The screen shot of the second virtual Ethernet adapter for the VIO Servers should look the same.
VIO服务器的第二个虚拟以太网适配器的屏幕截图看上去完全相同。
The second virtual Ethernet adapter on each of the VIO Servers must be configured as a non-trunk adapter.
必须将每个VIO服务器上的第二个虚拟以太网适配器配置为非干线适配器。
You should also set up a third virtual Ethernet adapter on each VIO Server using the virtual LAN ID of the trunk adapter.
您还应该在每个VIO服务器上设置第三个虚拟以太网适配器，使用干线适配器的VirtualLANID。
From this menu you can see the virtual Ethernet adapter we created previously with the 383 primary VLAN and the 373 additional VLAN.
在这个菜单上，可以看到前面创建的虚拟以太网适配器（主VLAN 为 383，辅 VLAN 为 373）。
That requires that at least one partition have both a physical Ethernet adapter, as well as a virtual Ethernet adapter that is connected to the other partitions.
但这需要至少有一个分区既拥有物理以太网适配器，又拥有连接到其他分区的虚拟以太网适配器。
On the AIX partition, an interface (not shown in the figure above) en0 can be created on top of the Virtual Ethernet adapter ent0 and a valid IP address can be assigned to it.
在AIX分区上，可以在虚拟以太网适配器ent0 上创建接口en0（上图中没有显示），可以给它分配一个有效的IP地址。
On the AIX partition, an interface (not shown in the figure above) en0 can be created on top of the Virtual Ethernet adapter ent0 and a valid IP address can be assigned to it.
在AIX分区上，可以在虚拟以太网适配器ent0 上创建接口en0（上图中没有显示），可以给它分配一个有效的IP地址。
应用推荐