微机械射频开关作为MEMS执行器的一种,是微机械技术中的一类有代表性的结构,是很多微机械器件的基础。
As a kind of MEMS actuators, micro mechanical radio frequency switch is a representational structure of micromechanical technology, and basis of many micro mechanical components.
采用了电容开关的技术以补偿工艺、温度和电源电压的变化,并对片上电感和射频开关进行优化设计以得到最大的Q值。
Some optimization designs were made with the on-chip inductor and the RF switches to get the maximum Q-value.
本文对典型的干扰源—开关电源的传导发射频谱进行了分析,并介绍了降低传导干扰的设计方法。
Conducted spectrum of switched power sources, a typical interference source, is analyzed in this paper, and the design techniques have been introduced to minimize conducted interference.
报道了利用离子注入技术研制出一种用于手机的超低插损砷化镓单片射频单刀双掷开关。
An ultra low insertion loss GaAs MMIC RF SPDT switch based on full-ion-implantation technology is reported.
采用双平衡混频结构进行设计,在射频端口实现宽带阻抗匹配,在本振端口选取合适的开关信号。
With the use of double balance mixer structure, we achieved wideband impedance match at RF port and selected appropriate switch signal at LO port.
基于PIN二极管开关电路在射频信号切换方面的特性,设计了一种应用于滤波器切换的PIN电子开关电路。
Based on characteristics of PIN diode switch circuit in rf signal switching, a PIN electronic switch circuit is designed to perform filter switching.
射频MEMS开关是重要的射频MEMS器件,一些RF MEMS开关已经应用于部分微波系统的前端电路、数字电容器组和移相网络。
As one of the most important MEMS devices, RF MEMS switches have been applied in front-end circuits of some microwave systems, antenna and phase shift architectures.
例如,射频输出线可以耦合到开关,这个开关基于控制信息而被控制,例如,从收发信机接收的控制信息。
For example, the RF output line may be coupled to a switch, which is controlled based on control information, e. g., received from the transceiver.
通过分析MEMS电容开关的工作原理,设计出一种适合分布式射频MEMS移相器电路的新型电容开关。
A novel capacitive switches structure for the distributed RF MEMS phase shifters is presented based on the analysis of the operation principle.
为解决悬臂梁结构的射频微机电系统开关在残余应力的作用下会发生翘曲的问题,提出在悬臂梁的顶端引入斜拉梁的方法。
A DC-contact series radio frequency(RF) micro electromechanical system(MEMS) switch with slanting beams was developed to eliminate warping of the cantilever beam due to residue stresses.
应用计算机辅助设计(CAD)方法模拟设计一种射频微机械(RF - MEMS)开关。
RF MEMS switch is designed by computer aided design (CAD) method.
为了实现射频传输线的薄衬底结构,根据共面波导的设计思想,设计了腔体式共面波导型射频微机械开关。
In order to realize thin dielectric structure of the transmission line and combined the principle of the design of CPW, a cavity structure has also been studied.
雷达天线往往收发共用,通过收发开关连接高功率发射单元和低功率射频单元要考虑收发开关的隔离度问题。
Isolation of the T/R switch must be considered when the high power transmitter is connected to the low power radio frequency unit by T/R switch as the radar antennas are reciprocal.
雷达天线往往收发共用,通过收发开关连接高功率发射单元和低功率射频单元要考虑收发开关的隔离度问题。
Isolation of the T/R switch must be considered when the high power transmitter is connected to the low power radio frequency unit by T/R switch as the radar antennas are reciprocal.
应用推荐