本文测试了带张应力铝纳米梁的电学性质。
This paper tests the electrical character of the al nano-beams with tensile stress.
张应力有利于与R相及马氏体相形核有关的软模。
A tensile stress promotes soft modes which relate to the nucleation of the R-phase and the Martensite phase.
张应力作用6小时导致脊髓细胞的减少和轴突的丢失。
Tensile stress for 6 hours resulted in reduction of spinal cord cells and loss of neurites.
随着板宽的增加,前张应力沿横向的差距先减小后增大。
With the increasing of strip width, the transverse difference of front tension stress decreases firstly, and then increases.
弯曲载荷可以对一个物件同时产生压缩应力和张应力么?
Can a bending load makes both compressive and tensile stress in a member?
电学测试结果表明:张应力下金属纳米梁的电阻值不稳定。
The test results show that the electric resistance of Al nano-beams with tensile stress is instability.
在舷窗结构设计时还应避免使处于张应力的表面与水分接触。
In the structural design of the Windows, it should be noted that the surfaces in high tensile stress should not contact with moisture.
得到了各道次单位轧制压力、前后张应力和出口横向位移的分布。
The distributions of the pressure, the front tension stress, the back tension stress and the exit lateral displacement of each pass are given out.
虽然玻璃可以承受很大的压应力,但是张应力可以使这些小裂痕逐键逐键的长大。
While glass is very strong in compression, tensile stresses will make these tiny fissures start to grow, bond by bond.
目前尚没有关于探讨培养的脊髓细胞对张应力的生物学反应的体外研究。
There are no in vitro studies that investigated the biologic responses of cultured spinal cord cells to tensile stress.
目的评价张应力作用后面颌肌细胞烟碱样乙酰胆碱受体基因表达变化。
Objective:To elucidate the effect of strain on nicotinic acetylcholine receptor (nAChR) mRNA expression in maxillofacial skeletal myocytes.
该止回阀包括被止回阀材料的张应力保持到位并且偏压成被关闭的弹性圆盘。
The check valve comprises a resilient disc held in place and biased closed by the tensile stress of the check valve material.
模拟结果显示:无论是单轴压应力还是双轴张应力,都使得空穴迁移率增大。
The simulation results show that both uniaxial compression and biaxial tension can enhance the hole mobility.
钢化玻璃受一定的急冷温度时,其表面的压应力与张应力方向相反,相互抵消。
When tempered glass suffers rapid cooling of a certain extent, the internal tensile stress and compressive stress on the surface can offset due to opposite stress direction.
铸坯中心线偏析是产生裂纹的内部条件,轧后冷却或矫直过程中的张应力是外部条件。
The internal condition for cracking is the centerline segregation of slab and the external is the tensile stress of slab formed during cooling or straightening.
而扩展裂纹与主应力夹角的逐渐减小则是裂纹附近张应力和剪应力集中点的变化所致。
And that the Angle between extending crack and principal axial stress decreases gradually is caused by the variation of tensile and shear stress focuses in the course of brittle formation.
说明了地幔隆起可在盆地区产生拉张环境,正是这种拉张应力场导致了地裂缝的产生。
The simulation results show that a tension stress field is produced with mantle lifting up.
结果表明:在注入近表面层,样品密度随剂量而增加;表面受到横向张应力的作用。
The results are as follows, the density of the specimen near implanted surface layer increases with dose, horizontal stress takes effect on surface layer.
在同步辐射X射线光刻中,由于掩模的初始张应力和掩膜的非均匀受热将使掩模产生热畸变。
In synchrotron radiation X-Ray lithography, distortion of mask is caused by its initial tension, stress and inhomogeneous thermal effect.
在纳米梁电学测试中,反复扫描电流产生的热会减小梁上张应力,从而使电阻随扫描次数增大。
The scan electric current decrease the tensile stress in the nano-beams, so the electric resistance increase with the scan electric current times.
震源机制结果显示,近E-W向或WNW-ESE向的水平扩张应力控制着该区的岩石圈应力场;
Their focal mechanism solutions show that the nearly E-W or WNW-ESE horizontal tensional stress controls the lithospheric stress field in the region.
由于低渗透页岩地层流体高温膨胀导致的超孔隙压力,有可能产生有效拉张应力,严重时会导致地层破裂。
Due to the higher thermal expansion of fluid in low permeability shale, the super pore pressure may lead to the development of effective tensile stress and even formation fracturing.
用这些计算方法,首次从实验上求得了空位与溶质原子复合体分别在低张应力状态和无应力状态下的扩散系数。
Using these approaches diffusion coefficients were obtained for the first time for complexes under tensile stress condition and no stress condition respectively.
结论不同张应力可引起MMP - 9含量发生明显的变化,对临床上选择最适矫治力可能起到重要的作用。
Conclusion different tension stress patterns take different effects on the secretion of MMP-9. It may play a very important role in choosing the best orthodontic force in clinic.
例如,通过在沟道中引入适当的压应力和张应力能分别提高PMOS的空穴迁移率和NMOS的电子迁移率。
For example, the hole mobility in PMOS and the electron mobility in NMOS can be significantly enhanced by introducing appropriate compressive and tensile channel stresses, respectively.
安装到路基上,尤其当基础张应力很高的情况下,它能吸收并从根本上减弱有裂缝或交通而产生的张应力缝值。
Installed on the subgrade, especially when the basic tensile stress is very high, which can absorb and fundamentally weakened cracks or traffic and the tensile stress of the joint values.
安装到路基上,尤其当路基的基础应力很高的情况下,它能吸收并从根本上减弱有裂缝或交通而产生的张应力缝值。
Installed on the subgrade, especially when the basis of subgrade stress is very high, which can absorb and fundamentally weakened cracks or traffic and the tensile stress of the joint values.
研究结果表明:轧后带钢局部高点高度及附加张应力的大小与来料高点高度成正比,随总轧制压下率的增大而减小。
Results indicate the local high point height and additional tension stress of rolled strip are proportional to local high point initial height of strip, decrease as rolling reduction ratio increases.
介绍板形的基本概念和影响板形的因素,简述板形控制的基本方法,提出了一种由张应力分布控制辊控制板形的新技术。
Briefly analyzing the basic method to control the flatness and brings up a new technology by using the tension distribution control technology to fulfill the control of the profile.
介绍板形的基本概念和影响板形的因素,简述板形控制的基本方法,提出了一种由张应力分布控制辊控制板形的新技术。
Briefly analyzing the basic method to control the flatness and brings up a new technology by using the tension distribution control technology to fulfill the control of the profile.
应用推荐