Since the author had no experience with winding transformers, this transformer was wound by hand.
由于作者没有绕线包的经验，这个变压器是完全手绕的。
The primary side of the three-phase secondary line winding transformer is directly connected with the voltage output end of the three phase network;
所述三相多副边绕组变压器的原边直接或通过高压开关与三相电网的电压输出端相连；
An equivalent circuit of multi-winding transformer under the impulse voltage test condition has been worked out. The circuit parameters are frequency-dependent.
建立了电力变压器在冲击试验条件下的频率依赖参数的等效电路模型。
Based on the analysis of the differential protection of the double winding transformer, the paper presents a simplified ratio restraint algorithms for the three phase, three winding transformer.
在分析双绕组变压器的差动保护算法的基础上，提出了适用于三相三绕组变压器的比率制动式算法，并对判据进行了简化。
The formulation design, processing characteristic and material choice of winding without filling in epoxy resin cast dry-type transformer are introduced. The warnings in cast process are presented.
介绍了环氧树脂浇注干式变压器无填料绕组浇注的工艺特点、材料的选择和配方设计，提出了浇注过程中应注意的事项。
According to the national standard test methods, the frequency response of winding deformation curve was obtained through testing and analyzing the transformer winding model.
参照国家标准的测试方法，对变压器绕组模型进行了测试、分析，得到了绕组变形的频率响应特性曲线。
In recent years, the ratio of the transformer faults caused by the winding deformation directly or indirectly remains very high.
近年来，由于变压器绕组变形直接或间接导致的变压器损坏事故居高不下。
The method to check short-circuit point between parallel conductors in transformer winding by Gaussmeter and to repair fault point are introduced.
介绍了运用高斯计来探查变压器绕组内并联导线间短路点，并对故障点进行修复的方法。
The application and structure design of common adjustable tensile force tension devices for winding conductor of transformer with different structure are presented.
介绍了常用的不同结构及拉力可以调节的变压器绕组导线张紧装置的结构设计及应用。
The factors that cause the resistance unbalance of transformer winding are summarized and analysed.
综述了引起变压器绕组电阻不平衡的因素，并进行了分析。
When electric power coupling transformer at input current is less than rated value, public winding can be also overload.
电力自耦变压器在其输入电流均小于额定值时，其公共绕组也可能过负荷。
The torsional deflection of spiral winding for the large power transformer is mostly caused by the common effect of the axial current component and the radial leak magnetic field.
大型电力变压器螺旋线圈的扭转变形主要是由于轴向电流分量和辐向漏磁场共同作用所产生的。
A new measurement method for transformer winding deformation is proposed on the basis of ultrasonic reflection principle.
根据超声波反射的原理，提出了变压器绕组变形检测的新方法。
Whem electric power coupling transformer at input current is less than rated value, public winding can be also overloaded.
电力自耦变压器在其输入电流均小于额定值时，其公共绕组也可能过负荷。
The paper analyses the current transformer (ct) that secondary winding possesses casing tap, and its secondary connector wiring fault's influence on the ct changing rate.
文章分析了二次绕组带有抽头的套管电流互感器(CT)，其二次端子接线错误对CT变比的影响。
The vibration signals of core and winding measured from the transformer oil tank with vibration measurement system are investigated.
利用变压器振动测试系统，对在变压器油箱表面测得的铁心及绕组的振动信号进行研究。
The wave process of transformer winding under impulse voltage is introduced. The software for winding wave process calculation is presented.
介绍了变压器在冲击电压下的绕组波过程及绕组波过程的计算软件。
The radial stability of the high capacity transformer winding is compared and re searched with model simulated test. It lays a foundation for development of high capacity products.
对特大容量变压器内绕组径向稳定性进行了模型模拟对比实验和研究，为特大容量产品的开发奠定了基础。
The excitation characteristic of secondary winding of current transformer is the key factor to transformer performance and the quality of secondary winding directly influences that of the quality.
电流互感器二次绕组的励磁特性是决定互感器性能的重要因素，二次绕组品质的好坏直接关系到成品的质量。
It is an effective attempt of our institute to realize the mechanization and specialization of the voltage transformer winding technology and design modularization of the winding machine.
是我所为实现电压互感器绕线工艺的机械化、专业化、以及绕线机设计模块化的有效尝试。
The admittance matrix includes the information about the winding connection of the transformer, the electrical quantities of the transformer, and how the start points are connected.
该导纳矩阵包含了变压器各绕组的联结方式、变压器的电气参数及变压器中性点的接地方式等信息。
The winding loss model of central-tapped transformer in SMPS is different from that of the non-tapped transformer because the two secondary windings work in different time intervals.
中间抽头变压器由于两个副边线圈是分时工作，其线圈损耗模型不同于无抽头原副边线圈同时工作的变压器。
Winding faults can be identified by measuring transformer short-circuit reactance and analyzing the data.
通过测量变压器的短路电抗并计算分析，可以判断变压器的绕组故障。
The fluxes which escape the core and pass through only one of the transformer winding are leakage fluxes.
而逃脱的通量的核心和通过唯一的变压器绕组有漏通量。
A supply voltage can be supplied at the primary winding and the transformer provides a current and a voltage at the secondary windings.
一个电压可在主线圈上供应，而所述变压器可在副线圈上提供电流和电压。
The harmonic compensation currents proportional to the harmonic current in the primary winding, which is detected real-timely, are injected to the multiple secondary winding of the transformer.
实时检测变压器原方绕组的谐波电流，通过逆变器产生与原方绕组谐波电流成比例的谐波补偿电流注入变压器副方多补偿绕组中。
Be suitable for coil winding of stator winding and transformer winding which need wire arrangement.
适用定子线圈，变压器线圈需排线的线圈绕制。
Copper losses are the resistive heating losses in the primary and secondary winding of the transformer.
铜的电阻加热损失的损失在小学和中学绕组变压器。
Copper losses are the resistive heating losses in the primary and secondary winding of the transformer.
铜的电阻加热损失的损失在小学和中学绕组变压器。
应用推荐