the toughness of PVA fiber concrete beams is higher than common concrete in any concrete ages, and increasing with PVA fiber volume ratios increasing.
分析结果表明:无论哪种龄期,PVA纤维混凝土梁的韧性要比普通混凝土梁高,且随纤维含量的增加而增大;
It shows the axial tension initial cracking strength of concrete increases with the increasing of steel fiber volume ratio and enhancing of concrete strength grade separately.
结果表明:混凝土轴拉初裂强度分别随钢纤维体积率的增大和混凝土强度等级的提高而增大。
Results show that steel fibers significantly enhance the flexural strength of concrete, and flexural strength increased with the increase of steel fiber volume of dosage increase.
试验表明:钢纤维明显提高了混凝土的抗折强度,且抗折强度随钢纤维体积掺量增加而增长。
A mathematical expression for compressive stress-strain curve of reactive powder concrete was established for different stee1 fiber volume fractions based on experimental analysis.
在实验分析的基础上,建立了不同钢纤维体积含量活性粉末混凝土受压应力-应变全曲线的数学表达式。
In this paper, a special wavelet transform used to analyze snapped section surface image of three-dimensional braided composite material and detect the fiber volume fraction is proposed.
提出了一种基于一类特殊小波变换对三维编织复合材料拉伸断面进行图像处理、测量复合材料纤维体积含量的方法。
The composite skirts for solid rocket motor shells fabricated by VARTM (VacuumAssisted Resin Transfer Molding) had poor mechanical properties because the fiber volume fraction was very small.
VARTM工艺成型的固体火箭发动机壳体复合材料连接裙段构件纤维体积含量较低,复合材料力学性能不佳。
Three kinds of new methods used for detecting fiber volume fraction of 3D woven composite were introduced, such as weighing method, theory model calculation method, digital image analysis method.
文中阐述了适用于三维机织复合材料纤维体积含量测定的3种新方法:称量法、理论模型法、数字图像分析法。
When the steel fiber volume fraction is higher than 3.5%, its compressive strength decreases, the splitting tensile strength increases slightly, however, its flexural strength increases obviously.
当钢纤维体积含量超过3.5%后,活性粉末混凝土抗压强度下降,劈拉强度略有提高,而抗折强度仍有明显的提高。
When the steel fiber volume fraction is higher than 3.5%, its compressive strength decreases, the splitting tensile strength increases slightly, however, its flexural strength increases obviously.
当钢纤维体积含量超过3.5%后,活性粉末混凝土抗压强度下降,劈拉强度略有提高,而抗折强度仍有明显的提高。
应用推荐