这种接口采用点对点架构，外周设备协商解决总线冲突问题，以确定哪个设备控制数据传输最佳。
This interface uses a peer-to-peer architecture in which peripherals negotiate bus conflicts to determine which device can best control a data transfer.
此设计使rti的信号总线能实现更好地控制数据流的分层控制网。与Insitu公司以前的设计相比。
The design leverages RTI's message bus to implement a hierarchical control network with well controlled data-flows.
重点介绍了通过软件设计由FPGA来实现PC104总线数据传输控制；
This paper emphasizes on using FPGA realizing the data transmission control of PC104 bus through the soft-ware.
考虑到现场的环境干扰较强，对总线电缆及CAN控制器、驱动器采用了冗余设计，保证数据传输的可靠性。
Considering strong disturbance environment in the field area, redundant design in bus cable, CAN controller and driver is involved to assure the reliability of data transmission.
总线是连接计算机各部件的一簇公共信号线，由地址总线、数据总线和控制总线组成。
The bus is the computer parts connected by a bunch of public signal, address bus, data bus and control bus composition.
总线由数据总线、地址总线和控制总线组成。
The bus by the data bus, the address bus and control bus composition.
为了在总线上传输仪器命令和数据，控制器给一个呼叫口和一个或几个响应口分配地址。
To transfer instrument commands and data on the bus, the Controller addresses one Talker and one or more Listeners.
CPU的控制下，数据源器件和数据目的地器件被“使能”(等价于将其连接)至总线用于短暂的传输。
Under control of the CPU, a data source device and data destination device are "enabled" onto (equivalent to being connected to) the bus wires for a short transmission.
为了排除人为干扰、提高可靠性，采集数据以可编程逻辑控制器为核心，通过现场总线和以太网的多层网络传送至数据库中。
To avoid interfering by work, data were sampled through a multi-layers network which synthesize the field-bus and Ethernet and center on programmable logic controller.
第四章讨论总线管理，阐述了数据传输、流量控制和差错控制在网络式仪器总线中的实现。
In chapter four, describes the bus management, and discussed the implementation of data transfer, flow control and error control in the network-stye instrument bus.
软件设计主要包括以下功能模块：接收总线数据、控制EMPC、监控电力汇流条、传送汇流条控制器状态等。
The software includes the following function modules: bus data receive, EMPC control, electrical bus monitor, status data transmission and so on.
VME总线控制器是VME总线系统的关键设备，具有完整的VME总线数据传输能力。
VMEbus Controller, which has the complete data transfer capability, is the key device of the VMEbus system.
介绍了由微型计算机控制的应用智能型数据总线的智能防火系统。
This paper introduces an intelligent data bus fire alarm system by microcomputer control.
给出了一个以CPLD为控制核心的基于计算机PCI总线高速数据采集系统的设计实例。
In the paper, a design example of the high speed data acquisition system based on PCI bus of computer with CPLD as a control kernel is introduced.
该系统采用CPLD实现了DSP与多通道adc的逻辑和时序控制，通过DSP的HPI与PCI总线接口设计实现了采集数据的高速传输。
The system utilizes CPLD to realize logical and timing control between DSP and multi-channel ADC. The interface between DSP's HPI and PCI bus is employed to achieve high-speed data transmission.
本文以摆式列车分布式控制中的数据通讯为例，介绍了CAN总线通讯系统的设计与应用。
Based on the example of the data communication in tilting train's distributed control system, in this paper, introduces the design and application of the CAN bus communication system.
总线控制协议是高速多路串行数据总线的关键，它决定了多路串行数据总线的实时响应能力以及在高负载和低负载情况下的串行数据总线的特性。
Bus control protocol is the key or high rate multiplex data bus. The capacity of real—time responseness of multiplex data bus and properties in high and low load are decided by the protocol.
具有较强的总线控制能力和数据处理能力，能用于较复杂的控制系统之中。
It has powerful control and data processing capability, and therefore can be used in complicated automatic measuring systems.
针对电缆行业制造的特点，利用现场总线网络控制技术自身的优点，提出了一套较为优化的数据采集和监控方案。
According to the characteristic of cable manufacture, utilizing the advantage of bus network control technology, and putting forward an optimization project of data gather and monitor.
智能采集器与控制器通过现场总线通信，交换信息、发送指令、采集数据和控制。
Intelligent data acquisition collector communicates with controller via field-bus, exchanges information, sends command, gather data and control.
同时主要对CAN总线节点的通信程序、家电通用控制器和数据采集模块进行了详细设计，并最终在开发环境下演示运行。
And it designs the CAN field bus node communication, the universal controller and the module of data gathering in details, and finally runs the system under the development environment.
而显示控制器作为控制的一个重要部分，可以对总线的数据实行监测和修改。
As an important component of the control system, display controller can monitor and modify the BUS data in real time.
本设计实现了在MIC总线冗余系统中主控制器与从控制器间的数据通讯。
This design realizes the data communication between the main controller and accessary controller in MIC bus redundancy system.
介绍了先进飞机供电系统及其控制系统的组成，并对数据通信总线的容错设计进行论述。
Advanced aircraft power system and its control system was introduced and fault tolerant design of data bus was discussed.
每种微处理机都具有三组总线，分别供数据、地址和控制信号使用。
Each standard microprocessing unit creates three buses: one each for data, address, and control.
设计出了一种基于可编程自动控制器(PAC)，采用现场总线和I7000系列分布式数据采集模块组成的潮汐模拟控制系统。
In this sense, the control system based on programmable automation controller (PAC) for simulating tide with field bus and I7000 distributed data acquisition units was developed.
介绍了一个支持现场总线的智能数据采集控制系列模块成功运用于铁路信号系统的远程控制的工程实例。
An engineering sample with intelligent data collection control series modules to support field bus and remote control of railway signal system is introduced.
其中USB总线接口芯片CH375是这一部分的核心，选择并控制USB总线的数据传输方式使之适合是本课题的关键部分。
The core of this part is the USB interface chip-CH375. Choosing and controlling the working style of the chip is the emphasis of the thesis.
本地主控机通过RS485总线向现场信号采集设备发送控制指令并接收采集的测试数据，从而实现对rs485总线通信的控制。
The local controller sends steering order to field signal-acquisition equipments and receives test data from RS485 bus, thereby communication control of RS485 bus was realized.
单片机通过CAN总线向主控制器发送检测数据，主控制器经过判断可主动启动并完成车体的制动动作。
The microcontrollers transmit data to the main controller by the CAN bus, the main controller can start-up and finish the brake action initiatively after estimating.
应用推荐