Propping transverse loading pushing approach was applied in the deviation rectification course.
在纠倾过程中采用了顶升纠倾横向加载推进法。
The distance between the bearing points and the distribution of the transverse loading are arbitrary.
简支点的间距及横向载荷的分布可以是任意的。
A boundary element method for the analysis of interfacial slip in fiber-reinforced composites under transverse loading is presented.
用边界元方法对横向载荷作用下纤维增强复合材料界面的滑移进行分析。
When the transverse loading speed becomes bigger, the axial elasticity modulus also becomes bigger, while the platform yeild strain becomes smaller, buy the yield stress changes little.
横轴方向的位移荷载速度越大，纵轴方向的弹性模量越大，平台极限应变越小，而屈服应力和平均平台应力相差不大。
The stress-strain curve under transverse loading of MMCs has a corner point, associated with the initiation of interfacial de-bonding, which is determined by the interfacial bonding strength.
在常响应界面情况下，复合材料横向拉伸应力-应变曲线存在明显的转折点，对应于界面分离的起始点，转折点的位置取决于界面粘结强度。
In the analysis of the stress and deformation under dynamic loading, the inertia force and damping moment should be considered in addition to the transverse shear effect.
在分析动载荷下的应力和变形时，除考虑横向剪切效应外，还须考虑微段的惯性力和阻尼力矩。
The calculated strength could show the affection caused by transverse shear effect and the affection had only relation to the loading value and no to the ratio of span-height.
预测的强度能够反映出横向剪切效应的影响，其影响只与载荷大小有关，而与跨高比无关；
The results of the tests reveal that the effect of the vertical bending transverse to the bridge under the action of vertical loading is greater than that longitudinal to the bridge.
试验结果表明：结构在竖向荷载作用下横桥向竖向弯曲效应大于纵桥向竖向弯曲效应；
Byintroducing the principles of initiating a lane loading in long span Bridges with comments, the appropriate lane loading as well as multi-lane transverse reduction factors are suggested.
还评述了大跨径桥梁的车道荷载拟定原则，探讨了大跨径桥梁的车道荷载和多车道横向折减。
When the dam is loaded by hydraulic jacks and dam deformations occur, the sensing bar works like an elastic beam under arbitrary transverse and axial loading.
当大坝受到油压千斤顶荷载产生变形时，该传感器类似于一根一端固定并同时受轴向拉、压和横向弯曲的弹性梁。
The dynamic characteristics of elastic plates subjected to transverse impact and non-linearly elastic & elasto-plastic cylindrical shells under axial impact loading are investigated theoretically.
然后采用增量数值解法分析了轴向冲击载荷作用下非线性弹性圆柱壳的轴对称动力响应问题。
Two-dimensional distribution of loading was proposed, including transverse distribution and longitudinal distribution, and reliability models were derived under the two distributions respectively.
提出载荷的二维分布：横向分布和纵向分布，并分别建立了基于载荷两种分布的可靠度计算模型。
The loading ability is moderate according to the potential indices evaluative criteria for longitudinal oil drain system and transverse direction oil drain system.
按照纵向排油系统和横向排油系统的潜力指数评价标准，烃源岩的充载能力中等。
The metallic foam is represented by an array of discrete lump masses linked by elastoplastic springs in loading direction and constrained by hinged extensible rods transverse to the loading direction.
泡沫金属材料由数排质量块描述，质量块在受载方向由非线性弹簧连接，垂直于受载方向弹性杆连接。
The metallic foam is represented by an array of discrete lump masses linked by elastoplastic springs in loading direction and constrained by hinged extensible rods transverse to the loading direction.
泡沫金属材料由数排质量块描述，质量块在受载方向由非线性弹簧连接，垂直于受载方向弹性杆连接。
应用推荐