Another important work of this dissertation is the design of an RF low-noise amplifier integrated within a Bluetooth transceiver chip.
本文另一个工作重点是设计集成于蓝牙收发器信机芯片中的射频低噪声放大器。
And finished the design of data transceiver.
并完成了电力线数据收发器的设计。
In this paper, the authors introduced VCSELs and the optical transceiver modules, and discussed the framework design of GBIC module and its key technique.
本文在简单介绍光收发模块和VCSEL器件的基础上，着重讨论了GBIC模块的总体设计和主要技术关键。
In this dissertation, I make a systemic research on time domain equalization algorithm which is the key technology of DSL, and design ADSL transceiver system on a chip.
本论文对DSL技术中的关键技术时域均衡算法进行了系统的研究，并进行了ADSL收发器片上系统设计。
The design of a W-Band airborne collision avoidance radar transceiver developed recently is introduced.
介绍最近研制成功的W频段机载防撞雷达收发分机的设计。
Then detailed representations for CAN-BUS principle, CAN controller, CAN high-speed transceiver, and design project for CAN-BUS interface were given.
接下来对本系统所用到的CAN总线的原理、CAN控制器和CAN高速收发器进行了详细的介绍，并给出了CAN总线接口的设计方案。
The article is mainly on study of the theory and design of millimeter-wave transceiver front-end from the active devices and passive components.
毫米波器件又分为无源器件和有源器件，本文从这两个方面对毫米波收发前端的理论和设计进行了研究。
This paper in-depth research and analyzes the reliability issues in this transceiver modules mainly from the design of reliability, test of reliability, modeling and distribution of reliability.
本文主要从可靠性设计、可靠性试验、可靠性建模与分配这三个方面研究了毫米波收发组件中的可靠性问题。
The design methods of the transceiver system about integration and modularization, low power consumption, miniaturization, and LPI are presented in this paper.
收发系统作为便携式战场侦察雷达的重要组成部分，其功耗、体积、重量、低截获和改善因子等均为工程设计的重点。
TDSCDMA paper-based system with the base station transceiver on the design of broadband digital transceiver RF front-end design principle and design methods.
本文借助基于TDSCDMA系统的基站收发机的设计阐述宽带数字收发机射频前端的设计原理和设计方法。
The design methods of main controller circuit, serial port expanding circuit, RS-485 integrated transceiver, etc., are introduced as well as their chips.
分别介绍了主控制器电路、串口扩展电路、RS- 485集成收发器等的设计方法，以及电路芯片的选取。
The paper is mainly on in-depth study of the theory and design of millimeter-wave transceiver modules from the active circuits and passive circuits.
毫米波电路可以分为有源电路和无源电路两种，本文正是从有源电路和无源电路这两个方面对毫米波收发组件的理论和设计进行了研究。
This article describes the structural design of certain X band radar transceiver through modularization.
通过介绍某雷达X波段发射机的结构设计特色，引入了雷达通用化收发系统的概念；
This paper is mainly about design and implementation of digital intermediate frequency (IF) transceiver combined with the software defined radios (SDR) technology based on FPGA.
本课题将以FPGA为硬件载体，结合软件无线电技术设计实现数字中频扩频收发系统。
Using the PC, AT89C51 single chip, SJA100CAN controller, 82c250 CAN transceiver and MAX232, the design of the hardware circuit and software of the system is realized.
给出了利用PC机、AT 89 C 51单片机、SJA100CAN控制器、82c 250 CAN收发器、MAX232等实现数据采集与控制系统的硬件电路设计及软件设计。
High speed optical transceiver module decides the quality of optical repeater station, a novel design method was proposed for 3g mobile communication, and has receive the result of design.
因此文章提出了一种面向第三代通信标准的高速光收发模块的新设计思路，并得到了初步设计结果。
The mission of this project is to design a low-cost wireless transceiver be used voice communication base on the general chip, and finally complete the automatic test for this.
本论文的主要任务就是以通用的调频通信集成电路芯片为平台设计出一个用于语音通信的低成本无线收发模块，最后还要完成电路参数指标的自动测试。
We present a novel concurrent transmission MAC protocol for MANETs which enjoys the simple design of single-channel, single-transceiver and single-transmission power architecture.
本文提出一种工作在单信道、单发射器和单发射功率模式下的并发传输MAC协议。
A wireless digital semi-duplex low power voice transceiver for short-distance communication is introduced in terms of the design of its hardware and software.
介绍了一种针对短距离通信的、半双工、低功耗无线话音通信器的实现方案。从硬件电路和软件设计进行了阐述。
The basic theory and standard modes of the transceiver are described. The design method and hardware electric circuit are given in the article.
对其基本原理和标准规范进行了说明，给出了设计思路和硬件电路。
The paper focuses on the design and implementation of FPGA based ASK if transceiver and detailed design and functional verification are described.
文章将重点放在了ASK中频信号发生器和接收机的FPGA设计及实现，给出了详细的设计方案和功能测试结果。
The paper introduced the technology of fiber-optic repeater which use the optical transceiver, and discussed the theroy of circuirt design of the module.
本文首先介绍了直放站的相关原理与技术，作为对直放站光模块应用的介绍；
The two levels of the design is connected by CAN Bus through the transceiver (TJA1050).
两级系统通过收发器同CAN总线连接并实现数据的互换。
The two levels of the design is connected by CAN Bus through the transceiver (TJA1050).
两级系统通过收发器同CAN总线连接并实现数据的互换。
应用推荐