The third and a fourth voltage signals are generated in response to a second control signal.
所述第三和第四电压信号是响应于第二控制信号而生成的。
The analog signals must be converted to voltage signals suitable for conversion to digital form.
模拟信号须转换成适合于变换到数字形式的电压信号。
Analog signal board mainly detects current signals, voltage signals and implements fault protect.
模拟接口完成电流、电压检测及保护等功能。
The output signals may be resistance signals( resistance value can be set by yourself) or voltage signals.
输出信号有电阻信号（阻值可自定）、电压信号。
A grounded source is one in which the voltage signals are referenced to a system ground, such as earth or building ground.
接地信号源的电压信号以系统地线作为参考点，比如建筑物或大地。
On an outside phone company connection, the black and white pair may be used for low-voltage signals such as phone lights.
在外部电话公司联系，黑人和白人对可用于低压信号如电话灯。
Optic detecting and amplifying circuit makes the optoelectronic signals exchange, amplify, filter and get the voltage signals.
光探测及放大电路实现信号的光电转换并放大、滤波，得到清晰的电压信号。
The electrobridge measurement circuit, which consists of PT100 temperature sensor and precise resistance, outputs slight voltage signals.
PT100温度传感器和精密电阻构成的电桥测量电路输出微弱的电压信号。
According to the comparison of voltage signals with the film pattern, the judgment for film continuity on the evaporating wall was achieved.
通过将电压信号与壁面液膜形态进行对比，总结出判断液膜连续性的判据。
A second latch circuit latches the first and second voltage signals and outputs a second output signal in response to a third control signal.
第二锁存电路锁存所述第一和第二电压信号，并且响应于第三控制信号而输出第二输出信号。
A first latch circuit latches the third and fourth voltage signals, and outputs a first output signal in response to the second control signal.
第一锁存电路锁存所述第三和第四电压信号，并且响应于该第二控制信号而输出第一输出信号。
In the power energy metering chip, there are analog to digital converters to process the voltage signals of the current censor and the voltage sensor.
在电能计量芯片中，需要模数转换器对电流和电压传感器的电压信号进行处理。
A voltage amplifier generates a third and a fourth voltage signal based on a detected voltage difference between the first and second voltage signals.
电压放大器基于所述第一和第二电压信号之间的所检测的电压差而生成第三和第四电压信号。
The circuit can output analog voltage signals with positive and negative polarity according to the phase relation of encoder signals of orthogonal output type.
它可以根据正交输出型编码器信号的相位关系，输出具有正负极性的模拟电压信号。
The power supply has some functions such as presetting voltage, stepping adjustment, displaying the output voltage signals and current signals at the same time.
该电源具有电压可预置、可步进调整、输出的电压信号以及电流信号可同时预示功效。
We proposed a new method to distinguish the lightning strikes and common short-circuit faults on the basis of the characteristic of the bus voltage signals using S-transform.
基于行波特征区分雷电冲击与短路故障有一定局限性，提出一种利用母线电压信号特征识别雷击与短路故障的新方法。
A new high speed protection criterion for high voltage transmission line based on the wavelet transform of transient voltage signals from the two ends of the line is presented.
提出了一种基于双端电压暂态信号小波变换的高压输电线路快速保护算法。
Combining with the practical research and development of the computer measure and control system, the paper introduces an automatic method to measure the "low-level and wide-range voltage signals".
结合笔者从事计算机测控系统的研发实践，介绍一种测量“低电平宽量程电压信号”的自动测量方法。
Their idea is to represent the 0s and 1s of digital signals not using voltage levels as in conventional computers, but using the presence or absence of noise.
他们的想法是不像在传统计算中那样使用电压高低来代表0和1，而是使用噪音的有无。
In this case, there are a limited number of switch CARDS that can handle both the high voltage and the high current signals.
在这种情况下，则仅仅有限的开关卡既可以处理高压信号，又可以处理大电流信号。
Shielding may be essential in a switching system if a mixture of low current, high voltage, and high frequency signals are present.
如果切换系统中会混合出现小电流、高电压和高频信号，屏蔽则非常关键。
Is the input signal transmitter output voltage and current signals.
输入信号是变送器输出的电压，电流信号。
A novel fundamental frequency and initial phase detection method based on DSP is proposed, which can be used to get synchronous fundamental frequency voltage or current signals of power system.
提出了一种基于数字信号处理器的基波相位和频率校正检测方法，可用于电力系统中电压或电流基波分量同步信号的获取。
According to features of power quality disturbance signal, this paper detects the disturbance signals of high-frequency, transient impulse and voltage notch with wavelet transforming.
针对电能质量扰动信号的特性，本文采用小波变换对电力系统的高频、瞬时脉冲、电压切痕扰动信号进行检测。
In most applications, the graph shows how signals change over time: the vertical (Y) axis represents voltage and the horizontal (x) axis represents time.
在大多数应用中，图形显示信号随时间而变化：垂直(y)轴表示电压和横向(x)轴代表时间。
The hard drive circuits translate those signals into to voltage fluctuations.
硬盘电路板把这些信号，转化为电压波动。
According to the signals of arc voltage errors and arc state, four control regulations and counting measure of control parameters are designed.
根据电弧电压偏差信号及电弧状态，设计了四个控制规则及其控制参数的计算方法。
The system can be used to analog signals of frequency, voltage, current simultaneously etc. Meanwhile it can be used to detect precision of the meters.
该系统能够同时模拟频率类、电压类、电流类等多种信号，还能同时检测电子仪表的精度。
The system can be used to analog signals of frequency, voltage, current simultaneously etc. Meanwhile it can be used to detect precision of the meters.
该系统能够同时模拟频率类、电压类、电流类等多种信号，还能同时检测电子仪表的精度。
应用推荐