At present, the domestic production lines for concrete weight coating of submarine pipeline are basically imported.
目前，国内管道混凝土配重涂敷厂的生产装备基本为国外进口。
Features: Concrete weight coating is used to provide pipe stability on the sea bed as well as superior mechanical protection.
涂层特性：混凝土配重使管道能够稳定地保持在海床上，同时为管道提供有效的机械保护。
Desciption: Weight coating system composed of cement, water, aggregates, heavy or light depending on the required density and reinforcement.
说明：混凝土配重涂层系统由水泥、水、骨料(按照具体的密度要求使用重骨料或轻骨料)和加固材料组成。
The coating material formula, coating technology and coating equipment for inner machine light weight coating are introduced based on the production experience in Fujian Youxi Coating Paper Co.
结合福建尤溪涂布纸有限公司的生产经验，介绍了机内轻量涂布纸的涂料配方，涂布工艺和涂布设备等。
The results showed that Jinfu seed coating had no bad effect on the growth of kidney bean and plant fresh weight was added above 10%.
结果表明，金斧种衣剂对芸豆出苗后生长发育无不良影响，植株鲜重平均增加10%以上。
While disposable cups are made predominantly of cardboard (about 95% by weight), they also contain about 5% polyethylene in the form of a thin coating inside the cup.
便携杯子虽主要由硬纸板构成（重量占比达到约95%），但还是包含了约5%的聚乙烯（polyethylene）以很薄的涂层形式附着在杯子内侧。
Adjustment in preheated control, die-to-roll distance, and roll pressure can be made to modify substrate adhesion. Coating weight is usually controlled by adjusting line speed.
预热控制的调整，模具到卷轴的距离，以及卷轴的压力都可以修改基层黏合。生产线的速度通常控制涂料的重量。
In this study, Opadry II (85 series) Clear was shown to have lower coating weight gain standard deviations than a standard clear hypromellose based film coating.
欧巴代II（85系列）无色显示包衣增重标准差低于相同工艺条件下的标准无色羟丙甲纤维素基薄膜包衣。
The effects of the composition and molecular weight of the HDI oligomer on the properties of coating film were studied.
通过改变HDI齐聚物合成反应的条件，探讨了齐聚物的组成和分子量对涂膜性能的影响。
Within first 20 hours, there was apparent weight loss of the coating, and then weight loss became slower gradually.
两种涂层均在降解20小时内失重明显；之后，失重率曲线趋于平缓。
Continuous Galvanizing Line with 'hot' coating weight gauges, installed directly above the air knives.
连续镀锌线，装有热态涂层重量测厚仪，直接安装在气刀的正上方。
The importance of the coating weight control for the CGL and the model control technique used by most manufacturers at present are first introduced.
首先介绍了热镀锌机组镀层重量控制的重要性和目前主要厂家所使用的模型控制技术。
We are the world's market leader for online non-contact coating weight gauges and coating weight auto-control systems for continuous galvanizing lines.
我们公司在线非接触式涂层重量测量系统和涂层重量自动控制系统领域是全球的领导者。
The results of loquat stored in the ways of packing, coating film or low temperature were compared. Effects on losing weight ratio Browning ratio, and storing period were also studied.
试验目的是调查包装、涂膜和低温贮藏对枇杷果实的保鲜效果，并对枇杷果实的失重率、褐变率及贮藏期的影响进行探讨。
The effects of pretreatment for powder coating on the galvanized steel sheet were investigated through tests of cryslalography, film weight and salt spray test, and the existing process was improved.
对一种用于汽车和通讯行业的新型预磷化镀锌钢板的粉末喷涂前处理工艺进行了研究，通过晶相、膜质量及盐雾试验，对预磷化板的现有工艺进行了改进。
The coating of the jewelry contains 1-40% of flavor combination by weight percentage;
所述首饰品涂层中含有1～40％重量百分比的香料组合物；
The method for preparing the coating comprises the following steps of mixing the prepared component 1 and the component 2 with the weight ratio of 8:1, thus preparing the coating.
该涂料制备方法将制得的组分1按8∶1的重量配比与组分2的固化剂混合后，即得到该涂料。
METHODS The orthogonal design method was used to optimize coating material, coating weight, content of the porositymaking agent.
方法：采用正交设计以体外溶出为指标，对包衣材料种类、包衣剂用量、致孔剂用量进行处方筛选。
Also, the influences of the ratio of rosin to paraffin wax in coating, and of coating weight on the nutrient release rate were discussed.
分析了松香与石蜡的配比、涂层量对包膜尿素养分释放速率的影响。
With the increase of temperature, the weight loss of zinc coating increases.
且随着温度的升高， 镀锌板的锌层脱落量增加。
The effects of additive in the silicasol back coating slurry on the weight of investment castings are investigated.
试验考察了硅溶胶精铸型壳的背层浆中加入高温焙烧易挥发性添加物对精铸件重量及其分布的影响。
Results showed that the relationship between weight loss of coating sample, substrate sample and exposure time obeyed with power function in the simulated conditions of the marine splash zone.
结果表明：在海洋飞溅区模拟条件下，涂层试样和基体试样的腐蚀失重与试验时间的关系曲线遵循幂函数规律。
The resistant oxidation protective effect of coating was characterized by means of energy dispersive spectroscopy(EDS) analysis and oxygen weight-gain testing in different scope temperature.
大连理工大学博士学位论文4．在不同温度范围内，对涂层的保护功能，采用能谱（EDS）分析和氧化增重实。
IRM group has over 50 years of experience developing systems to measure thickness, flatness, width and coating weight utilizing X-ray and laser technologies.
IRM集团具有超过50年的专业经验，利用X射线和激光技术生产开发测量厚度，平直度，宽度和金属涂层厚度的测量系统。
Crystal size should be small and dense, with a coating weight appropriate to the particular phosphate method.
晶粒应小而致密，膜重与磷化方式相称。
Higher molecular weight recommended for cross linking with amino and phenolic resins stoving lacquers for internal coating of cans and tubes.
高分子量，建议与氨基改性酚醛树脂组合，生产罐的内层涂料。
The resilience punching coating pachymeter has small size, light weight, and easy use, and can solve the problem of measuring the coating thickness at the construction field site.
本实用新型体积小、重量轻、使用方便、解决了在施工现场测试涂层厚度的问题。
It was found that the weight per cent of ceramic particles in the coating, the component of matrix and the erosion conditions have great effects on the anti-erosion properties of SMCC.
发现基体组成、陶瓷颗粒种类、含量及冲蚀条件对有机硅复合涂料耐冲蚀性有很大的影响。
In the respect of loss weight, with the increased corrosivity in solution, concrete samples lose more weight, with HPC and NHPC samples mainly peeling cement paste, and WHPC samples peeling coating.
质量变化方面，各试件质量损失随着溶液腐蚀性的增强而增大，HPC和NHPC主要是水泥浆的剥落，WHPC是涂层的剥落。
The plastic substrate may be ultra-high molecular weight polyethylene and the UV opaque coating may be unexpanded polytetrafluoroethylene (' PTFE ').
该塑料基底可为超高分子量聚乙烯，并且UV不透光涂层为未膨胀的聚四氟乙烯(“PTFE”)。
应用推荐