Proper gating in this slot area was the only way to avoid weld lines.
开口内采用适当的浇口是避开融接线的唯一途径。
This paper presents a method to explore the implications of gate location on weld lines.
提出了一个分析浇口位置对熔接痕影响的方法。
In order to obtain the best gate location addition, the position of air bubbles and weld lines were forecasted.
预测可能存在的气泡、熔接痕的位置，确定最佳浇口位置，并在此基础上设计模具。
In order to obtain the best gate location addition, the position of weld lines and the clamp force were forecasted.
预测可能存在的熔接痕位置及锁模力的大小，确定最佳浇口位置。
Then using CAE analysis and through adjusting the gate position, weld lines can be optimized to the minimum length, and this result has also been identified by practice.
进而应用CAE软件进行分析，通过调整浇口位置，对熔接痕的长度进行优化，使其减少到最小，结果得到实践验证。
Rectify the axis lines, levelness and elevation of the positioning form, fix it by electric welding on the bear frame and then weld sufficient supports and lifts.
校正定位模板的轴线、水平度和标高，用电焊固定在支架上，并焊上足够数量的支撑和拉杆。
The defect type here includes pits (patches) and uniform appearance except for the defects such as streaks, die lines, weld marks and lines.
缺陷类型包括点(斑)缺陷和大面积的不均一外观。未涉及条纹，模具痕或焊合线等条带型缺陷。
Assessment results showed that all assessment points were located within the failure lines of analysis level 1 and 2. So the pipeline structure with surface flaw at the weld toe was safe.
评定结果表明，不论是采用一级或是二级评定，各评定点均在评定曲线定义的范围内，说明该结构是安全的。
Assessment results showed that all assessment points were located within the failure lines of analysis level 1 and 2. So the pipeline structure with surface flaw at the weld toe was safe.
评定结果表明，不论是采用一级或是二级评定，各评定点均在评定曲线定义的范围内，说明该结构是安全的。
应用推荐