Check that the voltage plate on the motor is suitable for the supply voltage available.
检查电动机上的电压板是否适合供电电压。
Electrospinning works by connecting a needle-like spinneret to a high-voltage power source and releasing a charged liquid from it towards an earthed collector plate.
电纺的工作方式是将一根针状喷丝头连上高压电源并从中对一个接地的收集器释放出一股带电液体。
Varying the voltage or the distance between the ground plate and the graphene alters the conductivity, "just like tuning a knob," Engheta said.
改变电压或是接地板与石墨层之间的距离都能改变传导率，“就像调节旋钮一样”，Engheta说。
The effect of charges remaining on a dielectric plate upon the 50% impulse surface flashover voltage U_ (50) in the non-uniform field (rod-plane gap) is investigated.
针对不均匀电场(棒-板间隙)中绝缘板上残余电荷对50%冲击闪络电压u _(50)的影响做了一些试验研究。
Verify ac line voltage phase and frequency with the controller data plate on the enclosure door prior to connecting ac power.
在连接交流电源之前，请验证交流电压、相位和频率是否与控制装置外壳门参数板上的相应数据相同。
The influence of the hydraulic retention time, the voltage between the electrodes and the plate distance to the effect was discussed.
采用电化学法处理含氮废水，探讨了水力停留时间、板间电压和极板间距对电解效果的影响。
The maximum wattage and rated voltage are shown on the heater data plate.
在热水器的规格面板上，标注着最大功率瓦数和额定电压。
This is because the plate voltage is too high, and the Max allowable current without exceeding dissipation limits is too low.
这是因为板电压过高，最高不超过允许的电流损耗限制太低。
In certain conditions, the effects of current, voltage, length and thickness of the plate on the temperature field were simulated.
在其他条件一定的情况下，分析了电流、电压、板长及板厚分别对温度场的影响。
However, the peak of field plate electronic field will increase with the drain voltage until device is breakdown.
而场板电场峰值则随着漏电压的增大不断增大，直至器件击穿。
To analyze the formation of surface discharge on a dielectric plate under positive nanosecond impulse voltage in air, a wire to plane electrode system with a barrier of negative film was used.
采用感光胶片作为阻挡介质的针-板放电系统，解析空气中固体电介质上纳秒正脉冲表面放电的形成过程。
The test result shows that the quantity of embeded flock increased with the added flocking time and additional voltage, but decreased with the added distance of plate.
实验证明在其他条件一定时，植入绒毛量随着植绒时间和外加电压的增加而增加，随极板距离的增加而减小。
The results show that the current and voltage are the strongest factors, the thickness is stronger, and the last one is the length of the plate.
结果表明：电流和电压对焊接温度场的影响最大，板材厚度其次，板材长度最小。
Be sure that applied voltage is conformed to the voltage indicating in name plate.
确认使用电压与电装铭牌上的电压相符。
The formation rate of ozone due to the point-to-plate pulsed high-voltage corona discharge was calculated with electronic collision theory.
采用电子碰撞理论计算了点面式高压脉冲电晕放电过程中的臭氧产生速率。
Through measuring three-phase current of low voltage at user side and handling by specific algorithm, TA ratio of HV measuring can be accurately judged whether is consistent with data plate.
通过测量用户低压侧三相电流相量，通过特定的算法处理，准确判定用户高计TA的实际变比是否与铭牌一致。
The polycrystalline silicon layer is formed on the oxide layer and used for serving as an upper electrode plate of the high-voltage capacitor.
多晶硅层是形成于氧化层上，用以作为高压电容的上电极板。
The two-step diffusion drain electrode structural layer is used for serving as a lower electrode plate of a high-voltage capacitor.
双重扩散漏极结构层用以作为一高压电容的下电极板。
The results show that when the battery is charged at low current and constant voltage, its failure mode is the sulphation of negative plate and the softening of positive plate;
用优选充电制度，电池失效模式是正极活性物质软化，板栅腐蚀相对较少。
Main service in high voltage grid transmission, communications tower factory, is used for connecting plate processing Angle and the ideal processing equipment.
主要服务于高压电网输变电、通讯行业的铁塔制造厂，是用于角钢及联接板加工的理想加工设备。
When semiconductor chilling plate is used in parallel connection mode, a DC power supply with a low voltage and high current has to be available.
半导体制冷片多个并联使用时，需要低压大电流的电源提供直流工作电压，为此我们设计了1。
When semiconductor chilling plate is used in parallel connection mode, a DC power supply with a low voltage and high current has to be available.
半导体制冷片多个并联使用时，需要低压大电流的电源提供直流工作电压，为此我们设计了1。
应用推荐