High rated current for High current circuits. Designed by special lead wire to prevent open circuit failure.
高定格电流以适为高电流电路板。设计特殊导针来预防开路。
Uses: Suitable for high current circuits and widely used in DC. impulse. high frequency and high current circuits.
用途：适用于较大直流，广泛用于各种直流、脉动高频较大的电流场合。
The method can analyze electronic circuits by using Trans Linear circuits, Current Mirrors, Current Conveyers, Switched Current circuits in common use.
该方法可以利用跨导线性电路、电流镜、电流传输器、开关电流电路等单元电路来分析常用电子电路。
Further, the current quadrilateral and admittance quadrilateral, as well as their similarity to the power quadrilateral in non-sinusoidal alternating-current circuits were derived.
由功率四边形进一步确立了非正弦交流电路中的电流四边形和导纳四边形，以及它们和功率四边形的相似关系。
It is recommended that AC power supplies to instruments be protected by fuses or automatic circuit breakers rated at not more than 2 Amperes, and must be separated from any load current circuits.
最好使用交流电源供电，并为设备安装保险丝或额定电流小于2安培的自动断路器，自动断路器还必须与其他负载电流电路分离。
The software that runs in conjunction even allows the homeowner to turn off circuits remotely and to set power consumption limits based on current solar generation rates or the cost of electricity.
同时运行的软件能够让屋主远程关闭电源并根据当时的太阳能产出率或者电源价格而限定电源使用量。
Care must be taken when connecting logic circuits to ensure that their logic levels and current ratings are compatible.
连接逻辑电路时，必须小心翼翼，以保证他们的逻辑电平和电流额定值是兼容的。
Switching applications of high impedance circuits include low current, high resistance, and high impedance voltage applications.
高阻电路的切换应用包括小电流、高电阻和高阻抗电压应用。
Further information on shielding low current, high resistance, and high impedance voltage circuits can be found in Section 5.
关于屏蔽小电流、高电阻和高阻电压电路的更多信息，可参考第5章。
In ac circuits, the current amplitude changes continuously that the concept of phase or time becomes very important.
在交流电路中，电流的幅度是连续不断地变化的，因此相位和时间的概念变得十分重要了。
The two rails are not only signal lines of track circuits, but also loop current line of locomotive traction current in electrified railway block.
电力牵引区段的两条钢轨，既作为轨道电路的通道来传输信号电流，又作为牵引电流的回路来传送牵引电流。
When the voltage is removed, the separated charges generate a decaying current through circuits connected to the insulator as they recombine.
当撤去电压时，这些分离的电荷在重新组合时会在与绝缘体相连的电路中产生衰减的电流。
Step down transformers provide low voltage AC power for lighting, instruments and other circuits that use alternating current at a lower voltage.
降压变压器低压AC电源提供照明，仪器仪表和其他使用交流电在一个较低的电压的电路。
The symmetric ternary current-mode CMOS circuits designed by using this theory not only have simpler circuit structures and correct logic functions, but also can process two-way signal.
应用该理论设计的对称三值电流型CMOS电路不仅具有简单的电路结构和正确的逻辑功能，而且能处理具有双向特性的信号。
The simulative circuits of active network elements, analog signal operation and inductors based on current conveyors are systematically researched. A new active floating inductor is proposed.
系统地研究了电流传送器在有源网络元件模拟、模拟信号运算和电感模拟电路中的应用，提出了一种基于电流传送器的新型模拟浮地电感。
Guided by the switch signal-theory, how to realize the threshold controlling in current-mode CMOS circuits is studied.
以开关信号理论为指导，对电流型CMOS电路中如何实现阈值控制进行了研究。
Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.
虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。
The discharge of circuits' parasitic capacitances leads to a high current spike during turning on.
由寄生电容引起的泄放电流在开通时产生很高的电流尖刺。
This paper proposes a new current-limited comparator including current detect and current comparison circuits.
新型电流极限比较器由电流检测电路和电流比较电路两个部分组成。
These studies have played a complementary role on the current electronic circuits CAD technology.
这些研究对当前电子电路CAD技术起到了补充作用。
BUS protection PANEL, a module (black box) containing electrical circuits for control and protection of electrical alternating current supply to the airplane.
汇流条防护板，黑匣子式的组件，内含控制和保护飞机交流电源的电路。
The constant gm of input stage is achieved by two identical maximum current selection circuits.
采用两路结构相同的最大电流选择电路实现输入级总跨导的恒定。
Contact failure can occur when excessive heat or a high current or voltage pulse causes the contacts to weld together, resulting in short circuits.
当过热或者高电流或电压脉冲导致触点焊接在一起时，就会发生接触故障，形成短路。
The operations of current transmission switch used to realize threshold-controlling circuits were established.
建立了实现阈值控制电路的电流传输开关运算。
The driving circuits adopt constant current chopping for the purpose of improving rotating torque and increasing working efficiency of the stepper motor.
驱动电路采用恒流斩波方式，提高了步进电机的运转扭矩和工作效率。
Some application examples of translinear principle in current mode circuits are given out.
最后给出了跨导线性电路在电流模式电路中的应用实例。
A further focus is on components that are designed to protect circuits from current and voltage surges, ESD and excessive temperatures.
另一个关注焦点为专门设计用于保护电路的元件，使其不受电流和电压冲击、ESD和非正常范围温度影响。
Due to the particular load characteristic, both the current loop and voltage loop control circuits are devised.
并且针对其独特的负载特性，在设计电流闭环控制电路的同时，还设计了电压环控制电路。
The static switch is sized to clear most short-circuits and transient current spikes.
静态开关的大小来清除最短路和瞬时电流峰值。
The static switch is sized to clear most short-circuits and transient current spikes.
静态开关的大小来清除最短路和瞬时电流峰值。
应用推荐