The 4-cylinder is a 16-valve DOHC design with Toyota’s VVT-i variable cam timing system, and is rated at 179 horsepower at 6000 rpm and 172 lb-ft of torque at 4000 rpm.
4缸机为16气门DOHC（双凸轮抽）设计，配备丰田VVT-i（智能正时可变气门控制系统），最大功率179hp/6000rpm(131kw/6000rpm),最大扭矩172lb-ft/4000rpm(233Nm/4000rpm).
The valve effectively seals at higher pressures with less closing torque than the wrench-operated design.
同扳手型设计相比，这种阀门可以在更高的压力下使用更小的转矩有效地密封。
Make sure that any outlet seal is properly tightened to the same torque requirement as the CGA connection for the particular valve outlet.
对于特定的阀门排气口，确保所有排气口密封都按与CGA接头同样的转矩要求正确上紧。
Table, the minimum time to close the valve spring torque is the torque, maximum torque is to open the valve spring torque.
表中，最小弹簧扭矩即为关闭阀门时的扭矩，最大弹簧扭矩即为打开阀门时的扭矩。
Output torque of the actuator must meet or exceed the operating torque requirements of the specific valve to be actuated.
执行机构的输出扭矩必须满足或超过所应用阀门所需的操作扭矩要求。
AW pneumatic actuator used, make sure the valve opens, closing torque, and then do the valve using a fluid medium, added security value.
选用AW气动执行器时，先确定阀门启、闭的扭矩，再根本阀门使用的流体介质，增加安全值。
This is because the torque caused by the closure of the valve.
这是考虑到阀门的关闭力矩所致。
V-valve dual-bearing structure, mechanical stability, high starting torque is small, to ensure the valve sensor with excellent sensitivity and speed.
型阀采用双轴承结构，机械稳定性高，启动扭矩小，保证了阀门具有极好的灵敏度和感应速度。
The three major forces involved in valve actuation are thrust, torque and rimpull.
决定阀门操作的力主要有三种：推力，扭矩和边缘拉力。
The specifications for seat sealing test, body sealing test, body strength test, valve long term test, fatigue strength test and operation torque of plastic valves were summarized.
汇总了塑料阀门产品所需性能要求的阀座密封试验、阀体密封试验、阀体强度试验、阀门长期试验、疲劳强度试验和操作扭矩的规定。
When designing valve systems, hydrodynamic torque must be considered to help assure correct selection for the application.
在设计阀门系统时，必须考虑水动力扭矩，这样有助于正确选择所需阀门产品。
The regulations and methods for valve base seal test, valve seal test, valve strength test, long term valve test, fatigue test and operating torque test were summed up in this article.
汇总了塑料阀门产品要求的阀座密封试验、阀体密封试验、阀体强度试验、阀门长期试验、疲劳强度试验和操作扭矩的规定和方法。
The open torque is little and the valve can self compensate after wearing because of big chocking force. The seal performance is good and stable.
开启力矩小，楔紧力大。磨损后，能自行补偿，密封性好，性能稳定。
The handle turning torque should become snug, but not excessive when the valve is properly adjusted for leak-free operation.
手柄的旋转扭矩应该变得舒适，而且当对阀门进行适当地调整使其实现无泄漏操作时感觉不会过紧。
So instead of using Nd-Fe-B Alnico motor to reduce the size of the torque, but also on reducing the size of the servo valve, a reduction of quality, cost savings.
这样用钕铁硼代替铝镍钴就缩小了力矩马达的体积，也就可以缩小了伺服阀的体积，减少质量，节约了成本。
Torque is the rotary effort required to operate a valve.
扭矩是操作阀门所需的旋转作用力。
Cone air lock valve can realize to discharge dust with the help of torque balance.
锥形锁风阀利用力矩平衡的方法实现卸灰。
Furthermore, the adjustment, opening and closing of valve are controlled by the driving torque and actual loading torque.
阀门的启闭或调节动作受控于所施加的驱动转矩与实际负载转矩。
Engine using variable valve timing technology can improve the intake charge, so that coefficient of charge increase, engine torque and power can be further improved.
发动机采用可变气门正时技术可以提高进气充量，使充量系数增加，发动机的扭矩和功率可以得到进一步的提高。
Baumann 25000 butterfly control valve is a low torque and low noise butterfly valve.
鲍曼25000蝶阀控制阀是一种低扭矩，低噪音蝶阀。
Headstock and headstock is the moment to open or close the valve must be imposed by force or torque.
启闭力和启闭力矩是指阀门开启或关闭所必须施加的作用力或力矩。
Operation process as the medium pressure is help to open valve, so reduce operating torque.
操作过程由于介质压力是有助于阀门开启的，所以减小了操作力矩。
Utilizing GMM to design new-type actuator, replacing traditional actuator such as the torque motor or the force motor, will enhance the response speed and precision of electro-hydraulic servo valve.
利用GMM设计新型的电—机转换器，取代传统型电—机转换器，如力矩马达或力马达等，可提高整个电液伺服阀的响应速度和控制精度。
For larger valves, heavy duty VS series scotch yoke type actuators provide nonlinear torque characteristic with the highest possible mechanical advantage for seating and unseating the valve.
对于大型阀门，重型VS系列挡车轭类型的涡轮执行机构能够提供非线性特性的扭矩，具有最好的机械性能，适用于阀座和无阀座阀门。
Butterfly valves, sizes 8 "and larger, when used on liquids, show a marked increase in dynamic torque which tends to close the valve."
对于公称通径大于8英寸的蝶阀，如果是在液体中使用，则在关闭阀门时，动态扭矩有比较明显的增加。
The control valve has the characteristic of large torque, work reliability and short respond period of time.
这种控制阀具有转矩大、工作可靠、响应时间短等特点。
Because of this torque balance, ensure the valve opening and the corresponding relationship between the input signal accurately to achieve the correct positioning of the spool.
水力控制阀由于这种力矩平衡，保证了调节阀开度与输人信号之间对应关系准确，实现了阀芯正确定位。
Compak actuators are matched to each valve, s torque requirements to ensure that the most economical valve and actuator package is specified.
康派克气动装置需要与每个阀门的扭矩匹配，从而确保阀门使用的最大经济性，气动头配件是指定的。
Compak actuators are matched to each valve, s torque requirements to ensure that the most economical valve and actuator package is specified.
康派克气动装置需要与每个阀门的扭矩匹配，从而确保阀门使用的最大经济性，气动头配件是指定的。
应用推荐