The results show that water flow simulation and optimization models are better than others.
计算结果表明，枯水流量演进模型是可行的，是对流量演进理论的有益尝试和补充；
Temperature and flow fields, and interfaces of water freezing in soil and crude oil solidifying in the pipeline were obtained through numerical simulation.
通过数值模拟，获得了停输期间温度场、流场以及土壤水分结冰界面和管道中原油凝固界面的分布情况。
The recharge simulation method of intercepting certain boundary flow under higher natural water table is studied and presented.
研究并提出了较高天然地下水位条件下截取边界定流量补给模拟方法。
On the basis of flow field simulation, the effect of different types of nozzle structure on the flow patterns are calculated and examined with water model experiments.
在此基础上模拟计算了几种不同形式的水口对流动形态的影响，并用水力模型试验进行了验证。
The cluster of workstation for parallel arithmetic is established to carry out the large-scale numerical simulation of shallow water flow.
建立了并行计算系统工作站机群，实现了浅水流动的并行数值模拟。
The fluid flow and transport process of non metal inclusion in tundish under bottom blowing are studied by numerical simulation and water model experiment.
采用数值模拟手段，结合水模型实验，研究了中间包底部吹气过程对中间包内流场及夹杂物传输行为的影响。
The flow field of film-cooled turbine vane is investigated in this paper with the help of water simulation.
本文通过水模拟实验，对涡轮叶片气膜冷却时射流的流场进行了研究。
Simulation of turbulence atomization jet in the air-water two phase flow field was performed.
对水在空气中湍动雾化射流的气液两相流场进行了数值模拟。
Based on the Reynolds stress model CFD numerical simulation method, both flow mechanism and flow characteristics of dispersed oil phase in oil-water separation hydrocyclone were studied.
采用雷诺应力模型CFD数值模拟方法，对油水分离器内的流动机理和分散油相的流动特点及处理方法进行研究。
The response was compared with that obtained through simulation realized by the use of MATLAB and the actual process on different steam flow, feed water flow, fuel flow and control method.
并运用MATLAB仿真工具，针对锅炉水位和汽压调节对象仿真模型在不同的蒸汽负荷、不同给水量、不同燃油量和不同控制方式下的动、静态情况进行仿真研究。
This method can describe the water flow velocity and vortex function distribution on all points of the reactor, with the simulation result in good coincidence with field test data.
该方法能够描绘出反应器内各点的水流速度以及涡流函数分布，且模拟结果与试验测定结果吻合得较好。
Numerical simulation is one of effective tools for studying water flow, and there are still many difficulties in numerical study of water flow for turbulence and complicated boundary conditions.
数值模拟是研究水流运动的主要手段，但由于湍流运动以及边界的不规则性，给水流运动的数值模拟带来了较大困难。
The article describes its characteristics and points out their study directions. One is how to control soil water in aeration zone, the other is numerical simulation study on water-gas flow.
本文在阐述包气带水特征的基础上，指出了包气带水研究方向：一是包气带中土壤水的调控研究，二是水—气二相流数值模拟研究。
Infiltration model for surge irrigation is the base of surface water flow movement simulation and irrigation scheme design of surge irrigation.
波涌灌溉土壤间歇入渗数学模型是进行波涌灌溉田面水流运动数值模拟和灌水方案优化设计的基础。
Lateral routing flow of surface water and subsurface soil water become necessary in land surface simulation in mountainous regions.
地表水以及土壤水的侧向流动成为山区水文过程必须考虑的部分。
For this reason, the numerical simulation on the flow and heat transfer in engine water jacket becomes a principal method to optimum cooling system.
因此，内燃机水套冷却液流动数值模拟便逐渐成为目前研究内燃机水套冷却液流动、设计和优化水套结构的重要手段。
Through case study on water flow and soil simulation, it is proved that the method is prospect for broad practical use.
该文以水流与土壤模拟为例，论证该方法的应用前景。
The numerical simulation on fluid flow in cooling water jacket of 498 diesel engine is performed using computational fluid dynamics (CFD) software FLUENT.
应用CFD模拟分析软件FLUENT对498发动机冷却水套内的流场进行模拟计算，研究分析了水泵内流场对发动机内冷却水流动的影响。
For this reason a renovation design of building a prism shape of overfall weir to stop the water flow and optimal measures were proposed and adopted. Simulation experiment resu...
为此，在模型试验的基础上提出了棱块体挡流堰改造方案，并采取了相应的优化措施。
The 2_d average water depth mathematical model in orthogonal curvilinear coordinate system is used for the numerical simulation of the flow field in the diversion channel of large pumping station.
应用正交曲线坐标系下的二维水深平均数学模型对大型泵站的引水河道流场进行了数值模拟。
In the research of water hydraulic technology, flow field simulation is done by the method of Fluid-Solid coupling, leading to the pressure nephogram and velocity vector of the pump model.
在水压技术理论研究方面，应用流固耦合理论对水压齿轮泵进行了二维流场的仿真分析，得出了其流场压力云图和速度矢量图。
In the research of water hydraulic technology, flow field simulation is done by the method of Fluid-Solid coupling, leading to the pressure nephogram and velocity vector of the pump model.
在水压技术理论研究方面，应用流固耦合理论对水压齿轮泵进行了二维流场的仿真分析，得出了其流场压力云图和速度矢量图。
应用推荐