This will mean installing a three-way motorised valve, a cylinder thermostat and making some changes in the pipe layout.
这将意味着安装一个三通电动阀，一个气缸恒温器并对管道布局进行一些更改。
Working principle: piston moves from left to right, form a negative pressure pump cylinder, the liquid tank into the pump by the inhalation valve cylinder.
工作原理：活塞自左向右移动时，泵缸内形成负压，则贮槽内液体经吸入阀进入泵缸内。
According to different working conditions, rotary cylinder valve selection of different control components, can be classified as follows.
根据不同工况，旋筒阀选用不同的控制元件，可以分类如下。
The 4-cylinder is a 16-valve DOHC design with Toyota’s VVT-i variable cam timing system, and is rated at 179 horsepower at 6000 rpm and 172 lb-ft of torque at 4000 rpm.
4缸机为16气门DOHC（双凸轮抽）设计，配备丰田VVT-i（智能正时可变气门控制系统），最大功率179hp/6000rpm(131kw/6000rpm),最大扭矩172lb-ft/4000rpm(233Nm/4000rpm).
Leaks occurring at the cylinder valve's pressure relief device, diaphragms, or valve to the cylinder connection cannot be repaired.
发生在钢瓶阀门的减压装置、横膈膜或阀门到钢瓶的接头处的泄露不能维修。
关闭钢瓶阀门。
The valve lifter, a round cylinder, rides on the CAM.
气门挺杆为一圆筒体，坐落在凸轮上。
For cryogenic liquid cylinders, the transfer line is connected to the cylinder liquid withdrawal valve.
对于低温液体钢瓶，转移管连接到钢瓶的液体提取阀门上。
Recommended Closing Procedure: Close the cylinder valve tightly using a gloved hand. Always wearing gloves when operating cylinder valves. NEVER use wrenches or other persuaders to operate the valve.
推荐的关闭程序：用戴手套的手紧紧地关闭阀门。推荐操作钢瓶阀门时总是戴手套。禁止用扳手或其它强制性的工具来操作阀门。
When returning cylinders to the supplier, properly close the cylinder valve, replace and secure any valve outlet seals, and properly install the cylinder cap.
钢瓶返还给供应商时，正确关闭钢瓶阀门，替换并固定阀门排气口密封，正确安装钢瓶帽。
When a cylinder with this valve configuration is in the upright position, the inlet of the tube is immersed in liquid and the liquid phase will be removed.
当带有这种阀门配置的钢瓶处在垂直位置时，管子的入口浸在液体中，就可以提取液相产品。
Note automatic leak control arm cylinder valve and locked balance valve.
说明内泄出自动臂缸的控制阀及锁死平衡阀。
Two design strategies that three-way valve control unsymmetrical cylinder and four way valve control symmetrical cylinder were analyzed from principle and system structure aspects.
对船用舵机泵控系统中位置控制单元的三通阀控制非对称缸和四通阀控制对称缸的两种设计方案进行了理论分析和系统结构分析。
At the end of the shift or work day, close the cylinder valve and bleed the pressure off the regulator and torch equipment.
在下班或工作日结束的时候，关闭钢瓶阀门，放出调整器和吹管设备内的压力。
Always close the cylinder valve when product delivery is not needed.
当不需要产品输出时，总是关闭钢瓶阀门。
Main products: all kinds of seals for Petrochemical Industry (EOG), Hydraulic cylinder, cylinder, Valve, Metal gate as well as special design products according to different requirements.
主要产品有：石油石化行业(EOG)密封、液压油缸密封、气缸密封、泵阀密封和五金门控缓冲密封，也可以根据用户使用要求设计特殊用途的产品。
Always close the cylinder valve when product delivery is not needed. Do not leave it open when the equipment is unattended or not operating.
当不需要产品输出时，总是关闭钢瓶阀门。当设备无人照管或没有运转时，不要让阀门开着。
With the regulator adjusting knob turned fully counterclockwise, place both hands on the cylinder valve and open it slowly, allowing the pressure to rise gradually in the regulator.
调整器的调节钮逆时针旋死后，两只手放在钢瓶阀门上，慢慢地开启，使调整器内的压力逐渐增加。
They are designed to provide a secondary seal in the event the cylinder valve develops leakage through the valve seat.
它们是设计用来在钢瓶阀门通过阀座产生泄漏的情况下提供一个二次密封。
General installed in the valve cylinder and the cylinder valve between the tube close to the road, so that the exhaust cylinder without a valve directly into to the cylinder for the purpose of rapid.
该阀一般安装在气缸与换向阀之间靠近气缸的管路上，使气缸的排气不经换向阀直接排出，达到气缸快速换向的目的。
Mud valves and Angle by the hydraulic cylinder type combination valve, hydraulic power drive cylinder valve lift, the valve open or closed channel, in order to achieve the fluid off.
排泥阀产品由液压缸和角式截止阀组合而成，液压缸内动力带动瓣升降，使阀体通道开或闭，以达到流体通断。
The tapered or open end is threaded to receive a cylinder valve or other suitable outlet connection.
钢瓶顶部是锥形的，最上端有个小开口。
The tapered or open end is threaded to receive a cylinder valve or other suitable outlet connection.
钢瓶顶部是锥形的，最上端有个小开口。
应用推荐