• Repeat this action for each repeat occurrence, which produces separate elements in the output card of the WebSphere TX map, which can be individually assigned separate values.

    对于每个重复事件重复操作这会WebSphereTX映射输出中生成单独元素可以这些元素分配单独的值。

    youdao

  • This section shows you to create a WebSphere TX type tree and maps so the WebSphere TX Design Studio can transform CSV input data into XML output data.

    节将展示如何创建WebSphereTX类型映射使WebSphere TXDesignStudio可以CSV输入数据转换成XML输出数据?

    youdao

  • You will configure a flow that takes CSV format messages from the MQ input queue and uses a WebSphere TX map to transform the message into XML and put on the MQ output queue.

    配置一个MQ输入队列取出 CSV格式消息WebSphereTX映射消息转换为XML然后放在 MQ 输出队列中。

    youdao

  • It also assumes that you have a basic understanding of WebSphere TX and that you know how to create a simple WebSphere TX map with one input and one output card.

    本文假定拥有WebSphereTX基础知识了解如何使用“输入、一个输出(one inputand one out put card)”创建简单的WebSphere TX数据

    youdao

  • Uplink power control shall be performed while the total UE transmit power is below the maximum allowed output TX power.

    UE传输功率小于所允许最大输出功率的时候上行功率控制可以执行

    youdao

  • At the end of TX tune mode, carrier output returns to normal mode level after a short delay.

    调谐完成状态载波输出返回操作模式电平有所延时

    youdao

  • At the end of TX tune mode, carrier output returns to normal mode level after a short delay.

    调谐完成状态载波输出返回操作模式电平有所延时

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定