电弧电压：一般认为电源正常输出电压即为切割电压。
Four, arc voltage: generally believe that the power supply is normal output voltage for cutting voltage.
切割机的气源部分应远离明火，并在其附近放置性能正常的二氧化碳或其他相应的灭火装置。
The prologue of air had should be far away from fire, and in its place near normal carbon dioxide or other performance of the corresponding fire extinguishing devices.
结果：经修复的残冠残根能恢复牙体牙冠的生理形态和正常的切割、咬牙合咀嚼功能。
Results:The repaired residual coronas and roots recovered their physiological functions and the normal function of cutting, chewing and artculating.
但气体流量过大，反而会使弧柱变短，损失热量增加，使切割能力减弱，直至使切割过程不能正常进行。
But gas flow rate is too big, but will make arc beam are short and heat loss increased ability to cut down to make cutting process, cannot proceed.
假如下颌骨发育很大，可以切割以后往后退，也可以变得比较正常一点，看起来美观一点。
If mandible bone growth is very big, can go to after cut regressive, also can become a bit normaller, look a bit more beautiful.
将轧制的不锈钢扁板切割成所需的长度，运输时就可以正常堆起来摆放。
Cutting flat-rolled stainless steel into desired length and then normally shipped flat-stacked.
本品配成的乳化液具有较小的导电率用于线切割加工不易断丝，能保证加工正常进行。
This product is prepared from emulsion with smaller conductivity for wire cutting is not easy to break the wire processing, can guarantee the normal.
结论：电动鼻窦切割钻切除部分下鼻甲术后黏膜再生较好，鼻黏膜纤毛清除系统基本恢复正常结构及生理功能。
Conclusions: The nasal mucosa regenerates well after partial inferior turbinectomy with powered microdebrider, and the nasal mucociliary clearance system recovers to normal largely.
实验结果表明，该系统能准确地检测数控线切割机床的故障，并在故障发生时保证机床正常工作。
Experimental results show that the system can monitor the fault exactly and ensure the WEDM run normally.
本实用新型的切割型星型卸灰阀可以对落下的滤袋进行切割，保证卸灰阀正常运转。
The cutting-type star dust discharge valve can perform cutting to a falling filter bag, and ensures the normal operation of the dust discharge valve.
但是在棱角和切割洞孔表面周围的毛剌应钝化，以保证在正常操作处理时不会割伤手指。
Burrs on edges and around holes shall be blunt enough as to not cut the hand when handled normally.
方法对25例正常脊柱行螺旋CT扫描后经三维软件处理，分别按多个切割层面切割成像进行观察。
METHODS Three dimentional images received according to eight angle and sculpting locations were observed in 25 normal spines.
方法对25例正常脊柱行螺旋CT扫描后经三维软件处理，分别按多个切割层面切割成像进行观察。
METHODS Three dimentional images received according to eight angle and sculpting locations were observed in 25 normal spines.
应用推荐