The results show that the computed temperature checks fairly well with experimental temperature.
结果表明：计算值与实测点的温度值吻合良好。
N. B. the using temperature of bricks should not exceed the experimental temperature of Linear Change after Heating.
注：砖的工作温度不超过重烧线变化的度验温度。
For infrared burner fueled with manufactured gas design should be performed only according to experimental temperature profile within ports.
对于人工煤气，在燃烧器设计时应通过实验确定火孔内温度分布的曲线后计算阻力系数。
A series of CSTR's were employed to simulate tubular reactor, being supplemented by checking with five sets of experimental temperature profiles.
模型以反应器的分析为依据，用一系列连续搅拌式反应釜逼近管式反应器，并以五组实验温度分布作了校正。
The results showed that the range of the region of phase co-continuity PS/PA6 was 40/60-65/35 at experimental temperature, rotor speed or mixing time;
结果表明在一定螺杆转速、共混温度、共混时间范围内，PS/PA6共混物形成双连续相组分的比例范围为40/60—65/35；
METHODS Recording the 1D and 2D NMR spectra of lomerizine dihydrochloride while changing the experimental temperature and adding D 2O into the solution.
方法测定其在改变温度和加入重水条件下的各种1D和2 D核磁共振谱。
The pressure gradient at every experimental temperature decreases with increasing conduit diameter thus the LPTT can be lowered down in larger size pipelines.
测得不同温度下压力梯度均随管径增大而下降，故增大管径可以降低极限输油温度。
By comparing the two thermocouple temperature was the temperature at each experimental temperature difference in each temperature measurement point to repeat 5 times less on average.
通过对比两个热电偶的温度获得每个实验温度点下的温度差，在每一个温度点上重复测量5次，取其平均值。
N. B. The using temperature of bricks should not exceed the experimental temperature of Linear Change after Heating. The above Heat-Conduction Coefficent is obtained by using flat-plate method.
本试验方法适用于电热合金随温度变化的测量，亦可用于超过电热合金使用温度范围的情况。
The results show that prediction of VLE depends not only on whether the experimental temperature is around the boiling points of the solute, but also on the selection of excess Gibbs energy model .
结果表明，除了该公式本身要求实验柱温在溶质沸点附近外，VLE预测结果还取决于过量自由焓模型的选择。
This article introduces a preparing method of medical gelatin and explores its technological conditions, and gives the best experimental temperature and the best basicity, which has applying value.
介绍一种医用明胶的制备方法并对其工艺条件进行了详细的探讨，给出了最佳实验湿度及最佳的碱度，具有一定的应用价值。
The experimental results of measuring the current of a coil and the environmental temperature agree well with the theory.
对通电线圈的电流及环境温度进行测量的实验结果与理论分析相吻合。
Method Based on experimental study result, mechanism of formation damage from temperature oscillation is analyzed.
方法根据实验研究成果，分析温度震荡引起的储层损害的机理。
The heat transfer and solidification change are analyzed by measuring the temperature change curves of metal mold, casting and pressurized bar in experimental model during local pressurization.
该研究通过试验模型测量局部加压过程中金属型、铸件和加压杆的温度变化曲线，分析了传热与凝固现象。
It can provide experimental environment of hardware for study software compiling and program debugging about temperature measure and control.
为学习温度测量与控制的软件编写和程序调试提供了硬件实验环境。
Actually, in experimental design and running, there are two aspects are often neglected, that the temperature box wind speed and sample placed.
而实际上，在试验方案设计和试验开展中，还有两个方面常常被忽略，即温度箱风速、样品的摆放。
How does the time taken to establish thermodynamic equilibrium depend on the temperature in the experimental cell?
怎么花费的时间建立热力学平衡取决于在实验性细胞的温度？
The exit radial temperature profiles formed by four configurations of dilution hole design have been studied experimentally on a two-dimensional experimental combustor.
在二元试验燃烧室上，研究了四种掺混孔设计方案对燃烧室出口径向温度分布影响。
The mechanical seal experimental unit of change-resisting work condition was a experimental equipment which can adjust temperature and pressure and operate in all kinds of work conditions.
所设计的变工况机械密封实验台是一套模拟机械密封工作状况的实验设备，能够模拟密封各种正常工况及变工况工作情况。
According to the trial, we use finite element analysis program to conduct temperature field and thermal stress analysis of the pier under sunshine, and compared the outcome with experimental results.
根据试验采用有限元分析程序，进行日照作用下桥墩的温度场和温度应力分析，并与实验结果进行对比。
The deviation between experimental and theoretical MITDs is mainly caused by membrane property, temperature polarization and the influence of temperature on OD flux.
膜材料性能、温差极化以及温度对渗透通量的影响是造成这种偏差的主要原因。
The experimental results indicate that secondary air can accelerate volatile combustion in dilute phase zone and raise temperature here remarkably.
实验结果表明：二次风可以促进挥发分在稀相区的燃烧，对提升稀相区的温度作用明显；
Objective To provide experimental evidences for the choice of air-condition temperature and thermal comfort.
目的为室内人工空调温度参数的设定及热舒适度提供实验证据。
This paper describes the experimental study, algorithm, temperature compensation and error analysis.
本文介绍该仪表的实验研究、算法、温度补偿及误差分析。
According to the analysis of experimental data, this paper gives temperature correction coefficients based on pressure.
根据分析结果，对铜柱静压实验数据进行分析，提出了基于压力的温度修正系数。
An experimental researching method-surface temperature method for heat transfer on ceramic coat in low-heat-rejection engine was developed.
本文探索了一种低散热发动机陶瓷表面传热的实验研究方法—表面温度法。
High temperature air generator is one of the critical components of experimental investigation system for study on biomass high temperature air gasification technology.
高温空气发生器是生物质高温空气气化技术研究的实验研究系统的关键部件之一。
Based on those experimental data, we adopted TECPLOT software to visualize all those temperature profiles and velocity profiles and made further analysis.
基于实验数据，用TECPLOT软件进行了速度场和温度场的可视化处理，并加以分析。
In this paper, a kind of thin film thermocouple is designed for transient temperature measurement, and a new experimental scheme of temperature transducer dynamic calibration is presented.
针对瞬态温度测量设计了一种薄膜热电偶，提出了一套瞬态温度传感器动态标定的实验方案。
In this paper, a kind of thin film thermocouple is designed for transient temperature measurement, and a new experimental scheme of temperature transducer dynamic calibration is presented.
针对瞬态温度测量设计了一种薄膜热电偶，提出了一套瞬态温度传感器动态标定的实验方案。
应用推荐