I can't unscrew the lid of this jar.
这个瓶盖儿我拧不开。
You'll have to unscrew the handles to paint the door.
要漆这扇门，你得把螺丝拧开，缷下门把手。
旋开锁住盘片的螺母。
Ican't unscrew the top of this bottle.
这个瓶盖我拧不开。
I can't unscrew the top of this bottle.
我拧不下这瓶的盖子。
Unscrew the diaphragm from the compressor.
从压缩装置上拧松隔膜。
Unscrew the bonnet by turning counterclockwise.
反时针方向旋转拧松阀盖。
Unscrew the jar and cover with lid fitted over it.
旋开罐盖，用合适的盖子覆盖。
Disconnect the cable from the spark plug and unscrew the spark plug.
断开连于火花塞的缆线并旋下火花塞。
Simply unscrew the battery caps or remove the covers to check the level.
只需要拆开或者直接取下蓄电池盖，就可以检查电解液的液面高度。
Unscrew the screw (3) with Allen key, and take out the external skive tool.
用随机附送的内六角扳手松开螺丝(3)，拿出外剥刀具。
Simply unscrew the old electrode, replace it with a new one, and calibrate!
只需拧下旧的电极，更换一个新的它，校准！
Unscrew the valve cap and set it to the side or in a pocket where you won't lose it.
拧下阀盖，并设置它的侧面或装在口袋里，你不会失去它。
You simply unscrew the top of the clear phone, pour cola in and watch the chemical process start.
用户只须拧开手机透明外壳的顶端，把可乐倒进去，就可看到化学反应。
Unscrew the aerator from the faucet, turn the water on at the shutoff valves, and open the faucet.
松开水龙头的透气口，打开总阀送水，打开水龙头。
To replace the relief valve disc, hold the upper guide fin and unscrew the diaphragm pressure plate.
要更换安全阀阀瓣，握住上部引导翼，旋下隔膜压力板上的螺丝。
You may have to unscrew the gear (3 screws) to access the right hand latch, but I am not sure of that.
也许你需要松开齿轮(3颗螺丝)来卸下右手边的卡子，不过我不是很确定。
The only thing I had to do for Jan Turner that entire evening was unscrew the top on the ketchup bottle.
那天整个晚上，唯一我不得不帮助简•特纳所做的一件事情就是为她拧开番茄酱的瓶盖。
Unscrew the nut from the service connection of suction line valve and connect the compound pressure gauge.
将真空泵连于复合压力表，打开复合压力表和真空泵对室内机和连接管抽真空。
Now unscrew the two screws on the front right under the flash. These two are slightly longer and identical.
现在取下油前方内闪下的两个螺丝。这两个一样的螺丝比稍长。
Using an appropriate sized wrench, loosen the check valve cover. Unscrew the check valve cover and lift off.
采用大小适中的扳手，松开止回阀盖。旋下止回阀盖螺丝并拿起。
Using an appropriate sized wrench, loosen the check valve cover. Unscrew the check valve cover and lift it off.
采用尺寸大小适中的扳手松开止回阀阀盖。宁松止回阀阀盖并将其取出来。
Unscrew the Allen screw in the middle of valve cap and lift up the cap just enough to pick up the old diaphragm.
旋松阀帽中间的内六角螺丝，并且提起阀帽，正好足够拿走旧阀膜。
Unscrew the locking handle found on the side of the phase shift 'Siko'unit; this enables the adjusting handle to be turned.
旋开移相器上“西科”牌（？）装置一端的止动柄，即可转动止动柄而调整移相器。
Using a Chemtrol spanner wrench1, unscrew the seat-carrier (Tru-Bloc Model-C) by rotating in the counterclockwise direction.
使用一把Chemtrol活动扳手1，通过逆时针方向旋转拧松阀座支架（Tru-Bloc型号C）的螺纹。
To reverse the seat disc, unscrew the disc screw and disassemble the disc washer and disc rubber from the disc holder assembly.
为了翻转阀座阀瓣，则要拧松阀瓣螺丝，从阀瓣固定器总成拆解阀瓣垫圈和阀瓣橡胶。
To reverse the seat disc, unscrew the disc screw and disassemble the disc washer and disc rubber from the disc holder assembly.
为了翻转阀座阀瓣，则要拧松阀瓣螺丝，从阀瓣固定器总成拆解阀瓣垫圈和阀瓣橡胶。
应用推荐