The test principle of multi-core cable testing instrument is presented in this paper.
本文介绍了多芯电缆测线仪的测试原理及应用。
Radiodetection's cable test products quickly locate problems such as breaks or deteriorating insulation.
雷迪公司的线缆故障测试产品能快速定位线缆断裂和绝缘层老化。
This thesis comes from the project of the connecting hardware test in Raychem Cable Accessory Ltd.
本论文来自瑞侃电缆附件有限公司的连接硬件测试项目。
The physical type of the cable connector used to link the device under test and the host
用于链接测试设备和主机的电缆连接器的物理类型。
We got the results in Listing 34 from our own network failure test when we disconnected a network cable from the wmbmi1.in.ibm.com server.
我们的网络故障测试（断开连接 wmbmi1.in.ibm.com 的网络电缆）得到了清单34中的结果。
Please note that the sealing material and cable insulation used in our test units and systems contains silicone.
请注意我们的试验箱和系统中所使用的密封材料和电缆绝缘中含有硅。
Connect the test cable and tighten to specified torque with a torque wrench.
连接上测试电缆，并用一个扭矩扳手紧固到指定的扭矩。
Inspect, monitor, test and adjust cable transmission and distribution systems.
检查，监测，测试和调整电缆的输电和配电系统。
The following paragraphs discuss cable and test fixture requirements and types of connectors generally used when making low level measurements.
以下各段将讨论在进行低电平测量时对电缆和测试夹具的要求以及常用的连接器类型。
Lethal voltage may be present on cable connector jacks or test fixtures.
在电缆连接器插头或测试夹具上可能会出现危险致死电压。
Inspect, test and repair cable and satellite television signals and associated equipment at subscriber's premises.
检查，测试和维修用户住所的有线电视和卫星电视信号和相关设备。
Use a null modem cable to connect the two nodes through their serial ports. Now test the serial connection, as follows.
通过两个节点的串口，使用一根直连线缆将它们连接起来。
Product use: power cable, control cable, optical fiber cable into a necessary device for beam combustion test.
产品用途：是电力电缆、控制电缆、光缆等成束燃烧试验的必备装置。
This paper presents the status-quo of wind power generation, performance requirements for the cable for wind power generation and a special test-torsion test.
本文介绍了风力发电的现状、风力发电用电缆的性能要求及一项特殊试验——抗扭转试验。
Radio frequency and coaxial cable assemblies - Part 1: Generic specification - General requirements and test methods.
射频与同轴电缆组件。第1部分：一般规范。一般要求和试验方法。
Based on an analysis of the problems existed in DC voltage withstand test for rubber plastic cable, some methods currently suitable for testing rubber plastic cables are compared.
在分析橡塑电缆直流耐压试验存在问题的基础上，对目前适合的橡塑电缆试验的几种方法进行比较。
The method offers valuable applicable effects in cable characteristic test and fault diagnostics.
该方法在电缆特性测试和故障诊断等技术中具有较高的应用价值。
The electrical test of submarine cable is an indispensable link after laying and installing the cable.
海底电缆的电气试验是电缆敷设和安装后不可缺少的环节。
The principle and working process of a FM serial resonance device was introduced and its application no AC withstand voltage test of high voltage XLPE insulated cable was also discussed.
介绍一种调频串联谐振装置的原理及工作过程，并在高压交联聚乙烯（XLPE）绝缘电缆交流耐压试验中应用。
From test, the relationship of cable free end, anchor pier, foundation deformation and cable creep with load is revealed and rational design force for anchorage cable is proved.
通过试验，掌握了锚索自由端、锚墩和基础变形以及锚索徐变度与荷载的关系，验证了锚索设计吨位的合理性。
The HVDC withstand voltage test can discover the defect of paper insulated cable efficiently, but it has limitation in discovering the defect of cross-linked polyethylene insulated power cable.
分析了高电压直流耐压试验可有效发现纸绝缘电缆缺陷，但在发现交联聚乙烯绝缘电力电缆缺陷方面有局限性。
The performance of various of cable conduits is analyzed. The inspection of cable conduits and test of friction coefficient is described. The buried depth of cable conduits is calculated.
对各种电缆导管的性能进行了分析，叙述了电缆导管的检验以及摩擦系数的测试，并对电缆导管的埋地深度进行了计算。
It is advanced equipment of communication cable factory test and repair core wire, pair twisting wire at present.
是目前通讯电缆厂检测和修理芯线、绞对线的先进设备。
The electromagnetic system was successfully applied in field test of cable robots on Xupu Bridge.
系统采用电磁检测方法，已在徐浦大桥缆索机器人现场试验中成功进行了实践。
A test method is recommended for the voltage endurance test of high voltage cross linked polyethylene insulated cable.
针对高压交联聚乙烯绝缘电缆耐压试验方法提出了建议。
Through the analysis of high voltage Cross-linked polyethylene (XLPE) cable voltage test, the paper points out that the AC voltage withstanding test is more suitable to XLPE acceptance test.
通过对高压交联聚乙烯电缆（XLPE）耐压试验的分析，提出采用交流耐压试验更适合于XLPE的竣工试验。
Through the analysis of high voltage Cross-linked polyethylene (XLPE) cable voltage test, the paper points out that the AC voltage withstanding test is more suitable to XLPE acceptance test.
通过对高压交联聚乙烯电缆（XLPE）耐压试验的分析，提出采用交流耐压试验更适合于XLPE的竣工试验。
应用推荐