通过网络进行引导。
Because you are not configuring this DHCP server to perform dynamic addressing, it will respond to the boot requests from your LPARs without interfering with normal DHCP operation on the network.
因为没有将这个DHCP服务器配置为动态寻址，所以它将响应来自LPAR的引导请求，并且不影响在网络上进行正常的DHCP操作。
This low-level area of the hardware allows you to reset a hung system, boot from a specific device (like a CD or a network boot), or get into single-user mode.
硬件的这个低级区域允许您从特定的设备（如CD或网络）启动重新设置挂起的系统，或允许您进入单用户模式。
You can use this command to tell the system to boot from CD, disk, the network, or other devices.
可以使用这个命令让系统从CD、磁盘、网络或其他设备引导。
You may normally boot from a hard drive, but you may sometimes need to boot from a floppy disk, a USB memory key, a CD or DVD, or a network.
您可能通常从硬盘驱动器引导，但有时可能需要从软盘、usb内存密匙、CD或DVD，或者网络引导。
For media players or thin clients, however, you could boot from a CD, from a UFD, or over the network.
但是，对于媒体播放器或瘦客户机，您可以从CD、UFE或者通过网络启动。
Modify the example as necessary, then use it to power on an LPAR and attempt to network-boot it from a server in the network.
根据需求修改这个示例，然后在一个LPAR 上使用它，并尝试从网络中的服务器引导它。
Clients without a CD-ROM drive but with a Linux-supported bootable network card, for example, can boot remotely from a Knoppix-running server by means of PXE.
例如，不带CD - ROM驱动器，但是带有支持Linux的可引导网卡的客户机可以通过PXE从正在运行Knoppix的服务器进行远程引导。
Access to CD-ROM devices is not needed during the boot and installation procedure. Compared with the usual installation method from CD-ROM, installation from network provides the following benefits.
在引导和安装期间，不需要访问CD - ROM设备。
This enables a PXE server to know (at boot time) the exact architecture of the client from the first network boot packet.
这使PXE服务器能够知道(在启动时)从第一个网络引导数据包的客户端的确切的体系结构。
This means that a PXE server must respond within that time period to ensure that the client boots from the network and that it does not pass to the next device in the boot order.
这意味着PXE服务器必须对作出响应，以确保从网络引导客户机，并且它不传递到下一个设备启动顺序中的该时间段内。
The BIOS or Extensible Firmware Interface (EFI) of the computer signals a request to boot from the network.
在BIOS或的计算机的可扩展固件接口(efi)信号从网络引导的请求。
The end goal is to enable a client computer to boot from the network and receive a network boot program (NBP) from a server.
最终目标是使客户端计算机从网络进行引导，并从服务器接收网络引导程序 （NBP）。
The end goal is to enable a client computer to boot from the network and receive a network boot program (NBP) from a server.
最终目标是使客户端计算机从网络进行引导，并从服务器接收网络引导程序 （NBP）。
应用推荐