对称型槽成形的工件较平直。
The workpiece formed by the symmetrical trough is relatively straight.
典型的铣削夹具：图13.3所示为一用于在图示其它工序都完成的工件上铣槽的简单铣削夹具。
Typical milling fixture. Figure 13.3 illustrates a simple milling fixture for milling the slot in the otherwise completed workpiece shown.
介绍了工件退刀槽宽度小于机床退刀行程的内凹齿轮的齿形加工方法，解决了传统加工方法不易实现的难题之一。
Tooth profile machining of mid-concave gear with narrow run-out groove is introduced, which solves a difficult problem using traditional machining.
固体份应保持在20—22%之间，需补加的树脂和颜料浆的数量决定于通过电泳槽的工件数。
The solids level should be maintained at 20 to 22%. The necessary amount of pigment and resin to be added to the tank depends upon the number of jobs run through the tank.
窄深槽磨削时磨削温度很高，易使工件表面烧伤，加工精度降低，刀具的寿命缩短。
When grinding of narrow and deep slot, grinding temperature is very high, which is easy to cause burns of element surface, reduce machining accuracy and shorten tool service life.
加工出了复杂细槽的工件，加工工艺合理，效果良好。
Produce the piece with the complex slug. The machining technology is reasonable and the effect is good.
型槽带有磁力，可固定被测工件，使测量更加准确。
Magnetic square box advantages: V-groove with a magnetic force can be a fixed measured part, so that more accurate measurements.
最后，本文针对微槽切削加工过程，分析了切削参数和刀具磨损对工件毛刺形成的影响。
Finally, the influence of cutting parameters and tool wear on burr formation are studied through the experiment of machining micro-flute.
30度的入槽角是既使工件迅速地侵入槽液中，又能保持槽的深度最小的择中方案。
The thirty-degree angle of entry is a compromise which permits the vehicle to be quickly submerged in the paint while keeping tank depth to a minimum.
30度的入槽角是既使工件迅速地侵入槽液中，又能保持槽的深度最小的择中方案。
The thirty-degree angle of entry is a compromise which permits the vehicle to be quickly submerged in the paint while keeping tank depth to a minimum.
应用推荐