Furthermore, a circuit that can adjust drive voltage value for IGBT has been presented.
另外，还给出了一种可对IGBT的驱动电压进行幅值调整的电路。
The voltage value related to its capacitance value can be output directly by the measurement circuit.
测量电路可直接输出与电容值相对应的电压值；
Dielectric absorption is calculated from the residual voltage value, as described in the previous paragraph.
按照前一节介绍的方法，从剩余电压的数值就能计算出介电吸收。
If the working-frequency discharging voltage value exceed normal range, can faintly adjust the discharge gap.
如果工频放电电压值超出范围，可对间隙进行微调。
The invention provides a method of performing input voltage value to comparator and an optical-driving circuit.
本发明提供一种用于确定输出到比较器的输入电压值的方法及光驱动电路。
Applying the diagram, it is convenient to compute the reactive power necessary for keeping the voltage value constant.
用调相设备调整无功功率，保持电压偏移在规定的范围内。
As the increase of power dissipation and the decrease of power voltage value, voltage drop becomes more and more serious.
随着功耗的增加和电源电压的降低，电压降落变得越来越严重。
On the basis of the theories, the release voltage value of electromagnetic relay in the accelerated storage life testing were fitted and forecased respectively.
在此基础上，针对电磁继电器贮存加速寿命试验所得到的释放电压数据分析进行拟合与预测，并对各种回归分析方法的拟合与预测结果进行了精度分析。
It is found that the change of threshold voltage value fits in exponential law with absorbed dose, which is caused by the effect of space charge and interface charge.
产生这种现象的原因是场效应管氧化物中的空间俘获电荷与吸收剂量近似成线性变化，对阈值电压变化和吸收剂量有近似线性的改变；
The basic theory for voltage and reactive control and the taps changed in transformer and shunt capacitor switched affect the voltage value are discussed in the paper.
本文从电压无功综合控制的基本原理出发，说明了变压器分接头的调节与并联电容器投入容量的大小对电网电压的影响。
First, the topology of the inverter and different output voltage level numbers in the situation of different voltage value ratio of two DC power supplies are analyzed.
文章中首先分析了逆变器的拓扑结构以及在直流端电压比不同的情况下的输出电平数。
The equation is given which explains the relation between resonance frequency and capacitor bank capacitance, bus short-circuit capacitance and bus rising voltage value.
本文分析了谐振次数与电容器组容量、母线短路容量以及母线电压上升值之间的数学关系。
For analog inputs, any absolute voltage value above which the analog-to - digital converter cannot distinguish a change. The overload value can be different for plus and minus inputs.
就模拟输入而言，使模数转换器不能区别其变化的超范围的绝对电压值。超载值对于正输入和负输入可能不同。
Texas Instruments TLC5615 for U. S. products introduced in 1999, is a serial interface of the DAC, the output voltage type, maximum output voltage is twice the reference voltage value.
TLC5615为美国德州仪器公司1999年推出的产品，是具有串行接口的数模转换器，其输出为电压型，最大输出电压是基准电压值的两倍。
In the voltage regulator circuit, the zener diode which ACTS as the voltage datum, along with the temperature change, its regulated voltage value also can have the corresponding change.
在稳压电路中，作为电压基准的稳压二极管，随着温度的变化，其稳定电压值亦会发生相应的变化。
Now lower the voltage to its previous value and the bar's vibrations slow down, but not to the original frequency.
现在把电压降低到原来的大小，硅条的震动减弱，但是并不会减弱到原来的频率。
The choice of the nature and value of the test voltage is determined by standards which apply to the product tested.
测试电压的性质和数值的选择应由所测产品应用标准决定。
Which one is actually observed depends on whether the voltage has been increased or lowered to the required value.
出现哪个取决于电压是否被提升或减弱到所需的值。
The exact determination of the breakdown voltage must therefore be attached to the measurement of an electrical value characteristic of the dielectric breakdown phenomenon.
因此击穿电压的检测必须重视电介质击穿现象的电参数值的测量。
The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.
然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。
The voltage of the individual cell is determined by calculating the present value, based on a series of measured cell differences, from an accepted reference.
单个电池电压的当前值是与一个已知的参考标准进行比对，从一系列测得的电压差中计算出来的。
When using remote sense, the voltage difference between high force and high sense, and between low force and low sense is usually limited to a specified value.
在采用远地取样时，通常将强制高端和取样高端之间以及强制低端和取样低端之间的电压差限制在规定的数值之内。
With 12 LED digital display, can show the tube voltage, current and count value.
具有12位LED数码管显示，可分别显示电压、电流、计数值。
The offset voltage will cause an error in the applied stimulus to a device under test or the value measured by the voltmeter.
偏移电压会导致施加到被测装置的激励发生误差，或者使伏特计的测量值发生误差。
It is also possible to set U1 voltage to a value near zero, for quadruple-field XRII.
在四视野X线影像增强器里也可能将U 1电压值设定为零左右。
As shown in Diagram 1, as from the voltage Uc, the leakage current increases very swiftly and the breakdown voltage is reached for value ue.
正如图1所示，而从电压Uc开始，漏电电流迅速增加，击穿电压达到Ue。
The buildup of the opposing voltage to its full value requires a longer time .
反向电压上升到它的满值需要较长的时间。
Very high ohmic value resistors may exhibit a significant change in resistance with a change in applied voltage.
当施加的电压变化时，非常高值电阻器的阻值可能会发生很大的变化。
The driving device with output unit has the same value for the output resistance of different voltage level.
驱动装置结合有输出单元，其对于不同的电压电平的输出电阻具有相同的值。
The driving device with output unit has the same value for the output resistance of different voltage level.
驱动装置结合有输出单元，其对于不同的电压电平的输出电阻具有相同的值。
应用推荐