Increasing properly coating thickness is helpful to resist th...
适当增大涂层厚度有助于模样抗变形能力。
Micrograph technology was used to measure film coating thickness.
采用显微图像测量薄膜包衣厚度。
At the same temperature, the dipping time is longer, the greater the coating thickness.
在同一温度下，浸镀时间越长，镀层越厚。
Wet film thickness gauges may be used during coating to ensure correct coating thickness.
在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。
The lead fatigue strength is decreased linearly with the increase in nickel coating thickness.
直流镀镍层的引线随厚度的增加，抗疲劳强度呈直线下降。
Notethe coating thickness of weld seam should be not less than 80% of coating thickness on pipe body.
焊缝处的防腐层厚度，不得低于管本体防腐层规定厚度的80%。
Results show that thermal fatigue behavior is associated with circle temperature and coating thickness.
结果表明，复合涂层的热疲劳行为与热循环上限温度、涂层厚度有关。
The preparation parameters were investigated by evaluation of the film coating thickness and uniformity.
以薄膜包衣厚度和均匀性为指标，考察包衣工艺参数。
In the course of color coating steel plate production, coating thickness directly effects product cost and quality.
彩色涂层钢板的生产过程中，涂层的厚度直接影响产品的成本和质量。
It finally discusses measuring methods of coating thickness and technical problems to be solved in measuring methods.
文章最后讨论了“涂层厚度的检测方法”及检测方法中需解决的一些技术问题。
The deposition rate and coating thickness were determined, and the effects were compared with those of electroplating.
对镀速和镀层厚度进行了测定，并与电镀进行了效果比较。
Deposition continues until the coating thickness becomes sufficient to form a barrier against further paint attraction.
继续沉积，直到涂层厚度足够形成一个屏障以对抗进一步的油漆引力。
With the increase of heat flow density, the influence of coating thickness on the interior temperature of tool is enhanced.
随着热流密度的增加，涂层厚度对刀具内部的温度影响增大。
Experimental results indicate that the quality of SEM image is closely related to the coating method and the coating thickness.
试验表明，扫描电镜图像的质量是同喷镀导电膜的方法和厚度有着密切的关系。
Plastic heavy wire mesh of the raw material is coated with a PVC plastic coated wire, plastic coating thickness of about 1mm or so.
包塑重型六角网的原料铁丝是涂敷了PV C塑料涂层的铁丝，塑料涂层厚度大约在1 mm左右。
According to the surface effect of microwave conducting, surface coating thickness is correlative with microwave surface effect depth.
根据微波导通的趋肤效应表明，表面镀层厚度与微波的趋肤深度是相关的。
Reducing plating time and coating thickness can solve these problems. So these methods can solve quality problem of the bubbling and...
减少施镀时间，降低镀层厚度，解决了镀层起泡脱皮质量问题，保证了化学镀镍零件的防腐性能。
Influencing factors to the uniformity of coating thickness for alkaline zinc plating have been studied systematically by Hall-cell test.
采用霍尔槽试验对碱性镀锌镀层厚度均一性的影响因素进行了研究。
Measurement of coating thickness in the proof-test of IC packages and metal cases using X-Ray Fluorescence (XRF) spectrometry is described.
介绍了在外壳检验中，应用X射线荧光光谱法（XRF），对外壳的镀涂层厚度进行测试；
The results showed a good agreement between the coating thickness data predicted by the present model and the data measured experimentally.
结果表明：该模型对镀层厚度的预测值与实测值之间有很好的相关性，可准确地预测不同电流密度、电镀时间下的镀层厚度。
The raw data output from the measuring equipment for surface roughness and coating thickness must be attached to all required documentation.
对所需的所有文档还必须附上测量设备测量表面粗糙度和涂层厚度时输出的原始数据。
The results show that thermal insulation coating and suitable coating thickness are helpful to improving the filling velocity of liquid aluminum.
结果表明，保温涂料及一定的涂层厚度有利于提高铝液的充型速度。
Cartons, cardboard resistance broken meter, temperature tracker, coating thickness gauge, hardness and a high degree of regulation, and other devices.
纸箱、纸板耐破度仪、炉温跟踪仪、涂层测厚仪、硬度计、高度规等测试仪器。
On the basis of electromagnetic induction principles, this paper primarily discusses the design of electrocircuits and probes for coating thickness monitor.
该文根据电磁感应原理，主要讨论涂层厚度监测仪电路和探头的设计。
Tools with internal contours (drilled holes; slots; etc.) can be coated. Depending on the geometry, the coating thickness will diminish as their depth increases.
模具的内部轮廓(孔，槽等)也可以涂层。涂层的厚度会随着深度增加而减小。
Key points in screen stenciling are advanced, including coating thickness, developing time and after treatment, matters needing attention in practice are put forward.
分析了网版制作中的技术要点，包括上胶厚度、曝光显影时间、二次曝光、坚膜处理等，指出了工艺中的注意事项。
The results show clearly that the microwave absorption of dispersions of metallic ultra fine grain relates to particle size, coating thickness, and method preparation.
结果表明：金属超细颗粒弥散系的微波吸收与粒度、涂层的厚度及配制方式有关。
Through the numerical analysis, it is posed that the structure surface stress gradient and the coating thickness are the principal factor that influence thickness effect.
通过数值分析提出，构件表面应力梯度和贴片厚度是影响厚度效应的主要因素。
The required finished coating thickness shall be specified by the purchaser. The specified thickness should not exceed the maximum recommended by the coating manufacturer.
业主需要确定涂层的厚度，但是厚度不应超过涂层生产商的建议厚度。
The required finished coating thickness shall be specified by the purchaser. The specified thickness should not exceed the maximum recommended by the coating manufacturer.
业主需要确定涂层的厚度，但是厚度不应超过涂层生产商的建议厚度。
应用推荐