The paper analyzes the fundamental part circuit of current conveyor, the current mirror and the voltage follower.
本文分析了电流传送器的基本镜像电流源和电压跟随器模块电路。
The methods for increasing the sensitivity of the measurement system were studied and the voltage follower based on operational amplifier was designed.
研究进一步提高测量系统灵敏度的方法，设计高输入阻抗的电压跟随电路。
After introduction of the tranlinear loop principal, the BJT current controlled conveyor has been designed by using mixed tranlinear loop voltage follower.
在引入了跨导线性原理后，利用混合跨导线性回路完成了对电压跟随器的设计，进而得到了双极管型电流控制传送器。
The principles and circuit diagrams of the high voltage amplifier as well as the big swing voltage follower using general puropse IC operational amplifiers are presented.
介绍以通用集成运算放大器构成高压放大电路及高摆幅电压跟随器的原理和电路。
It uses tow-stage differential amplifiuers to increasee the circuit gain and uses a source follower as a voltage buffer to decrease signal volt- age losing.
该电路应用两级差动放大增加电路增益，利用源极跟随器作为电压缓冲器以减少信号电平损失。
It is composed of an amplifier stage, two stages of source follower and a feedback resistance, and use a single supply voltage.
该光接收机采用单电源供电，由一级放大器、两级源级跟随器和一个反馈电阻组成。
It is composed of an amplifier stage, two stages of source follower and a feedback resistance, and use a single supply voltage.
该光接收机采用单电源供电，由一级放大器、两级源级跟随器和一个反馈电阻组成。
应用推荐