The software design of waveform.
波形显示软件设计。
On this basis, the complete waveform generation of software design, and to prepare the full process.
在此基础上，完成波形生成的软件设计，并编写出完整的程序。
At The compression ratio of 190, waveform design and signal processing hardware experiment are given.
给出了压缩比为190的波形设计实例和信号处理的实验结果。
A waveform design method that can restrain the multipath effect was proposed. It was achieved by placing signal on the second zero point of waveform filter and keeping the information rate.
提出了一种能够抑制多径干扰的基带波形设计方法，该方法是通过保持传输信息速率不变，在成形滤波器第二个零点叠加信号来实现的。
The stamping technique and design of bending former for a typical waveform piece in clutch driven plate assembly were introduced.
介绍离合器从动盘总成中的一种典型波形片零件的冲压工艺及弯曲成形模设计。
Last, the test data sent out by signal generator comes into the system, plots the waveform from export data after the function is achieved, and gives validation analysis to the design method.
最后由信号源发出测试数据进入系统，进行功能实现后输出数据绘制出波形图，对所设计的基带系统驱动方案进行验证分析。
A number of design formulars for the step height of waveform, the transformer coil and commutation components are derived.
文中导出了这一波形的阶梯高度、变压器线匝和换流元件的设计公式。
The design of the system fabric the DSP control board the algorithm of waveform generating and the power amplifier are introduced.
文中着重介绍了系统架构、DS P控制板、波形产生算法和功率放大器的设计。
It is discussed how to use CPLD to design an arbitrarily combinatorial coding waveform generator in this paper.
讨论了如何使用可编程逻辑器件设计任意组合编码波形发生器。
This paper presents a new design scheme of program controlled generator for coding waveform based on HDPLD.
本文提出了一种基于HDPL D的可程控多位任意组合编码波形发生器设计新方案。
The test vectors generation and verification in ASIC design are introduced, including stimulus writing guidelines, waveform audit, vectors strobe and simulation used for test vectors.
介绍了ASIC设计过程中测试矢量的产生与验证步骤，包括激励编写规则、波形检查、测试矢量的获得以及测试矢量的验证。
The selection of the initial shift register of M-sequence is a key technique in pulse compression waveform design whose pulse compression waveform must have low peak power and large compression ratio.
二相编码波形设计中初始移位寄存器的选择是个关键技术，它直接决定了信号波形在满足最小峰值功率下能否具有最大脉压比。
The paper mainly describes the design of the inverter, including circuit, DSP software design and PWM waveform generate theory.
重点叙述逆变器的设计，包括电路结构、DSP软件的设计、PWM波形的产生原理；
To produce the smooth waveform with the stable frequency, this paper presents a design method of sine signal generator's function circuit which is based on the DDS theory.
为了能够方便地产生波形平滑、频率稳定的正弦信号波形，提出了一种基于DDS技术的正弦信号发生器的设计方法。
Based on the UWB radar system, the emitting waveform design and signature waveform detection are discussed respectively in this paper to realize the detection and discrimination of targets.
本文在超宽带雷达体制下分别从发射波形设计和特征波形检测两个角度来实现目标的检测和识别。
We pictured the hardware structure of gradient waveform generator. The introduction of FPGA and FPGA design flow is also described.
文中描述了梯度波形发生器的硬件结构，简介了卡上fpga内部结构及FPGA内部逻辑设计流程。
This paper studies the design methods of the nonlinear frequency modulation signal waveform.
研究了非线性调频信号波形设计方法。
The main task of this paper is a combination of virtual instrument technology, arbitrary waveform generator of the research and design.
本论文的主要工作是结合虚拟仪器技术，进行任意波形发生器的研究与设计。
Finally, the experimental and waveform analysis showed that the system met the expected design requirements.
经相关的实验及波形分析，表明该系统满足预期的设计要求。
Secondly, the paper carried out arbitrary waveform generator software design.
其次，论文进行了任意波形发生器的软件设计。
As for different signal modality, the focus in waveform design is different too.
针对不同信号体制，波形设计时所应考虑的侧重点也不同。
Emulate experiments and lake experiment obtained lower error code rate than traditional waveform design method using this waveform structure with multiple phase shift key modulation.
以多进制相位调制方式采用这种波形结构进行了仿真实验和湖水试验，都获得了比传统的波形结构更低的误码率。
The design of SPWM waveform, hardware implementation and data processing are proposed.
文中论述了SPWM波形的设计、硬件构成和数据处理过程。
Here we bring forward one digital waveform generator based on DDS technology, use CPLD to do hardware design, finish functional and timing synthesize with certain EDA tool's help.
文中设计了一种基于DDS技术的数字波形发生器，并在此基础上采用CPLD技术来进行硬件设计研究，对电路的数字部分进行了分步设计以及功能仿真和波形仿真。
The radar waveform not only direct the signal processing, also affect the system resolution, measure precision, power of suppress clutter and so on. So its design and selection is very important.
雷达发射波形不仅决定了信号处理方法，而且直接影响系统的分辨力、测量精度以及抑制杂波能力等性能，因而它的设计和选择至关重要。
Then a new adaptive waveform design scheme is presented. As a result an optimal waveform can be selected and the performance of fire control radar can be improved.
基于实际作战需要，提出了一种波形设计的新思路，实现了各重复频率脉冲的自适应选择，以使雷达能够智能化的始终工作于最佳状态。
For active detection, through the different methods of waveform design, ways to synthesize high-resolution range profiles by different high-resolution signals is researched.
主动探测通过不同的波形设计方法，研究了各种高分辨力信号实现高分辨距离像的方法及其优缺点和应用。
The output waveform of the module is the same figure as the simulation waveform. This result indicates that the design method is feasible.
基本驱动模块电路输出波形的测试结果表明，这种设计方法是完全可行的。
It introduces the overall design of the system in chapter two, formed mostly with precondition of pulse, enlarge signal, Low-Pass Filter, AD Conversion, Serial Communication, waveform showing etc.
第二章介绍了系统的总体设计方案，它主要由脉搏信号预处理、信号放大、低通滤波、AD转换、串行通信、波形显示等几部分组成。
It introduces the overall design of the system in chapter two, formed mostly with precondition of pulse, enlarge signal, Low-Pass Filter, AD Conversion, Serial Communication, waveform showing etc.
第二章介绍了系统的总体设计方案，它主要由脉搏信号预处理、信号放大、低通滤波、AD转换、串行通信、波形显示等几部分组成。
应用推荐