It is suitable for both current - and voltage-mode control methods.
它同时适用于电流和电压模式控制方法。
The generalized binary signal to be applicable to voltage-mode and current-mode circuits is introduced first.
文中首先引入适用于电压型和电流型电路的广义二值信号,推导出源信号和负载简化定理。
This paper presents the principle and virtues of a current-mode-control pulse width modulation(PWM), and makes a comparison with traditional voltage-mode-control.
本文介绍了开关电源的电流型PWM控制技术的原理及特点,并和传统的电压型控制作了比较。
Power electronic applications require the amplitude control of output voltage or output current, called Voltage-Mode control and Current-Mode control respectively.
功率电子应用需要输出电压或输出电流的幅值控制,分别称为电压型控制和电流型控制。
The front stage uses the single-voltage-mode control strategy and the back stage uses the three states discrete pulse modulation hysteresis current control strategy.
前级采用电压单环调制方式,后级采用三态滞环离散脉冲调制电流滞环跟踪控制技术。
A kind of passive feedback chaotic control in the voltage-mode Buck converter is presented based on the approximation concept of time-delayed feedback control (TDFC).
基于时间延迟反馈近似思想,提出一类无源反馈控制方法,实现了电压模式Buck变换器的混沌控制。
Some new voltage-mode second-order filters based on current feedback amplifier are proposed. The major merits of these circuits are multiple filtering function and adjustable parameter.
构造了一些新的基于电流反馈放大器的电压模式双二阶滤波器,多滤波功能和参数可调是这些电路的主要优点。
Many 14-inch notebook, you may use 2 and 4 stringsof 8-cell hybrid mode, the voltage will still be 14.4V, capacity is doubled to4400mAh, to ensure a longer usage time.
而很多14寸以上笔记本,则可能采用2并4串的8芯混联方式,电压依然为14.4V,容量翻倍达到4400mAh,保证更长的使用时间。
The common and differential mode voltage produced by the PWM inverter can generate large common and differential current in the motor driving system.
由三相pwm逆变器产生的共模和差模电压可以在电机驱动中产生足够大的共模和差模电流。
The instrument is used in the charge (or coulombs) mode and its internal voltage source provides the step voltage.
使用仪器的电荷(库仑)模式,其内部电压源提供步进电压。
The control system utilizes a sliding mode observer for the generation of all controller feedback information by means of non-speed information, such as voltage, current and parameters of motor.
利用非速度信息,如:电机的电压、电流及电机本身参数,通过滑模观测器产生控制器所需的速度反馈信息。
An AC powered source usually has a significant level (often several volts) of line frequency common mode voltage.
交流供电的源通常具有很高电平的电源频率共模电压(常常有几伏)。
ZJC-50KV controlled by computer, through the man-machine dialogue mode, the voltage breakdown insulation, power frequency withstand voltage test.
50KV采用计算机控制,通过人机对话方式,完成对绝缘介质的工频电压击穿,工频耐压试验。
Using computer control, man-machine dialogue mode, the completion of the power frequency voltage breakdown of insulation media, power frequency withstand voltage test.
采用计算机控制,过人机对话方式,完成对、绝缘介质的工频电压击穿,工频耐压试验。
The two parts both adopt double loop PWM control mode which consists of outer voltage loop and inner current loop.
该系统包含升压和逆变两个环节,均采用电压外环、电流内环的双环pwm控制方式。
It is found that the hexagon pattern is transformed from diffuse mode by increasing the applied voltage.
实验发现,随电压的升高,六边形斑图是由弥散放电模式演化而成。
The conditions of voltage between contactors and current in main circuit under different using types are analyzed in detail, then designed the control sequences with working mode AC1-AC4.
详细分析了交流接触器在不同使用条件下的闭合与分断时触点两端电压与回路电流情况,并研究了AC1~AC4工作制下的控制时序。
Another kind of the voltage control mode, through the high and low voltage on motor speed control, motor feedback signal through the drive to the numerical control system feedback position control.
另一种采用电压控制方式,通过电压的高低进行电机的转速控制,电机的反馈信号通过驱动器反馈到数控系统进行位置控制。
It has four start mode: the ramp voltage start, the limit current start, the ramp speed start and the discrete frequency start.
所研究的软起动器具备四种起动方式:电压斜坡起动、限流起动、转速斜坡起动和分级变频起动。
Current Summing is the basic method to realize low-voltage reference which is different from that of conventional voltage mode.
不同于常规电压求和带隙基准,电流求和是实现低压基准的主要方法。
Analyzed failing cause of mode-frequency to load voltage drop for generating set, provided regulated method of cable voltage-drop compensation device.
分析了发电机组中频加载掉电压故障发生的原因,提出了电缆压降补偿装置调整方法。
Any common-mode current (ICM) that may be present flows from the voltmeter input lo to instrument chassis common, through earth ground to voltage source ground.
可能出现的共模电流(ICM)从电压表的输入低端流到仪器的机箱公共端,经过大地再流到电压源的地。
Recording AP in current clamp mode and recording current in voltage clamp mode.
AP记录采用电流箝方式,电流记录采用电压箝方式。
When in the external feedback mode, the electrometer will display the voltage across the feedback element. The unknown charge can be calculated from the following formula.
在外部反馈模式下,静电计显示反馈元件上的电压。未知电荷可以由下式计算。
MPS700 series dc voltage constant-current power supply, is designed by using linear series MOSFET control mode of the ac input dc output power.
MPS700系列直流稳压稳流电源,是采用MOSFE T线性串联调整方式设计的交流输入直流输出电源。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
再者,所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
In either case, that voltage is unwanted, and it is the job of the measurement SYSTEM to REJECT it, while responding to the differential-mode voltage.
另外的原因是该电压没有用,是测量系统工作时所抑制的,而只响应差模电压。
This simple structure is proved through the SPICE simulation to have the very high common mode input voltage excursion and low harmonious distortion.
电路模拟证明这种简单结构具有很高的共模电压输入范围和很低的谐波失真。
Based on the derived model, the factors affecting TCSC transient characteristics are discussed. Also the transient mechanism of TCSC is revealed under capacitor voltage synchronization mode.
借助该模型可分析影响暂态过程的相关因素,进而从本质上揭示了电容电压同步下TCSC的暂态机理。
Based on the derived model, the factors affecting TCSC transient characteristics are discussed. Also the transient mechanism of TCSC is revealed under capacitor voltage synchronization mode.
借助该模型可分析影响暂态过程的相关因素,进而从本质上揭示了电容电压同步下TCSC的暂态机理。
应用推荐