研制了直线电机及其功率驱动器，作为细胞脉动流实验驱动源。
We developed a line motor and its power amplifier, which acted as the driving mode of the cell pulsatile flow experiment.
实验系统由计算机、激光传感器、A／D转换器及输出功率驱动器等实验装置组成；
The control system are consisted of computer, laser sensor, A/D converter and the power driver of output etc.
垃圾转运站和直流电动机驱动器组合系统既经济又非常具有竞争性的低功率驱动器。
The RTS drive and DC motor combination is economical and extremely competitive for low-power drive systems.
在设计过程中，首先根据负载、惯量、速度等机械参数选择控制电机和配套的功率驱动器。
There are three steps to construct the hardware platform. First, select the motor and driver according to the parameter of mechanism.
如果您能帮助客户将其数据转移到这些高容量硬盘，将可以减少全部的驱动器、存储架数量和功率消耗。
If you can assist your customer with the movement of data to these higher-capacity drives, you can help reduce overall drive, shelf count and power consumption.
信号接收器把无线电讯号转化成机械功率运送给驱动器实现制动。
The receiver forwards the signal to an actuator, transforming the radio signal into the mechanical power by which the disk brake is activated.
若想让此驱动器工作，就需要一个能提供更大功率的带适配器的USBhub。
To get the drive to work, a USB hub that offers more power with an adapter is needed.
高功率，互补，线路驱动器输出保证干净，长电缆长度超过清晰的信号。
A high power, complementary, line driver output assures clean, crisp signals over long cable lengths.
高功率线驱动器成为标准配备。
高功率免费线路驱动器输出保证清洁，多长的电缆长度清晰的信号。
High power complimentary line driver outputs assure clean, crisp signals over long cable lengths.
虽然1TBSATA驱动器和一个300GB的光纤通道驱动器的实际功率差异相差不远，但瓦特/容量（单位容量的能耗）的成本差异极大。
While the actual wattage difference between a 1 TB SATA drive and a 300 GB Fibre Channel drive is marginal, the cost difference on a watt-per-capacity basis is significant.
令人印象深刻，在规范中列出的驱动器上显示的仅占1.05瓦，一个1500克营运冲击最大功率消耗。
Impressively, the specs listed on the drive indicate a maximum power consumption of only 1.05 watts and an operating shock of 1500g.
在用于惯性约束聚变研究(ICF)的高功率激光驱动器中，强激光束的传输、放大与控制问题一直是强激光物理与技术研究的重点。
In high power laser drivers used for Inertial Confinement Fusion (ICF) research, the propagation, amplification and control are always the research emphases of high power laser physics and technology.
简要介绍了半导体激光器的温度特性的后，分析了激光驱动器偏置电流提供和自动功率控制(APC)功能。
After the introduction of the characteristics of semiconductor laser diode, the bias current supply of the laser driver and the automatic power control (APC) function were analyzed.
功率放大器的输出误差、压电陶瓷的洄滞及蠕变误差、驱动器之间的耦合误差等是影响机器人运动精度的关键因素。
Output errors of power amplifiers, hysteresis and creep error of PZTs and coupling error among the actuators are the critical factors affecting the motion accuracy of micromanipulator.
目前，国外高功率激光驱动器实现远场分布平滑化的主流技术是基于正弦调频脉冲的光谱色散平滑技术(SSD)。
Nowadays, the mainstream of far field beam smoothing technology adopted by foreign high power laser drivers is smoothing by spectral dispersion (SSD) based upon sinusoidal frequency modulation.
在用于惯性约束聚变研究的高功率固体激光驱动器中，光学元件损伤的在线检测一直是强激光物理与技术研究的重点。
In the study of the high power solid laser for ICF, online inspection for optic damage plays an important part in the research of high laser physics and technology.
高功率，互补，线路驱动器输出，保证廉洁，在长距离电缆长度清晰的信号。
High power, complementary, line driver outputs assure clean, crisp signals over long cable lengths.
在高功率固体激光驱动器中，参考波前标定是自适应光学系统应用过程中的关键技术之一。
In high power solid-state laser driver, the calibration of reference wavefront is a key technique in the use of adaptive optics system.
在18“低频驱动器结合95分贝100 0瓦灵敏度(连续)功率处理能力，能够提供远远超过低频声压水平的典型系统的大小。”
The 18 "low frequency driver combines 95 dB sensitivity with 1000 Watts (continuous) power handling, to deliver LF sound pressure levels well beyond those typical of systems its size."
在15“低频驱动器结合96分贝100 0瓦灵敏度(连续)功率处理能力，能够提供远远超过低频声压水平的典型系统的大小。”
The 15 "low frequency driver combines 96 dB sensitivity with 1000 Watts (continuous) power handling, to deliver LF sound pressure levels well beyond those typical of systems its size."
本文主要研究了声光Q开关驱动器的关键模块——高效率E类功率放大器，设计实现了工程样机。
This thesis does research on the key module of Q-switch driver—high efficiency Class-E power amplifier, including the design and implement of the prototype.
波前功率谱密度（PSD）被用于评价惯性约束聚变（ICF）激光驱动器光学元件中频段的波前误差。
The wavefront power spectral density(PSD) is being adopted for specifying the large optical component employed in high power density solid-state laser for inertial confinement fusion(ICF).
设计了一种具有自动功率控制功能的激光驱动器电路。
A laser diode diver with auto power control function has been developed.
波前功率谱密度（PSD）被用于评价ICF激光驱动器光学元件在中频区域的波前误差。
The wavefront power spectral density (PSD) is being adopted for specifying the large optical components employed in high power density solid state laser for inertial confinement fusion (ICF).
我们的变频驱动器(电子控制器)通过调整电机功率的速度调节的电动传递。
Our variable frequency drives (electronic controllers) adjust the speed of electric motors by modulating the power being delivered.
双18“低频驱动器结合起来，200 0瓦九十八分贝灵敏度(连续)功率处理能力，能够提供远远超过低频声压水平的典型系统的大小。”
The dual 18 "low frequency drivers combine 98 dB sensitivity with 2000 Watts (continuous) power handling, to deliver LF sound pressure levels well beyond those typical of systems its size."
双18“低频驱动器结合起来，200 0瓦九十八分贝灵敏度(连续)功率处理能力，能够提供远远超过低频声压水平的典型系统的大小。”
The dual 18 "low frequency drivers combine 98 dB sensitivity with 2000 Watts (continuous) power handling, to deliver LF sound pressure levels well beyond those typical of systems its size."
应用推荐