Click Test connection to make sure that the connection works.
点击TestConnection确保连接工作正常。
Remember to click Test connection to verify your inputs (Figure 15).
记住点击Testconnection以验证您的输入（图15）。
Click Test again, and you should get the response shown in Figure 3.
再次点击Test，您应该获取如图3所显示的回应。
After configuration, click Test Connection to ensure that the changes have taken effect.
完成配置后，单击TestConnection以确保修改生效。
When the message displays confirming that the database has been started, click Test Connection.
当确认数据库已经启动的消息显示时，单击TestConnection。
The signal quality is still low. Move the receiver closer to the wireless mouse, and then click Test Again.
信号质量仍然较低。请将接收器移动到距离无线鼠标较近的位置，然后单击“ 再次测试”。
The signal quality is still low. Move the receiver closer to the wireless keyboard, and then click Test Again.
信号质量仍然较低。请将接收器移动到距离无线键盘较近的位置，然后单击“再次测试”。
No signal quality information was received. Move the receiver closer to your wireless keyboard, and then click Test Again.
未接收到信号质量信息。请将接收器移动到距离无线键盘较近的位置，然后单击“ 再次测试”。
Verify that the Derby network database is running, then select the Order DS data source and click Test Connection (Figure 23).
确认Derby网络数据库正在运行，然后选择OrderDS数据源，并单击TestConnection(图23)。
The signal quality is still low. Try refreshing your connection again by pressing the button on the bottom of the wireless mouse, and then click Test Again.
信号质量仍然较低。按下无线鼠标底部的按钮尝试再次刷新连接，然后单击“ 再次测试”。
The signal quality is still low. Try refreshing your connection again by pressing the button on the bottom of the wireless mouse, and then click Test Again.
信号质量仍然较低。按下无线鼠标底部的按钮尝试再次刷新连接，然后单击“ 再次测试”。
应用推荐