To microbes, fluids appear thick and still, and viscosity is the main force small organisms must reckon with.
对微生物来说，液体看起来粘稠而静止不动，粘稠性是小型有机体要考虑的主要因素。
There are three sections of damping force, and they are background damping force of a fluid viscosity, electric damping force of applied electric field and pressure of gas.
压缩和复原阻尼力主要由三部分构成，即电流变液基础粘度引起的本底阻尼力，电场强度函数的电致阻尼力和气室气体引起的压力。
A simplified mechanical model of sticky soil with certain viscosity was proposed for simulating the force between the soil and corrugated bulldozing plates.
针对粘性土壤提出了一个简化力学模型，数值模拟了具有一定粘性的土壤与波纹型推土板之间的作用力。
The viscosity of LDPE melt decreases in vibration force field and has a minimum value with vibration frequency change.
在振动力场作用下ldpe熔体的粘度减小，随振动频率的变化有一最小值。
The prepared ink has good solution viscosity, surface force, solvent resistance and adhesive capacity.
墨水溶液粘度、表面张力及耐溶剂性能、粘附性能均较佳。
In this paper, the viscosity, adhesion force and film properties of the acetate starches size are tested, and the test results are analysed.
本文对醋酸酯淀粉浆液的粘度、粘着力及浆膜性能进行了测试，并对测试结果进行了分析。
The viscosity and surface tension was improved by gel structure of bentonite colloid, so the capillary force is increased and therefore the wet compression strength is improved.
凝胶结构提高了粘结液相的粘度和表面张力，毛细力增大，生球抗压强度提高。
It has obvious actions of leakproof and lost circulation in low pressure absorbent formation because of containing a lot of foam with high shear force and high structural viscosity.
由于含有大量高切力、高结构粘度的泡沫，在低压渗漏地层有显著的防漏堵漏作用。
Hot water, steam, or gas is injected into the producing formation to lower the viscosity of the oil and force it through the reservoir toward producing Wells.
向产层注入热水、热蒸汽或热气体，以降低油的粘度，并将油经储层压向生产井。
The influences of strain rate, liquid volume fraction and liquid viscosity on the deformation force of semi solid compression of metals between two parallel plates were investigated according to…
结果表明 ，液体粘度对变形力几乎没有影响 ，变形力随轴向应变速率绝对值的增加而增加 ，随液体体积分数的增加而明显减少。
The phenomenon of increasing shear force, and decreasing apparent viscosity, showed that it was a kind of Pseudo plastic Fluid. As the temperature increased, the apparent viscosity decreased.
表观粘度测定显示辛烯基琥珀酸淀粉酯具有剪切变稀现象，属于假塑性流体，表观黏度随着温度升高而下降。
The results showed that the stability, viscosity and adhesive force of synthesized size were preferred when initiator dosage was 0.6%.
结果表明，当引发剂用量在0.6%时，合成的浆料稳定性好，粘度适中，粘附性好。
The results showed that the stability, viscosity and adhesive force of synthesized size were preferred when initiator dosage was 0.6%.
结果表明，当引发剂用量在0.6%时，合成的浆料稳定性好，粘度适中，粘附性好。
应用推荐