带切屑瘤的连续切屑：这种切屑显示了粘合或“焊接”在刀具面上材料局部高度变形区的存在。
Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.
本文由连续采煤机几何参数和运动参数与切屑断面积的关系式，定性分析了各种因素对落煤块度的影响。
The article studies the relationships of geometry parameters, movement parameters and coal lump section of continuous miner. It explains the qualitative effect of factors on coal lump.
本文根据实验观察，对高速切削条件下连续型带状锯齿形切屑的形成过程进行了分析研究。
Based on the experimental observation, the high speed formation courses of the continuous banding serrated chips are studied and analyzed.
结果表明，较低切削速度下形成连续带状切屑，而高速切削时形成锯齿形切屑。
The results show that continuous chip is formed under relatively lower cutting speed, while serrated chip is formed under higher cutting speed.
本文通过对连续采煤机截齿排列原则与形式分析、切屑图形成过程及作用、截齿受力与滚筒载荷模型的分析，研究了各因素之间的相互关系。
The relations between factors are studied according to analyzing the principles and shapes of pick arrangement, forming breakout pattern, and analyzing load models of picks and drums.
可是，如果要使切削液起作用就必须让它到达切屑刀具接触界面。但如何在采用单尖刀具连续车削的场合尤其是切屑-刀具接触压力高达70mpa时实现并非易事。
But it is not easy to visualize how it is accomplished in the case of a continuous turning with a single point turning tool, specially when the chip-tool contact pressure is as high as 70 MPa.
连续的切屑一般具有分离金属沿刀具面流动的特征。
Continuous chip. The continuous chip is characterized by a general flow of the separated metal along the tool face.
本文根据实验观察，对高速切削条件下连续型带状锯齿形切屑的形成过程进行了分析研究。
Study on microscopic characteristics of adiabatic shear bands in the serrated chips formed during high speed machining;
本文根据实验观察，对高速切削条件下连续型带状锯齿形切屑的形成过程进行了分析研究。
Study on microscopic characteristics of adiabatic shear bands in the serrated chips formed during high speed machining;
应用推荐