The atomization performance of Pulse Detonation Chamber is investigated using cold test.
进行了用冷态实验模拟爆震室中雾化性能的研究。
The cold test and thermal test for the jet characteristics of coherent jet oxygen lance have been carried out.
对电弧炉炼钢用集束射流氧枪的射流特性进行了冷态和热态试验。
The cold test and production test show that the ceramic burner is suitable for hot-blast stove with high support combustion chamber.
通过冷态试验和工业生产试验表明，该陶瓷燃烧器适于在高架燃烧室的热风炉上使用。
In cold test set of CFB, the effect of the main bed top structure on the particles descending flow near the bed wall has been studied.
在CFB冷态试验台上，深入研究了CFB主床的床顶结构对边壁下降流的影响。
In cold test set of CFB, the effect has been studied of the main bed top structure on the particles descending flow near the bed wall.
在CFB冷态试验台上，试验研究了CFB主床的床顶结构对边壁下降流的影响。
In cold test of boiler, resistance performance experiments of empty bed and different thickness were conducted, and the boiler's critical fluidized flow was determined.
在锅炉冷态试验中，进行了锅炉空床和不同料层厚度下的床层阻力特性试验，确定了锅炉的临界流化风量。
In addition, a cold test model is designed based on a set of designed clustered cavities, the amplitude frequency response of each cavity is measured with network analyzer.
此外，对一套加工成形的簇腔模型进行了冷测模型设计，并使用网络分析仪测量了各个腔体的幅频响应。
And water is used in cold test. Through changing operating conditions, throat area and back pressure, the change rule of discharge coefficient and pressure recovery factor were found.
通过大量冷态试验，在大范围变化工况、变化喉部面积及变化背压条件下，利用水对低温流量控制系统进行研究，得到了流量系数、压力恢复系数的变化规律。
The normal inlet structure of a cyclone was improved to be a new inlet structure with various rotating channels and angles, and a cold test was measured for the performance of the cyclones.
将旋风器常规进口结构优化改进为带有不同回转通道形式和角度的进口结构，并对各种旋风器的性能进行了冷态试验测定。
Finally, a output cavity loaded with a filter is computed and the computed result is analyzed and compared with cold test data in order to conform the reliability of this simulated computation method.
最后通过滤波器加载输出腔的模拟计算结果与冷测结果的比较和分析，进一步验证该方法的可靠性。
Simulation results are in good agreement with cold-test experiment.
模拟计算结果和冷测实验吻合得很好。
The main work of this thesis is simulation of the thermal characteristic and cold-test characteristic for coupled-cavity TWT slow-wave structure with ANSYS, which is a finite-element software.
本文的主要工作就是利用大型通用有限元计算软件ANSYS模拟耦合腔行波管慢波结构的热特性和冷测特性并对该软件进行了二次开发。
The main work of this thesis is simulation of the thermal characteristic and cold-test characteristic for coupled-cavity TWT slow-wave structure with ANSYS, which is a finite-element software.
本文的主要工作就是利用大型通用有限元计算软件ANSYS模拟耦合腔行波管慢波结构的热特性和冷测特性并对该软件进行了二次开发。
应用推荐