An optical fiber probe is used to study the cross-section of oil-gas-water three-phase slug flow in vertical tubes.
利用光纤探针试验研究垂直上升管内气、水、油三相弹状流截面相份额的规律。
The purpose of this paper is to illustrate the result of the research on the slug flow in vertical tubes and to effectively guide experimental investigation and production practices in future.
目的在于全面翔实地阐述垂直管弹状流的研究结果，以期有效地指导实验研究及生产实际工作。
It is indicated that the enhanced condensation heat transfer technology on vertical tubes, when applied to vertical utility heaters, can efficiently raise the feed water temperature and save energy.
最后指出，立管冷凝强化传热技术在电站的立式加热器中应用，可以较大幅度地提高给水温度，实现节能增效。
Liquid crystal technique was used to measure the glycerin temperature distributions in an agitated tank heated by vertical tubes.
利用液晶测温技术测量了垂直列管加热的搅拌槽内甘油的温度场分布。
In this paper, the conditions of bubble flow region existence are studied for upward gas-liquid two-phase flow in the vertical tubes.
文章对垂直上升管内气液两相泡状流的存在条件进行了研究。
An experimental study on the flow patterns of gas-water flow was carried out in vertical tubes under rolling and steady state respectively.
本文分别在摇摆和非摇摆状态下，对竖直管内气-水两相流流型进行了实验研究。
The additional frictional pressure drop for vertical tubes due to its connection with the bend was accounted into the frictional component due to return flow.
回弯压力降除考虑回弯头的局部阻力外，还包括相连直管段受回弯影响而增加的压力降。
Based on Experimental investigations, the DNB characteristics of steam-water mixtures in one-side heated vertical tubes under subcritical pressure are discussed.
在试验研究的基础上，讨论了亚临界压力单面受热垂直管内汽水混合物传热恶化的特点。
This thesis mainly studied the flow patterns in adiabatic water-air two-phase flow under non-rolling condition through experiment, which were conducted in horizontal, inclined and vertical tubes.
本文主要通过实验对水平管、倾斜管和垂直管内不摇摆绝热流动条件下的两相流流型进行了研究。
Vertical tubes transfer the entire mass of the structure to the ground where they rest on square base plates to spread the load.
竖向支架将整个构架的重量传到地面，构架下面的方形基底起到平均分散重量的作用。
Vertical tubes transfer the entire mass of the structure to the ground where they rest on square base plates to spread the load.
竖向支架将整个构架的重量传到地面，构架下面的方形基底起到平均分散重量的作用。
应用推荐