此外，在透射区顶部的IER为透射光和反射光提供了相似的光路。
Additionally, an IER on the top of the transmissive region provides the similar paths for both transmissive and reflective light.
用扫描和高压透射电子显微镜研究了灰铸铁激光硬化层微区组织形貌和精细结构。
Micromorphology and fine structure in laser hardened layer of grey cast iron have been investigated with scanning electron microscope and high-voltage transmission electron microscope.
采用光学显微镜和透射电镜研究了锆处理对微合金钢粗晶热影响区组织的影响。
Microstructure of simulated coarse grain heat affected zone (CGHAZ) of Zr Microalloyed HSLA Steel are investigated using optical microscopy and transmission electron microscopy.
随着铁靶功率的增加，透射光谱的吸收边有微弱蓝移，透过率在可见光区超过75%。
With the increasing of the Fe target power, the transparent of the coatings showed low blue shifts with the transmittance within the visible range being up to 75%.
详细分析了该光瞳滤波器的第一区半径和透射率对施特雷尔比、轴向和横向超分辨因子以及旁瓣能量的影响。
The effects of the radius and the transmittance of the first zone on the Strehl ratio, the transverse and axial gains, and the side lobes are analyzed in detail.
穿过此区的折射因低速而有延迟，又由于透射损失而有衰减。
Refractions which transit the zone will be delayed because of low velocity and attenuated because of transmission loss.
位于导光区两侧的镜带来了分布式布拉格反射，空气孔的排数决定了布拉格反射强度和透射谱。
The rows of air holes decide DBR coming from the mirrors on both sides of the guiding region, which governs the transmission spectrum.
通过透射电镜，观察了IF钢在铁素体区轧制时不同轧制工艺对析出物的形貌、大小、分布和数量方面的影响。
The effect of different rolling technology on the appearance, amount, size and distribution of precipitation has been studied by using transmission electron microscope.
透射电镜观察表明，焊接接头各微区的显微硬度变化主要与时效强化相的析出行为有关。
TEM observation revealed that the changes in micro-hardness of micro-areas across the weld are mainly related with the precipitate evolution during the aging process.
取大鼠右侧大脑海马CA1区组织标本，经过处理后透射电子显微镜观测细胞形态学改变并摄片。
To observe and take a photograph of rats nerve cell morphological changes through electron microscope after sampling and dealing with cerebral tissue specimen of right side hippocampi CA1 section.
用光学显微镜、透射电镜、扫描电镜、能谱分析、显微硬度等分析手段，对ZA合金TIG焊接熔合区的显微组织及其形态、显微硬度及成分等进行了研究。
The character of microstructure and micro rigidity of bond area of the ZA alloy in the TIG welding was investigated using TME, SME and other methods.
采用透射电镜、原位末端探针标记，图像分析，对缺血再灌注损伤区心肌细胞的损伤情况进行研究。
Electronic microscope, TUNEL, Image analysis were used for researches of myocardial apoptosis in ischemia-reperfusion injury region.
首次在透射电子显微镜下观察到渗钒层过渡区的形貌，并对过渡区进行了成分分析。
The photograph of transition region of vanadized layers was observed by using TEM for the first time and the composition was analysed.
退火温度与退火气氛对薄膜的透射率影响不大，薄膜在可见光区的透射率均在85%到90%左右。
Average optical transmittance of AZO thin films is from 85% to 90% in the visible light region.
本文应用X射线透射截面形貌技术研究了氢气区熔硅单晶中氢致缺陷与热处理温度的关系。
The relationship between the annealing temperatures and the hydrogen-induced defects in floating zone silicon grown in hydrogen atmosphere has been investigated by X-ray section topography.
方法晕船模拟器对SD大鼠进行模拟晕船刺激筛选晕船易感大鼠，取大鼠脑干前庭区利用透射电镜观察超微结构相对于正常对照组的改变。
Methods SD rats were stimulated by seasickness simulator. Brain stems were taken to observe the ultrastructure changes. Results rat seasickness model was successfully established.
紫外-可见光谱、微区能谱扫描、高分辨率透射电镜分析、元素分析、热重-差示扫描量热等分析证实了C_（60）对金属纳米团簇表面的修饰；
UV-Vis, Energy dispersive spectroscopy, Element analysis, TG-DSC or TG-DTA indentify that surface of metal nanoclusters was decorated by C_(60);
紫外-可见光谱、微区能谱扫描、高分辨率透射电镜分析、元素分析、热重-差示扫描量热等分析证实了C_（60）对金属纳米团簇表面的修饰；
UV-Vis, Energy dispersive spectroscopy, Element analysis, TG-DSC or TG-DTA indentify that surface of metal nanoclusters was decorated by C_(60);
应用推荐