Recommended Bolt torque requirement are shown below.
建议的所需螺栓力矩如下表所示。
The total torque requirement is calculated by a nonlinear auto-regression with exogenous input (NARX) dynamic neural network model.
基于非线性自回归（NARX）动态神经网络模型结构建立了总体转矩需求计算模型。
Make sure that any outlet seal is properly tightened to the same torque requirement as the CGA connection for the particular valve outlet.
对于特定的阀门排气口，确保所有排气口密封都按与CGA接头同样的转矩要求正确上紧。
The torque curve of the engine is quite steep and very sensitive to the rotating speed, which are conformable to the requirement by scooters.
发动机的扭矩曲线比较陡，对转速比较敏感，这和坐式摩托车的要求相适应。
The paper checks if the output torque of the single motor can meet the requirement of recoiling tension in this working condition.
本文针对这种情况校核单台电机的输出力矩是否能够满足卷取张力的要求。
Numerical examples show that the model meets the requirement of zero torque and rigidity for vertical roll.
算例表明，该模型满足立辗转矩为零和刚性化的要求。
In order to satisfy the operation requirement of the rated thrust of the propeller, the propulsion motor performs only in rated torque on the low speed, so the motor power is low.
认为以满足螺旋桨额定推力为目的，推进电动机只需要低速输出额定转矩来实现，即输出功率较低。
Reducer type, torque and transmission are differentiated by degression, more fit for client's requirement, avoid power.
罄减速机型号扭矩和传动都采用递减形式划分，更符合客户的要求，避免了功率浪费。
The system uses electro-hydraulic moment servo control system to simulate wave torque and PID algorithm to control. The result of simulation is up to the requirement.
本系统用电液力矩伺服控制系统来模拟海浪力矩，采用PID算法进行控制，其仿真结果符合要求。
According to the requirement analysis of QR-HEV, a light torque-composing parallel hybrid powertrain configuration is finally adopted.
根据QR -HEV的需求分析，确定采用轻度混合的扭矩合成型并联混合动力结构。
No monitoring and control requirement on screwing torque.
没有要求对对螺丝扭力进行监测及控制。
Servo motor controls capping torque, pre-set torque from touch-screen. When capping reaches set torque, capping head stops, suitable for tighter capping requirement.
旋盖的扭力由伺服电机控制，在触摸屏上设定扭矩。当旋盖达到设定的扭矩时，旋盖头即停止旋转，适合对旋紧度要求高的产品。
Compared with 380db clutch, 395db clutch has advantages of higher reserve ratio and torque capacity, and thereby can meet the requirement of heavy duty trucks better.
与380db相比，395db离合器具有后备系数大、传递扭矩大等优点，更能满足重型车的需要。
The paper discusses the characteristic and design method of low speed and high torque PMSM considering driving requirement of the oil extraction system.
本文结合低速大转矩的传动特点，对低速大转矩永磁同步电动机的设计特点和方法进行研究。
The paper discusses the characteristic and design method of low speed and high torque PMSM considering driving requirement of the oil extraction system.
本文结合低速大转矩的传动特点，对低速大转矩永磁同步电动机的设计特点和方法进行研究。
应用推荐