负电阻电路属于电子技术、地球空调领域。
The invention relates to a negative resistance circuit, belonging to the fields of electronic technique and earth air conditioning.
本文重新证明了非线性电阻电路存在唯一解的两个定理。
Alterative proofs of two theorems concerning the existence and uniqueness of solutions for nonlinear resistive circuit are given.
本文提出了一种用两个场效应管实现的压控线性电阻电路。
A voltage controlled linear resistor which consists of only two field-effect transistors (FET) is presented.
我们结束电阻电路这一章时，简短地介绍一下电气测量问题。
We close this chapter on resistive circuits with a brief introduction to the subject of electrical measurements.
本文叙述了一类非线性电阻电路存在唯一解的一种充分条件。
Presented here are the sufficient conditions guaranteeing the existence and uniqueness of the solution for certain nonlinear resistive circuits.
本文提出了一种基本适用于弱非线性电阻电路在软故障情况下的故障分析方法。
This paper presents a modified method for multiple-faults diagnosis of resistance circuits with weakly nonlinear element.
本文利用非线性电路的非线性性质和替代原理，提出一种新的非线性电阻电路参数识别法。
A new method is proposed to identify the parameters of a nonlinear resistive circuit by making use of the nonlinearity of circuits and by the substitution theorem.
对于有源非线性电阻电路，当非线性电阻不存在故障时，各元件参数、特性同样可唯一地确定。
Similarly, for the nonlinear active resistive circuit, when no fault occurs in nonlinear resistances, they can also be uniquely determined.
本文为了描述非线性电阻电路的策动点特性和转移特性，提出了一种折点跳动法，并导出了简明计算公式。
A breakpoint hopping method for determination of characteristics of nonlinear resistor circuit driving point and that of transfer is advanced in this paper. A simple formula is also developed here.
设计了单片机控制双臂电桥测量低电阻电路、多谐振荡测量电容电路、辅助调平电桥电路、输出显示等电路。
The two-arm bridge measuring low resistance circuit of MCU control, multivibrator measuring electric capacity, auxiliary leveling bridge circuit, output display circuit are designed.
讨论了纯电阻电路、非纯电阻电路电源输出功率和损耗功率，分析了输出功率最大值出现的条件及相应的公式。
This paper has discussed the power delivered by the power source lossed in the pure resistor element circuit. Condition of the maximum delivering power has been analysed and equation has been written.
然后他却发现了某些东西：一个除了由电阻，电容和电感组成的标准三重奏之外的第四个基本电路元件。
And he found something missing: a fourth basic circuit element besides the standard trio of resistor, capacitor and inductor.
由于电阻很大，电路中通过的电流就小。
The resistance being very high, the current in the circuit was low.
电路设计者通常会在电路中加入一个名为“温度系数(tempco)”的电阻器来进行补偿。
Circuit designers usually compensate for this by including a resistor known as a "tempco" in the circuit.
另一方面，在一张电路图表里，一个电阻器可能是水平或者垂直朝向的，并可能在之前电路元素的上面、下面或者旁边。
In a circuit diagram, on the other hand, a resistor might be oriented horizontally or vertically, and it might appear above, below, or next to the preceding circuit element.
在卡恩斯电路中，晶体管、电容器和可变电阻器是三个基本元件。
A transistor, a capacitor, and a variable resistor were the three basic components of Kearns' circuit.
组装好电路后，记忆电阻的电压的节奏随着任意的外部电压脉冲而改变。
Wired up the right way, the memristor's voltage would vary in tempo with an arbitrary series of external voltage pulses.
泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
抖动，说明极有可能是消磁电阻损坏，如果没有响声则可能继电器及其控制电路有问题。
Jitter, that is very likely damage degaussed resistance, in the absence of sound may be the relay and control circuit problem.
电路绝缘电阻测量。
高阻电路的切换应用包括小电流、高电阻和高阻抗电压应用。
Switching applications of high impedance circuits include low current, high resistance, and high impedance voltage applications.
在测试电路中，高绝缘电阻是成功地进行静电计测量的首要要求之一。
High resistance insulation in the test circuits is one of the first requirements of making successful electrometer measurements.
在任何电路中至少有三个量，它们是电压、电流和电阻。
There are at least three electrical quantities in any circuit, these are current, voltage and resistance.
Acme代表了零件方面的主要制造商，例如电子和硬件、电桥和二极管、电容器、连接器、感应器、LED显示器、集成电路和电阻器。
Acme represents major manufacturers in parts, such as batteries and hardware, Bridges and diodes, capacitors, connectors, inductors, LED displays, integrated circuits, and resistors.
当电流通过电路时，无论通过那个电阻，都有压强降低的情况。
As current flows through the circuit a volt drop occurs across each resistance.
这种电路的后续基尔霍夫电路法律，并拥有一个电阻和电感。
Such circuits follow Kirchhoff's circuit laws , and possess a resistance and inductance .
关于屏蔽小电流、高电阻和高阻电压电路的更多信息，可参考第5章。
Further information on shielding low current, high resistance, and high impedance voltage circuits can be found in Section 5.
研究人员通过使用热电阻和热电容对集成电路中异质连接双极型晶体管的热效应进行建模分析。
The researchers modelled the thermal effects of a heterojunction bipolar transistor in an integrated circuit using thermal resistors and thermal capacitors.
在进行高电阻测量时，电路的建立时间特别重要。
The settling time of the circuit is particularly important when making high resistance measurements.
在进行高电阻测量时，电路的建立时间特别重要。
The settling time of the circuit is particularly important when making high resistance measurements.
应用推荐